首页 | 官方网站   微博 | 高级检索  
     

超声电机LLCC谐振电路研究
引用本文:俞浦,李华峰,黄卫清.超声电机LLCC谐振电路研究[J].中国电机工程学报,2011,31(24).
作者姓名:俞浦  李华峰  黄卫清
作者单位:南京航空航天大学机械结构力学与控制国家重点实验室,江苏省南京市,210016
基金项目:国家自然科学基金项目(50875123,50735002); 国家重点基础研究发展计划项目(973计划)(2011CB707602); 江苏省自然科学基金(Bk2009373)~~
摘    要:超声电机需要幅值较高的驱动电压,因此其驱动电路需要变压器升压。超声电机为非线性容性负载,需要进行阻抗匹配,并保持电压和相移恒定。采用推挽电路作为驱动器拓扑,分析了该驱动电路在不同性质负载情况下工作过程,结果表明驱动器在感性负载时的开关管损耗较容性负载时小,感性负载可提高驱动器效率和可靠性。给出LLCC谐振网络及其参数计算方法,通过理论分析和仿真证明了电机谐振电压和相移与驱动条件可解耦,且该LLCC谐振网络可使驱动电路的负载性质由容性转变为感性。用TRUM-60型超声电机进行实验,结果证明了该方法的有效性。

关 键 词:超声电机  驱动  推挽  LLCC  谐振

Study on Driving Circuit of Ultrasonic Motor With LLCC Resonant Technique
YU Pu,LI Huafeng,HUANG Weiqing.Study on Driving Circuit of Ultrasonic Motor With LLCC Resonant Technique[J].Proceedings of the CSEE,2011,31(24).
Authors:YU Pu  LI Huafeng  HUANG Weiqing
Affiliation:YU Pu,LI Huafeng,HUANG Weiqing(State Key Laboratory of Mechanics and Control for Mechanical Structures,Nanjing University of Aeronautics and Astronautics,Nanjing 210016,Jiangsu Province,China)
Abstract:High driving voltage is required for ultrasonic motors,so the driving circuit needs a transformer to boost voltage.Since the ultrasonic motor(USM) is a nonlinear capacitive load,a matching circuit is needed to keep the output voltage and the phase shift constant.Based on the switching circuit with push-pull topology,it was analyzed that the switching loss under inductive load is less than that under capacitive load,which will increase its efficiency and reliability.A novel LLCC resonant network was proposed...
Keywords:ultrasonic motor(USM)  driver  push-pull  LLCC  resonance  
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号