首页 | 官方网站   微博 | 高级检索  
     

脱胶工艺对不同段棉秆皮纤维性能的影响
引用本文:赵领航,李龙,孙超.脱胶工艺对不同段棉秆皮纤维性能的影响[J].西北纺织工学院学报,2012(2):158-160.
作者姓名:赵领航  李龙  孙超
作者单位:西安工程大学纺织与材料学院,陕西西安710048
基金项目:教育部科学技术研究重点项目(208140); 陕西省科技计划项目(2008K06-10); 中国纺织工业协会科技指导性项目(2008009)
摘    要:定量测定棉秆皮各段成分含量,并采用化学二煮法脱胶方法对棉秆皮进行分段脱胶.以棉秆皮纤维细度、残胶率、断裂强度为指标,研究脱胶处理对提取的不同段棉秆皮纤维性能的影响.结果表明,在同一脱胶工艺条件下,不同段棉杆皮纤维的细度、残胶率、断裂强度有较大差异,棉秆皮应采用分段脱胶处理.合理的棉秆皮脱胶分段方案为:第一段根部,地表以下部分;第二段中段,地表以上长度25cm;第三段稍部,地表以上长度大于25cm.

关 键 词:棉秆皮  脱胶  细度  残胶率  断裂强度

The effect of degumming process on cotton stalk peel fiber
ZHAO Ling-hang,LI Long,SUN Chao.The effect of degumming process on cotton stalk peel fiber[J].Journal of Northwest Institute of Textile Science and Technology,2012(2):158-160.
Authors:ZHAO Ling-hang  LI Long  SUN Chao
Affiliation:(School of Textile & Materials,Xi′an Polytechnic University,Xi′an 710048,China)
Abstract:The components of different part of cotton stalk peel was measured quantitatively,segment degumming of cotton stalk peel fiber has been done by using the chemical two-step degumming method.Taking fiber finencess,residual gum content and breaking strength as indexes,the effect of degumming process on the properties of different part of cotton-stakk peel was studied.The results show that under the same degumming process condition,the fiber fineness,residual gum ratio and breaking strength in different part of cotton stalk peel have great difference.Thus,piecewise degumming process should be taken for cotton stalk peel.The proper piecewise scheme of cotton stalk peel is as follows:the root,under the ground is the first part,the length of 25cm from the ground is the second part,the top of cotton stalk peel is the third part.
Keywords:cotton stalk peel  degumming  fineness  residual gum ratio  breaking strength
本文献已被 维普 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号