| 全塑轮胎浇口设计与联合仿真分析 |
| |
| 引用本文： | 高晓东,杨卫民,张金云,安瑛,谭晶.全塑轮胎浇口设计与联合仿真分析[J].橡胶工业,2018,65(3):346-350. |
| |
| 作者姓名： | 高晓东 杨卫民 张金云 安瑛 谭晶 |
| |
| 作者单位： | 北京化工大学机电工程学院,北京化工大学机电工程学院,北京化工大学机电工程学院,北京化工大学机电工程学院,北京化工大学机电工程学院 |
| |
| 摘 要： | 采用Moldflow软件,对辐板式全塑轮胎的注塑成型过程进行模拟分析,研究注射模具浇口的位置和数量对熔料流动状态、充模情况和制品精度等的影响,同时应用Moldflow-Digimat-Abaqus联合仿真对成型后的轮胎进行力学分析。结果表明,内侧四浇口方案为最优设计。
|
| 关 键 词： | 全塑轮胎 注塑成型 联合仿真 优化设计 |
| 收稿时间： | 2016/8/3 0:00:00 |
| 修稿时间： | 2016/8/3 0:00:00 |
The Gating system Design and Analysis of Plastic Tires with Wheel Spokes |
| |
| GAO Xiao-dong,YANG Wei-min,ZHANG Jin-yun,AN Ying and TAN Jing.The Gating system Design and Analysis of Plastic Tires with Wheel Spokes[J].China Rubber Industry,2018,65(3):346-350. |
| |
| Authors: | GAO Xiao-dong YANG Wei-min ZHANG Jin-yun AN Ying and TAN Jing |
| |
| Affiliation: | Beijing University of Chemical Technology,Beijing University of Chemical Technology,Beijing University of Chemical Technology,Beijing University of Chemical Technology,Beijing University of Chemical Technology |
| |
| Abstract: | The reasonable gate location and quantity in the injection system are very important. This paper takes the full plastic non pneumatic tire as an example, the gate location and quantity are analyzed using moldflow software. Mechanical analysis of tire after molding of each options is studied by moldflow-digimat-abaqus combined simulation. Through the analysis and comparison of different schemes, the optimal gate lacation and quantity are obtained. |
| |
| Keywords: | plastic tires with wheel spokes injection molding combined simulation optimal design |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《橡胶工业》浏览原始摘要信息 |
|
点击此处可从《橡胶工业》下载全文 |
|
