高效液相色谱法测定密胺餐具中甲醛单体迁移量

采用高效液相色谱法测定密胺餐具中的甲醛迁移量。样品经乙酸(4+96)溶液浸泡提取后,加入2,4-二硝基苯肼,与浸泡液中的甲醛反应生成2,4-二硝基苯腙,以C18色谱柱为分离柱,以甲醇-水(7+3)溶液为流动相进行等度洗脱,检测波长为350 nm。甲醛的质量浓度在0.01~40.0 mg·L-1范围内呈线性,测定下限(10S/N)为0.01 mg·L-1。对空白样品进行加标回收试验,回收率在99.8%~101%之间,相对标准偏差(n=10)均不大于0.6%。方法适用于密胺餐具中甲醛迁移量的检测。     

计算机辅助设计三聚氰胺分子印迹聚合物

借助密度泛函理论(DFT)长程校正方法,以三聚氰胺(MAM)为印迹分子,甲基丙烯酸(MAA)为功能单体,分别以二甲基丙烯酸乙二醇酯(EGDMA)、三羟甲基丙烷三甲基丙烯酸酯(TRIM)及二乙烯苯(DVB)为交联剂,以乙腈(ACN)、甲醇(MT)、乙醇(EA)、甲苯(TL)、四氢呋喃(THF)及二甲基亚砜(DMSO)为溶剂,模拟了MAM与MAA单体分子印迹聚合物(MIPs)自组装体系的构型,讨论了MAM与MAA的成键作用位点,及其稳定复合物的印迹反应比例及印迹作用机理,依据结合能(△E)优化了交联剂和溶剂,并借助分子中原子理论(AIM)揭示了MAM与MAA印迹作用的本质.计算结果表明,MAM印迹分子三嗪环上的N与胺基上H均通过氢键与MAA单体进行印迹聚合反应,且在印迹反应比例为1∶6,以TL为溶剂时形成的MAM-MAA有序复合物结合能最低,构型最稳定;与TRIM及EGDMA交联剂相比,DVB与MAM结合能最低,更适宜作为MAM-MAA印迹聚合物的交联剂.本研究为MAM-MIPs合成时印迹比例、交联剂及溶剂的选择提供了理论依据.     

静电纺丝法制备交联多孔纳米碳纤维膜及其电化学电容性能

Cross-linked porous carbon nanofiber networks were successfully prepared by electrospinning followed by preoxidation and carbonization using low-cost melamine and polyacrylonitrile (PAN) as precursors. The structures and morphologies of the nanofiber networks were investigated using Fourier-transform infrared (FTIR) spectroscopy, thermogravimetric analysis (TGA), scanning electron microscopy (SEM), X-ray diffraction (XRD), Raman spectroscopy, and N₂ adsorption/desorption. The carbon fibers had an interconnected nanofibrous morphology with a well-developed porous structure including micropores, mesopores and macropores, high-level nitrogen doping (up to 14.3%), and a small average diameter (about 89 nm). Without activation, the carbon nanofibers had a high specific capacitance of 194 F·g^-1 at a current density of 0.05 A·g^-1. Cycling experiments showed that the specific capacitance retained approximately 99.2% of the initial capacitance after 1000 cycles at a current density of 2 A·g^-1, indicating an excellent electrochemical performance.     

Quantitative surface-enhanced Raman measurements with embedded internal reference

Analytical applications of SERS are often more associated with qualitative than quantitative analysis, because of the difficulty in obtaining quantitative SERS results. In this paper we introduce a new strategy to quantitatively measure the SERS signals of analytes based on Au-core/Ag-shell nanoparticles with embedded 4-aminothiophenol as the internal reference. Successful detections of two analytes, Toluidine Blue O in aqueous solution (detection limit of 0.1 μM) and melamine in milk (detection limit of ∼5 μM), are demonstrated. The improvement in the linear fitting illustrates that the use of internal reference significantly improves the accuracy of the quantitative SERS measurements. The successful detection of melamine in milk illustrates the versatility of this detection scheme for a wide variety of analytes.     

表面增强拉曼光谱法同时检测奶粉中三聚氰胺和二聚氰胺

本文建立了奶粉中同时检测三聚氰胺及二聚氰胺的表面增强拉曼光谱法.奶粉样品经15％三氯乙酸溶液提取,中性氧化铝吸附杂质后进行拉曼光谱检测.三聚氰胺线性范围为0.0050～0.075 mg/L,检出限为0.0015 mg/L,回收率在79.5％～124％之间,相对标准偏差小于8.8％(n=5);二聚氰胺线性范围为0.50～l0mg/L,检出限为0.15 mg/L,回收率在76.5％～112％之间,相对标准偏差小于9.4％(n=5).该方法相比常规表面增强拉曼光谱法,仅通过一种样品前处理手段即可对奶粉中的三聚氰胺或二聚氰胺进行定性检出及定量分析,相比色谱等检测方法具有样品前处理过程简单、耗时短等优点,在奶粉质量监控方面具有良好的应用前景.     

自组装有序纳米银线表面增强拉曼光谱检测牛奶中三聚氰胺

制备具有表面增强拉曼散射(SERS)增强效果的基底是获得灵敏SERS检测的基础.本研究以多元醇法合成、流体流动法组装制备的有序纳米银线作为三聚氰胺的SERS增强基底,实现了样品中痕量三聚氰胺的快速灵敏检测.通过理论计算及实验考察得到了三聚氰胺的拉曼特征峰,优化了三聚氰胺在有序纳米银线基底上的SERS检测条件.在pH=8、水为溶剂、溶剂挥发时间为14 min的最佳条件下,三聚氰胺特征峰强度与浓度在0.05 ～ 1.00 mg/L范围内呈现良好的线性关系,其线性相关系数R=0.997,检测限为0.05 mg/L.在牛奶中添加不同浓度的三聚氰胺,其回收率为89.7％～ 109.2％,相对标准偏差低于6.8％.本方法对三聚氰胺检测具有很好的灵敏度和稳定性,为其它小分子化合物的SERS检测提供技术支持.     

Triazine Dendrimers for Drug Delivery: Evaluation of Solubilization Properties,Activity in Cell Culture,and In Vivo Toxicity of a Candidate Vehicle

Three criteria are evaluated to assess the potential of a dendrimer based on triazines, 1, for use as a vehicle for drug delivery. These criteria are: (1) its ability to solubilize small hydrophobic guests as measured spectrophotometrically; (2) its ability to deliver a drug in vitro as evaluated using a gene reporter assay; and (3) its in vivo toxicity in mice as determined by autopsy and screens of liver and kidney function. Vehicle 1 solubilizes pyrene to a similar extent to dendrimers based on poly(arylether)s, 4, encapsulating approximately 0.2 molecules of pyrene per dendrimer. This activity is approximately 10-fold greater than that of the more polar poly(propyleneimine) and poly(amidoamine) dendrimers, 2 and 3. Gas-phase computational models reveal that both 1 and 4 have cores that are accessible to solvent, suggesting that these dendrimers can occupy much greater volumes than 2 and 3 whose cores are confined toward the interior of the structure. Electrostatic potential maps can be used to rationalize differences in solubilization between 1 and 4. Precipitation results from mixing cationic 1 with the anionic indomethacin, but not with methotrexate, suggesting that the composition of the drug may dictate the scope of delivery applications. Dendrimer 1 solubilizes 10-hydroxycamptothecin and a novel bisindolemethane; approximately four and five molecules of drug per dendrimer are solubilized, respectively. In cell-culture experiments using a luciferase reporter gene assay, the dendrimer:bisindolemethane conjugate shows comparable activity to the bisindolemethane delivered in aqueous DMSO, suggesting that the dendrimer does not preclude delivery of the molecule to an intracellular target. Preliminary toxicology studies of 1 in mice show that this molecule has no adverse toxicity to the kidneys or the liver in single doses delivered intraperitoneally up to 10?mg/kg.     

Cu原子掺杂调控三聚氰胺在Au(111)表面自组装结构

The doping effect of Cu on the self-assembly film of melamine on an Au(111) surface has been investigated with scanning tunneling microscopy (STM). The evaporated Cu adatoms occupy the positions underneath the amino groups and change the hydrogen bonding pattern between the melamine molecules. Accordingly, the self-assembly structure has changed stepwise from a well-defined honeycomb into a track-like and then a triangular structure depending on the amount of Cu adatoms. The interaction between Cu adatom and melamine is moderate thus the Cu adatoms can be released upon mild heating to around 100℃. These findings are different from previous observations of either the coordination assembly or the physically trapped metal adatoms.     

Fabrication of Melamine/Tb3+-Intercalated Polydiacetylene Nanosheets and Their Thermochromic Reversibility

Polydiacetylene (PDA) is one kind of the conjugated polymer with layered structure, which can serve as a host to accommodate the guest components through intercalation. In these intercalated PDAs, some of them were reported to have a nearly perfect organized structure and perform completely reversible thermochromism. Till now, these reported intercalated PDAs were made by only introducing a single component for intercalation. Here, we chose 10, 12-pentacosadiynoic acid (PCDA) as the monomer, of which the carboxyl-terminal groups can interact with either Tb\begin{document}$ ^{3+} $\end{document} ions or melamines (MAs). When the feeding molar ratio of PCDA, MA, and Tb\begin{document}$ ^{3+} $\end{document} ion was 3:267:1, only Tb\begin{document}$ ^{3+} $\end{document} ions were intercalated though excess MAs existed. Such Tb\begin{document}$ ^{3+} $\end{document}-intercalated poly-PCDA exhibited completely reversible thermochromism, where almost all the carboxyl groups interacted with Tb\begin{document}$ ^{3+} $\end{document} ions to form the nearly perfect structure. When the feeding molar ratio of PCDA, MA, and Tb\begin{document}$ ^{3+} $\end{document} ion was 3:267:0.6, both Tb\begin{document}$ ^{3+} $\end{document} ions and MAs were intercalated. There existed some defects in the imperfect MA-intercalated domains and at the domain boundaries. The MA/Tb\begin{document}$ ^{3+} $\end{document}-intercalated poly-PCDA exhibits partially reversible thermochromism, where the backbones near the defects are hard to return the initial conformation, while the rest, those at nearly perfect organized domains, are still able to restore the initial conformation.     

三聚氰胺修饰玻碳电极用于溶出伏安法测定水样中痕量银

用电化学沉积法将三聚氰胺修饰在玻碳电极上,应用此三聚氰胺修饰玻碳电极测定银时,试液在pH 4.6的乙酸-乙酸钠缓冲溶液中,在—0.45V处还原60 s,然后在0～+0.6V范围内扫描,使银离子从修饰电极上溶出,实现了水样中银离子的溶出伏安法测定,在+0.27V处可得银离子的氧化峰电位,银的浓度在6.0×10~(-9)～5.0×10~(-7)mol·L~(-1)范围内与其峰电流呈线性关系,检出限(3S/N)为1.0×10~(-9)mol·L~(-1)。方法用于实际水样中痕量银的测定,加标回收率在90.0%～96.0%之间。