An efficient technique for pre-selecting low-redshift damped Lyα systems

The number of z ～ 1 damped Lyα systems (DLAs, log  N (H  i ) ≥ 20.3) per unit redshift is approximately 0.1, making them relatively rare objects. Large, blind QSO surveys for low-redshift DLAs are therefore an expensive prospect for space-borne ultraviolet telescopes. Increasing the efficiency of these surveys by pre-selecting DLA candidates based on the equivalent widths (EWs) of metal absorption lines has previously been a successful strategy. However, the success rate of DLA identification is still only ～35 per cent when simple EW cut-offs are applied, the majority of systems having 19.0 < log  N (H  i ) < 20.3. Here, we propose a new way to pre-select DLA candidates. Our technique requires high-to-moderate-resolution spectroscopy of the Mg  ii λ2796 transition, which is easily accessible from the ground for 0.2 ? z ? 2.4. We define the D -index, the ratio of the line equivalent width to velocity spread, and measure this quantity for 19 DLAs and eight sub-DLAs in archival spectra obtained with echelle spectrographs. For the majority of absorbers, there is a clear distinction between the D -index of DLAs compared with sub-DLAs (Kolmogorov–Smirnov probability = 0.8 per cent). Based on this pilot data sample, we find that the D -index can select DLAs with a success rate of up to 90 per cent, an increase in selection efficiency by a factor of 2.5 compared with a simple EW cut. We test the applicability of the D -index at lower resolution and find that it remains a good discriminant of DLAs for full width at half-maximum (FWHM) ? 1.5 Å. However, the recommended D -index cut-off between DLAs and sub-DLAs decreases with poorer resolution and we tabulate the appropriate D -index values that should be used with spectra of different resolutions.