基于P波模量的原位胶结充填体强度预测模型研究

原位胶结充填体质量评价通常采用单轴抗压强度作为表征指标,由于在现场工程中无法快速、准确获取充填体的强度值,因此需要建立一种参数易于获取且准确的原位胶结充填体强度预测模型。基于胶结充填体物理力学参数的内在联系,从量纲平衡的角度探索了胶结充填体单轴抗压强度与P波模量的关系。根据C矿和I矿两种原位胶结充填体的密度、P波速度及取芯强度的测试数据,采用线性拟合的方法获得了基于P波模量的原位胶结充填体强度预测模型。通过对C矿和I矿的强度预测模型拟合效果分析可知,P波模量与取芯强度呈正相关性,且拟合效果较好,证明原位胶结充填体强度预测模型精度高,具有很强的实用性。     

北洺河铁矿全尾砂胶结充填治理塌陷区的可行性研究

北洺河铁矿为践行“绿水青山就是金山银山”的绿色发展理念,探索利用选厂尾矿治理地表塌陷区方案。通过对北洺河铁矿塌陷区稳定性分析以及对全尾砂膏体制备、输送、胶结充填技术可行性试验研究,并结合经济估算、环境和社会效益等综合分析,认为全尾砂胶结充填治理塌陷区的方案可行。     

Paste backfill of high-sulphide mill tailings using alkali-activated blast furnace slag: Effect of activator nature,concentration and slag properties

The effect of activator type, concentration and slag composition on the strength and stability properties of paste backfill (CPB) of high-sulphide tailings using alkali-activated slag (AAS) as binder (7 wt.%) were investigated in this study. Acidic and neutral (AS–NS) slags were activated with liquid sodium silicate (LSS) and sodium hydroxide (SH) at 6–10 wt.% concentrations. Ordinary Portland cement (OPC) results were used for comparison. The strength development was found to remarkably improve with increasing the concentration from 6 to 8 wt.%. Further increase in concentration did not enhance the strength. SH was determined to produce higher early-age strength whilst LSS produced higher long-term strengths as an indication of slag selectivity for activators. More extensive gypsum formation was observed at lower concentrations in SEM/EDS studies. An increase in Na₂O concentration raised the activator consumption. High concentrations also led to poorly crystallized C–S–H gel, loose structure and drying shrinkage cracks especially in NS–SH samples. A reduction in total porosity up to 20% was obtained in AAS samples compared to OPC. Amorphous structure, chemical modulus ratio and/or basicity index (BI) values were seen to control the pozzolanic reactivity, and therefore, the alkali-activation and hardening process.     

全尾砂和废石联合胶结充填体最佳配比及应用

针对红岭铅锌矿分级充填骨料来源不足、地表废石堆积污染环境的情况,提出将该矿选厂产生的全尾砂和地表废石作为充填骨料的联合胶结充填方案。分别测试了全尾砂和地表废石的物理化学性质,验证了碎石和全尾砂作为联合充填骨料的可行性。通过充填配比试验,分析了不同配比全尾砂废石充填体强度特性,得出了最佳充填配比。结果表明,充填试块的强度随灰砂比减小而减小,随养护龄期增加呈增大趋势,随充填料浆质量浓度增大而增大,最佳配比为: 胶结充填灰砂比1∶8、普通充填灰砂比1∶12,全尾砂∶废石配比4∶6,质量浓度78%。根据研究结果,在红岭铅锌矿进行了全尾砂废石充填技术工业应用,证实该技术可行。     

Assessment of digital image correlation method in determining large scale cemented rockfill strains

A conventional contact method(using linear transducers) and a non-contact method are deployed to measure the axial and lateral deformations of large scale cylindrical cemented rockfill specimens.Experimental works incorporating two pinhole cameras to create one stereovision by digital image correlation shows that the non-contact method is as reliable for testing large cylindrical specimens as measurements done by using linear variable displacement transformer and string potentiometer. Considering this particular large specimen, the experiment resulted in the acceptable mean difference between lateral strain using both methods is 5.1 percent, and 14.5 percent for the axial strain. This occurrence is inevitable due to the heterogeneity of the concrete system and the placement of the monitoring point in digital image correlation method, although the comparison of stress-strain relationship in both methods still indicates a conformity. Based on the results of the present experiments, the authors recommend the noncontact method for a detailed investigation of the material behavior during the uniaxial compressive strength tests. Full field strain measurement enables this digital method to examine local strains near cracks at any point, a very useful tool for studying material deformation behavior.     

Seismic behavior of geosynthetic-reinforced retaining walls backfilled with cohesive soil

This study investigates the seismic performance of geosynthetic-reinforced modular block retaining walls backfilled with cohesive, fine grained clay-sand soil mixture. Shaking table tests were performed for three ½ scaled (wall height 190 cm) and ¼ scaled model walls to investigate the effects of backfill type, the influence of reinforcement length and reinforcement stiffness effects. The El Centro and Kobe earthquake records of varying amplitudes were used as base acceleration. Displacement of the front wall, accelerations at different locations, strains on the reinforcements, and the visual observations of the facing and the backfill surface were used to evaluate the seismic performance of model walls. The model walls were subjected to rigorous shaking and the walls did not exhibit any stability problems or signs of impending failure. The maximum deformations observed on the models with cohesive backfill was less than half of the deformation of the sand model. The load transfers between the geogrid and cohesive soil was comparable to that of sand and hence the needed reinforcement length was similar as well. As a result; the model walls with cohesive backfills performed within acceptable limits under seismic loading conditions when compared with granular backfilled counterparts.     

温度对膏体充填料浆流变特性影响试验研究

为了探究膏体的流变特性,取某尾砂制备不同质量浓度、灰砂比的尾砂料浆,采用Brookfield R/S+型流变仪和TC-550型制冷/加热式循环浴温度控制设备进行了膏体流变特性测试。结果表明,膏体料浆屈服应力和黏度随温度的变化与灰砂比和浓度有关。当灰砂比一定时,低浓度料浆屈服应力随温度增加不断减小,高浓度料浆屈服应力随温度升高先增加后减小; 当料浆浓度一定时,随着水泥比例增加,屈服应力随温度升高从不断减小到先增加后减小,且水泥比例越大,使屈服应力开始减小的温度越高。黏度变化情况与屈服应力类似。     

Investigation report of geotechnical disaster on river area due to typhoon landfall three times on Okhotsk region,Hokkaido, Japan

For one week from August 17 to 23, 2016, three consecutive typhoons made landfall in Hokkaido for the first time on record. These typhoons and the front they stimulated brought record-breaking torrential rain over the eastern part of Hokkaido. To investigate the damage to grounds and rivers resulting from this rainfall, the Japan Society of Civil Engineers (JSCE) and the Japanese Geotechnical Society (JGS) formed a disaster research group to conduct an investigation. This report provides the results of the investigation into damage to the grounds of areas along the Tokoro River of the Okhotsk region, Hokkaido, that suffered from this tremendous and diverse disaster. Specifically, the report describes the situation of the levees which were broken and eroded by the overflowing water, the shape of the levee bodies, the levee body soil properties examined by observation of the sections, as well as the occurrence of sand boiling and air blows. The washout of road embankments as well as damage to road bridge mounting fills and abutment backfills were also investigated. The investigation has demonstrated the need to clarify the resistance of the abutment backfills and levee bodies to flowing water as well as the geotechnical predominant factors in order to clarify the mechanisms behind erosion and washout, the need to review new measures that allow for the scale of sand boiling and resultant changes in levee body stability, and the fact that the existing embankments were able to temporarily suppress the flooding water which had spilled over from the river. Furthermore, although it has been identified that the findings of a study on an embankment washout associated with a tsunami can be applied to measures taken against the overflowing water, it has also been found necessary to clarify the predominant geotechnical factors using model tests and to use a more sophisticated analytical approach to establish a geotechnical stability review as soon as possible in order to prevent the levees and embankments from being eroded and washed out due to overflowing water.     

高庙子膨润土及其混合材料导热性能研究

导热性能是高放废物地质处置库缓冲/回填材料的重要性能之一。采用瞬变平面热源法,研究了我国高放废物地质处置首选缓冲/回填材料高庙子膨润土,及以其为主料,添加不同含量石英砂、北山花岗岩碎屑组成的混合材料的导热性能。分析了添加剂种类和含量、干密度、饱和度等因素对导热系数的影响。研究结果表明:高庙子膨润土及其混合材料的导热系数、热扩散系数都随干密度和含水量的增大而增大;石英砂、北山花岗岩碎屑能够不同程度提高膨润土的导热系数,石英砂的作用优于北山花岗岩碎屑;饱和度对添加剂发挥其提高缓冲/回填材料导热性能的作用影响明显,饱和度越高,添加剂的作用越显著。