首页 | 官方网站   微博 | 高级检索  
     

动态流量软测量建模方法研究
引用本文:吕梦雅,王岩,唐勇.动态流量软测量建模方法研究[J].哈尔滨工业大学学报,2009,41(1):242-244.
作者姓名:吕梦雅  王岩  唐勇
作者单位:吕梦雅,唐勇,LV Meng-ya,TANG Yong(燕山大学信息科学与工程学院,河北秦皇岛,066004);王岩,WANG Yan(河北工业大学计算机科学与软件学院,天津,300130)  
基金项目:国家自然科学基金,河北省自然科学基金 
摘    要:为了解决工业中动态流量测量困难的问题,引入软测量方法对动态流量进行测量.考虑BP算法建立软测量模型时收敛速度慢,易陷"局部极小"等不足,提出一种经遗传算法优化的BP网络进行软测量建模,用遗传算法先确定BP网络的网络结构和参数,将训练一定次数后得到的连接权值作为遗传计算的初始值,再用遗传算法确定BP网络的最优连接权值,最后把用BP算法训练得到的网络用于建模.文中对在燕山大学液压实验室采集的数据进行仿真,实验结果表明这种改进的建模方法在模型的训练速度和精度上有了较大的改善.

关 键 词:动态流量  软测量  BP  遗传算法

Dynamical flow testing soft-sensor modelling
LV Meng-ya,WANG Yan,TANG Yong.Dynamical flow testing soft-sensor modelling[J].Journal of Harbin Institute of Technology,2009,41(1):242-244.
Authors:LV Meng-ya  WANG Yan  TANG Yong
Affiliation:1(1.The college of Information Science and Engineering,Yanshan University,Qinhuangdao 066004,China;2.School of Computer Science and Engineering,Hebei University of Technology,Tianjin 300130,China)
Abstract:Dynamic flow plays a key role in monitoring the condition of hydraulic systems since it is a rich carrier of condition information.However,flow signals were usually difficult to be measured on-line due to the limitations such as high cost and time delay.For solving this problem,a novel soft sensor is presented.In order to overcome the disadvantages such as slow convergent speed and local minimum,the backpropagation(BP) was used to build the model of soft sensor.The GA algorithm was applied to optimize parameters and the structure of BPNN,thus to improve the performance of the model.The data produced by collection were adopted for the sake of simulation.The result verifies the validity of this method.
Keywords:BP
本文献已被 CNKI 万方数据 等数据库收录!
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号