钛基Ce掺杂SnO_2-RuO_2电极的制备及其对焦化废水的电解处理

采用溶胶-凝胶法制备了经稀土元素Ce掺杂改性的Ti/RuO_2-SnO_2-Ce电极,利用SEM、XRD、EDS等分析方法对电极表面的形貌、物相和涂层成分进行了表征,利用CV曲线、LSV曲线等检测手段对电极的电化学性能进行了测试。以Ti/RuO_2-SnO_2-Ce电极为阳极,钛板为阴极,构建电化学氧化反应装置,并采用其对焦化废水进行电解处理。结果表明,Ti/RuO_2-SnO_2电极经稀土Ce改性后极板表面活性位点数量明显增大,金属涂层的结晶化程度明显增强,电极的催化氧化活性显著提高。室温条件下,保持pH值为7.83,在电流密度为30mA/cm~2,电解时间为30min时,焦化废水经电解处理后COD去除率可达91.63%,TOC去除率可达66.22%,UV254值下降到0.921。     

二氧化锡溅射工艺研究

SnO2 是最早使用也是目前使用最广泛的一种气敏材料 ,使用该材料设计制作的气敏传感器具有许多优点。在简要介绍溅射镀膜的成膜过程和特点的基础上 ,着重介绍了SnO2 膜的制备流程 ,分析了功率和温度变化对成膜质量的影响     

Preparation and properties of nano-sized SnO2 powder

1　INTRODUCTIONSnO2isoneofthemainmaterialsusedingassensor.Becauseofthehumidityandgassensingfunction,itattractsmoreandmoreattentions.Butthepresentproblemishowtoimprovethestabilityandsensibilityofgassensor.Researchershavetakenmanymeasurestoresolvethisproble…     

湿化学法制备纳米ATO导电粉

采用非均相成核法 ,在Sn(OH) 4 晶种上均匀生长Sb掺杂Sn(OH) 4 ,制备纳米ATO粉末。以电阻测定系统研究了合成条件如掺杂浓度、反应温度、pH值、SnCl4浓度等对最终粉末电阻性能的影响。以TG DSC热分析、XRD、TEM等手段研究了晶粒生长过程 ,XRD显示为四方金红石型结构 ,平均粒径为15nm。当Sb/Sn(mol比 ) =0 .0 5 ,pH =2 ,T =60℃ ,SnCl4=1.2～ 1.8mol·L-1时 ,粉体电阻小于 0 .5Ω。     

用激光烧结法制备的SnO2薄膜的气敏性质

用溶胶-凝胶法制备SnO2前驱液,然后用提拉法分别在单晶Si和Al2O3基片表面制备出SnO2前驱膜,再用脉冲Nd:YAG激光烧结前驱膜使其转变为晶体SnO2薄膜.用XRD分析了单晶Si表面的SnO2薄膜,研究激光功率对SnO2薄膜相组成的影响.TEM观察表明,激光烧结后的薄膜SnO2颗粒均匀,直径约为10 nm.用激光烧结法制备的SnO2薄膜对浓度为1.80×10-4丙酮的最高灵敏度为30～40,明显高于用传统烧结法制备的SnO2薄膜的灵敏度.激光烧结能降低薄膜具有最高灵敏度的工作温度.     

固体超强酸S_2O_8~(2-)/SnO_2-SiO_2催化合成环己酮1,2-丙二醇缩酮

采用沉淀-浸渍法制备了固体超强酸S2O28-/SnO2-SiO2,以它为催化剂催化环己酮和1,2-丙二醇合成了环己酮1,2-丙二醇缩酮;考察了带水剂种类及用量、酮醇摩尔比、催化剂用量、反应时间对产品收率的影响,并用正交实验对反应条件进行了优化。实验结果表明,适宜的反应条件为:n(环己酮)∶n(1,2-丙二醇)=1∶1.6、催化剂用量为反应物料总质量的2.0%、带水剂环己烷用量5.0mL、反应时间50min。在此条件下,环己酮1,2-丙二醇缩酮收率达到91.47%;催化剂的稳定性良好,在重复使用5次后环己酮1,2-丙二醇缩酮收率为82.20%,活性下降的主要原因为催化剂表面积碳和吸附了有机物;经傅里叶变换红外光谱和气相色谱质谱分析表明,产物为环己酮1,2-丙二醇缩酮,纯度为100%。     

HZSM5分子筛膜复合二氧化锡对甲烷的气敏性能研究

采用液相氧化法制备二氧化锡纳米颗粒,并利用浸渍法制备Pd负载二氧化锡纳米材料,通过丝网印刷得到气敏传感膜并在其表面印刷分子筛层。基于动态气敏测试系统探究传感器对甲烷气体的灵敏度及其在CO和乙醇干扰气体下的选择性。研究结果表明,在Pd-SnO₂敏感层表面印刷Pd-HZSM5层后,传感器对甲烷的响应能力显著提高,并且在体积分数为5×10^-4的CO存在时,对甲烷的选择性也得到明显的提升。同样,在质量分数为2×10^-5乙醇的存在下,传感器对甲烷的响应也没有受到干扰。通过对分子筛进行表征和催化分析,发现Pd-HZSM5对CO的催化效率可达100%,使得CO在扩散过程中被催化氧化,这可能是印刷Pd-HZSM5分子筛膜从而提高传感器选择性的主要原因。同时研究还表明,在敏感层表面印刷分子筛层并不会影响传感器的响应和恢复速率。     

二甲醚催化氧化制下游产品(Ⅱ)V/Mn改性的SnO2/MgO催化氧化制碳氢化合物

考察了SnO2/MgO催化剂和添加助剂V、Mn对二甲醚（DME）催化氧化制取乙二醇二甲醚（DMET）和其他碳氢化合物的催化性能。结果表明，锡镁催化剂对DME在275～325 ℃有良好的催化活性；添加VOx能较大提高DME转化率和产物DMET的选择性，DME转化率可达23％，DMET选择性可达44％，在300℃收率达9％以上。     

Catalytic activity and solid acidity of vanadium oxide thin layer loaded on TiO2, ZrO2, and SnO2

Vanadium oxide spread highly on TiO₂ (anatase, A) and SnO₂, and rather densely on TiO₂ (rutile, R) and ZrO₂ to make the monolayer in less than 4–5 V nm⁻². Profile of acid site of the monolayer was measured by temperature programmed desorption of ammonia, and its relation with the surface oxidation state was studied. The acid site density was high on the V₂O₅/TiO₂ (A) independent of the degree of oxidation. On the other hand, that of V₂O₅/TiO₂ (R) and V₂O₅/ZrO₂ depended on the oxidation state, and the high value of the concentration was observed on the oxidized one. The strength of acid site generated on the V₂O₅ monolayer on TiO₂ was as high as on the HZSM-5 zeolite. Turnover frequency (TOF) of propane conversion, and product selectivity were measured in propane oxidation. Among tested oxides, the V₂O₅/TiO₂ (A) showed the high TOF and selectivity to form propylene, while those loaded on TiO₂ (R) and ZrO₂ the small TOF and poor selectivity. Therefore, the reaction profile of activity and selectivity could be related with the extent of spreading and solid acidity. An idea of limit of the acid site density ca. 1.5 nm⁻² on the monolayer was elucidated.     

Investigation on the electrocatalytic characteristics of SnO_2 electrodes with nanocoating prepared by electrodeposition method

SnO2 electrodes have many advantages in the degradation of toxic or bio-refractory organic wastewater,and SnO2 is a kind of anode material which has the potential to be widely used.Electrocatalytic effi-ciency and service life of Ti\SnO2 electrodes are key factors that can influence its applications.In order to enhance the electrocatalytic characteristics of Ti\SnO2 electrodes,a type of electrocatalytic electrode with nanocoating was prepared by direct current(DC)electrodeposition method and thermal oxidati...