| 基于单片机的钢丝绳无损检测系统设计 |
| |
| 引用本文： | 董巍巍,李建军,李钊,郭刚,米文鹏.基于单片机的钢丝绳无损检测系统设计[J].无线电工程,2013(11):43-45,64. |
| |
| 作者姓名： | 董巍巍 李建军 李钊 郭刚 米文鹏 |
| |
| 作者单位： | [1]第二炮兵工程大学士官学院,山东青州262500 [2]第二炮兵驻石家庄地区军事代表室,河北石家庄050081 |
| |
| 摘 要： | 针对钢丝绳缺陷检测装置应用的复杂现场,从钢丝绳无损检测原理出发,采用以C8051F005型单片机为核心,扩展液晶显示和基于PC机扩展USB接口通信的设计方案,开发了一套既可以单独在线实施检测并在液晶显示器上显示检测结果、又可与上位PC联机实现智能化检测诊断的低功耗、高精度钢丝绳缺陷无损检测装置。给出了系统硬件设计的基本原理、思路和软件实现方法等。系统在实验室条件下运行良好。
|
| 关 键 词： | 钢丝绳 无损检测 单片机 信号采集 |
Design on Non-destructive Testing Device of Wire Ropes Based on SCM |
| |
| Affiliation: | DONG Wei-wei1, LI Jian-jun1 , LI Zhao2, GUO Gang1 , MI Weng-peng1 ( 1. The Second Artillery Engineering University Sergeant College, Qingzhou Shandong 262500, China ; 2. Military Representative Oce of PLA Second Artillery Forces Stationed in Shifiazhuang Region, Shijiazhuang Hebei 050081, China) |
| |
| Abstract: | Aim at the complex working place of the wire rope testing device,from the principle of wire rope nondestructive testing,by adopting the design scheme of using C8051F005 MCU as the main part,extending the liquid crystal display and USB interface communication based on PC,this paper develops a wire rope nondestructive testing device with low power and high accuracy,which can not only carry out detection and the LCD display test results on line but also realize intelligent testing and diagnosis with PC. The paper introduces the basic principle and ideas of system hardware design,software implement method,etc. The system runs well in laboratory conditions. |
| |
| Keywords: | wire ropes NDE SCM signal acquisition |
| 本文献已被 维普 等数据库收录！ |
|
