| 修形ZI蜗轮滚刀齿形合格长度的研究 |
| |
| 引用本文： | 修树东,刘华明.修形ZI蜗轮滚刀齿形合格长度的研究[J].佳木斯大学学报,1994(1). |
| |
| 作者姓名： | 修树东 刘华明 |
| |
| 作者单位： | 黑龙江八一农垦大学(修树东),哈尔滨工业大学(刘华明) |
| |
| 摘 要： | 本文研究了修形ZI蜗轮滚刀齿形误差的计算方法,从理论上分析了滚刀设计参数和铲磨工艺参数对齿形误差的影响,提出了变砂轮中心高铲磨新工艺,为增加滚刀齿形合格长度开辟了新途径．
|
| 关 键 词： | 修形ZI蜗轮滚刀 滚刀齿形合格长度 铲磨工艺 |
STUDY ON QUALIFIED LENGTH OF HOB GEAR PROFILE FOR MODIFED ZI WORM HOB |
| |
| Xiu Shudong , Liu Huaming.STUDY ON QUALIFIED LENGTH OF HOB GEAR PROFILE FOR MODIFED ZI WORM HOB[J].Journal of Jiamusi University(Natural Science Edition),1994(1). |
| |
| Authors: | Xiu Shudong Liu Huaming |
| |
| Affiliation: | Xiu Shudong ; Liu Huaming (Heilong jiang August lst Agricultural Reclamation Uuiversity) (Haerbin Institute of Tachnology) |
| |
| Abstract: | In this paper,calculation method for profile error of modified ZI worm hob #is studied Factors that design parameters and relieving technical parameters affect profile error are analyzed theoretically, a new relieving technique called "changing hight of wheel center"is proposed,This creates a new way for the increase of qualified length of hob gear profile. |
| |
| Keywords: | modified ZI worm hob qualified length of hob gear profile relieving technique |
| 本文献已被 CNKI 等数据库收录！ |
