| 高压齿轮泵体挤压铸造技术研究 |
| |
| 引用本文： | 刘娉婷,罗继相,胡健民.高压齿轮泵体挤压铸造技术研究[J].特种铸造及有色合金,2007,27(2):118-120. |
| |
| 作者姓名： | 刘娉婷 罗继相 胡健民 |
| |
| 作者单位： | 1. 武汉理工大学物流工程学院,武汉,430063
2. 江苏南通有色合金铸造厂 |
| |
| 基金项目： | 交通部港口机械行业重点试验室资助项目 |
| |
| 摘 要： | 针对高压齿轮泵前后泵体结构、性能要求等特点,研究了挤压铸造生产前后泵体的工艺过程,给出了最佳的模具结构参数和工艺参数。研究结果表明,采用直接挤压铸造工艺生产齿轮泵体技术上是可行的,泵体在25MPa下无渗漏,爆破压力大于60MPa,节省材料消耗15%以上。
|
| 关 键 词： | 齿轮泵 挤压铸造 模具结构 |
| 文章编号： | 1001-2249（2007）02-0118-03 |
| 修稿时间： | 2006-12-08 |
Production of High Pressure Gear Pump by Squeezing Casting |
| |
| Liu Pingting,Luo Jixiang,Hu Jianmin.Production of High Pressure Gear Pump by Squeezing Casting[J].Special Casting & Nonferrous Alloys,2007,27(2):118-120. |
| |
| Authors: | Liu Pingting Luo Jixiang Hu Jianmin |
| |
| Abstract: | Aiming at the characteristics of structure and performance of pump body in high pressure gear pump, squeezing casting was employed to manufacture the pump body, and the optimized die structure parameters and processing parameters were provided. It was feasible for manufacturing gear pump by direct squeezing casting. The leakage of the manufacrured gear pump can not be found at the pressure of 25 MPa, and the blast pressure is more than 60 MPa, saving more than 15% materials. |
| |
| Keywords: | Gear Pump Squeezing Casting Die Structure |
| 本文献已被 CNKI 维普 万方数据 等数据库收录！ |
|
