首页 | 官方网站   微博 | 高级检索  
文章检索
  按 检索   检索词:      
出版年份:   被引次数:   他引次数: 提示:输入*表示无穷大
  收费全文   1669篇
  免费   132篇
  国内免费   47篇
工业技术   1848篇
  2024年   6篇
  2023年   13篇
  2022年   22篇
  2021年   26篇
  2020年   31篇
  2019年   33篇
  2018年   34篇
  2017年   52篇
  2016年   59篇
  2015年   53篇
  2014年   64篇
  2013年   88篇
  2012年   151篇
  2011年   114篇
  2010年   85篇
  2009年   105篇
  2008年   67篇
  2007年   109篇
  2006年   124篇
  2005年   87篇
  2004年   78篇
  2003年   75篇
  2002年   61篇
  2001年   54篇
  2000年   32篇
  1999年   32篇
  1998年   30篇
  1997年   33篇
  1996年   18篇
  1995年   19篇
  1994年   20篇
  1993年   9篇
  1992年   9篇
  1991年   8篇
  1990年   3篇
  1989年   6篇
  1988年   7篇
  1987年   5篇
  1986年   4篇
  1985年   6篇
  1984年   3篇
  1983年   2篇
  1982年   1篇
  1980年   1篇
  1978年   1篇
  1976年   2篇
  1975年   4篇
  1973年   1篇
  1951年   1篇
排序方式: 共有1848条查询结果,搜索用时 31 毫秒
1.
磁絮凝强化技术处理厌氧消化污泥脱水液   总被引:1,自引:0,他引:1       下载免费PDF全文
为满足后续生物处理单元对固体悬浮物(SS)和铁浓度的进水要求,采用磁絮凝强化技术对厌氧消化污泥脱水液进行预处理。通过正交试验和单因素试验,本文考察了混凝水力条件、聚合氯化铝(PAC)投加量、聚丙烯酰胺(PAM)投加量、磁粉投加量及药剂投加顺序对磁絮凝效果的影响。试验结果表明:磁絮凝强化技术在快搅300r/min(2min)、慢搅100r/min(15min)、静置10min时,依次投加磁粉(40mg/L)、PAC(30mg/L)、PAM(4mg/L)时处理效果最好。在此运行条件下,SS和Fe3+去除率分别为97.61%、98.24%、絮凝指数(FI值)取得最大值、zeta电位绝对值最小,絮凝效果最佳。与对照相比,磁絮凝强化技术对SS和Fe3+去除率分别可提高3.70%和10.82%,同时絮体最大沉降速度可提高33%。磁絮凝技术处理后的出水不仅可以满足后续生物处理单元对SS和铁浓度的要求,还可以有效提高磁絮凝体的沉降速度,减小沉淀时间,具有较好的实用价值。  相似文献   
2.
轻质滤料滤池的试验与研究   总被引:1,自引:0,他引:1  
轻质滤料滤池是以比水密度略小的滤料为滤床的滤池,通过以净水厂的原水和污水处理厂的二级处理出水为过滤试验对象,所取得的结果表明:下向流轻质滤料滤池对浊度和悬浮固体(SS)的去除率分别可以达到80%和45%,而滤床的水头损失不超过15cm。因此轻质滤料滤池可以以预过滤的形式配置在过滤处理的净水和污水的处理工艺中。  相似文献   
3.
Preparation of clean coal by flotation following ultra fine liberation   总被引:1,自引:0,他引:1  
This paper reports the results of current fundamental research at the Department of Process Engineering, University of Miskolc on the processing of clean coal from Mecsek bituminous coal, Southern Hungary. The theoretical possibility of the separation of different petrographic components was proven experimentally and their liberation degree was determined based on the petrographic composition, flotation kinetic study of isolated components (groups of components), scanning electron microscopy and microprobe analyses. The mill with stirred ball media was chosen for the ultra-fine liberation of the coal components. It was revealed that along with the liberation of coal components, their surface oxidation and spontaneous agglomeration, entrapping the mineral impurities take place in ultra-fine grinding. This paper discusses the interfacial phenomena occurring in the ultra-fine grinding process and their influence on the flotation. The concept for the advanced preparation of clean coal was developed, tested and proved. The main steps of this concept are the ultra-fine liberation in the stirred-media mill, the de-agglomeration of flocs spontaneously formed during the ultra-fine grinding and the induced (hydrophobic) flocculation with the following two-step flotation in a flotation column.  相似文献   
4.
一种两性离子聚合物的合成性能及应用分析   总被引:2,自引:0,他引:2  
本文合成了一种两性离子聚合物:丙烯酰胺—二甲基二烯丙基氯化铵—丙烯酸共聚物(PADA),讨论了三种单体的投料比对产物的组成影响。对它的结构进行了红外表征,就其絮凝、粘土防膨、抗温、抗盐性能进行了研究。结果表明:PADA具有好的防膨能力和良好的抗温抗盐性能,并有絮凝能力。  相似文献   
5.
以钛白粉副产品绿矾为主要原料,氯酸钠作氧化剂,调节亚铁离子与硫酸根离子之间摩尔比后微波作用仅几分钟就能合成出液体聚合硫酸铁,并在此基础上加入磷酸根离子可得到所需絮凝剂--聚合磷硫酸铁;试验了该絮凝剂最佳合成工艺条件;采用该试剂净化含铅废水,取得了较好去除效果,并且探讨了除铅最佳试验条件.  相似文献   
6.
一种有机硫类絮凝剂DTC的合成及性能评价   总被引:1,自引:0,他引:1  
李丽  刘伟 《油田化学》2007,24(1):48-52
讨论了由有机伯胺或仲胺和CS2合成二硫代氨基甲酸盐DTC的反应及副反应,简介了合成工艺。根据红外光谱确认了由三乙烯四胺合成的二硫代氨基甲酸盐(以下简称DTC)的结构。以含原油350 mg/L、含悬浮固体55.1 mg/L,含Fe^2+10.0 mg/L的模拟污水为实验水样,考察了该DTC的絮凝性能,在40℃、pH=6-7、沉降时间30分钟条件下DTC的适宜加量为20 mg/L,此时污水含油量为9.0 mg/L;使用DTC的适宜pH范围在4-8,pH=6为最佳值,适宜温度范围为10-45℃,温度高于45℃时DTC可发生热分解;DTC的除油效果随污水中Fe^2+浓度增大而改善。在含油89.1 mg/L、含悬浮固体55.1 mg/L、含Fe^2+13.2 mg/L的油田污水中,DTC的除油率最高,远高于常用絮凝剂PFS,PAC,CPAM,HPAM和PAM。当污水中不含Fe^2+时,DTC无絮凝除油效果。讨论了DTC在Fe^2+参与下的絮凝过程。图5表1参8。  相似文献   
7.
以丙烯酰胺、丙烯酰氧基乙基三甲基氯化铵、聚氧乙烯大单体和N ,N’ -亚甲基双丙烯酰胺为单体 ,进行四元反相微乳液共聚合 ,制备出新型含PEO支链的阳离子微粒絮凝剂。然后用该微粒絮凝剂分别对针叶木纸浆和特种纸白水进行了助留和絮凝性能的研究 ,结果表明 ,本新型微粒具有能单独使用、絮凝效果好和抗剪切性强等优点。  相似文献   
8.
阳离子型聚丙烯酰胺絮凝剂的开发与应用   总被引:8,自引:0,他引:8  
阳离子型聚丙烯酰胺具有许多优点,极具开发研究价值,是重要的高分子絮凝剂。介绍了阳离子型聚丙烯酰胺絮凝剂的制备方法,应用及其絮凝作用机理,并分析了其发展方向。  相似文献   
9.
Dispersion–flocculation studies on a Goethite–clay system using flocculants were carried out as a function of flocculant concentrations, pH of slurry, time of agitation and dispersant dosage. Also, the effects of pH and polymer concentrations on the adsorption behaviour of the system were investigated. Results show that well flocculated goethite was preferentially obtained from 4% goethite/kaolinite clay suspensions, with 50 ppm causticised starch in the slurry at pH values of 3–11·5 and with 50 ppm polyacrylamide at pH values of 3–8. Good flocs were also obtained on flocculation of the goethite suspension with 50 ppm polyacrylamide at pH values of 5–7, while the kaolinite suspension did not respond to the same dosage of causticised starch in the same pH range. Results further reveal that for the goethite/kaolinite suspension, the best results was obtained with 50 ppm polyacrylamide at pH values of 7–10. Based on the data generated in the study, it was concluded that causticised starch is a better flocculant than polyacrylamide for goethite suspensions although polyacrylamide is an excellent flocculant for kaolinite suspensions.  相似文献   
10.
Several problems are encountered with asphaltenes during the exploitation, transportation, storage and treatment of crude oil. The purpose of the present work was to study the behaviour of the crude oil fraction (<210°C) by varying the temperature and doping with some hydrocarbons including solid paraffin and aromatic concentrate. The effect of flooding water was investigated. A preliminary characterization study on asphaltenes removed from the crude oil using two different solvents was performed. The state of the oil was determined by the stability factor which indicates the susceptibility of asphaltenes to agglomerate or to disperse in the continuous phase.  相似文献   
设为首页 | 免责声明 | 关于勤云 | 加入收藏

Copyright©北京勤云科技发展有限公司    京ICP备09084417号-23

京公网安备 11010802026262号