基于网络处理器应用中网包保序机制研究

网包保序是高层协议对网络设备的严格要求。网络处理器（NP）中广泛采用的并行处理架构对保序机制的实现提出了新的挑战。通过理论分析比较了临界区轮询（CSRR）和线程池（POTS）两种保序模型在NP体系结构下的性能,提出在实际网络环境中POTS性能更优。在NP的代表性设计Intel IXP2400上的实测表明,POTS比CSRR性能高1.7％-102%。     

A novel triple notch‐bands ultra wide‐band band‐pass filters using parallel multi‐mode resonators and CSRRs

This article discusses a technique based on combination of multimode resonators (MMR) and complementary split ring resonators (CSRR) to design multi notch‐bands ultra wide‐band (UWB) band‐pass filters (BPF). The proposed structure consists of two parallel multimode resonators, resulting in a dual notch‐band UWB BPF, integrated with a single cell of CSRR to realize the third notch‐band. The mechanism of realizing the notch‐bands is mathematically presented and a triple notch‐bands UWB BPF is designed, simulated and fabricated. The overall size of the proposed filter is reported to be around 36 × 7.7 mm² where a size reduction of around 35% is demonstrated in comparison to the conventional filter. © 2013 Wiley Periodicals, Inc. Int J RF and Microwave CAE 24:375–381, 2014.     

CSRR based folded monopole tri‐band antenna array and its system level evaluation

In this article, a folded monopole antenna loaded with complementary split ring resonators (CSRRs) is proposed for tri‐band applications. The two bands of the antenna are generated by the folding of the monopole (first band is caused due to fundamental mode and another due to higher order mode) and CSRRs have been responsible for the third band. By using four such antennas in form of an array, the gain and bandwidth have been improved. The prototype of the antenna array is developed on FR4 substrate and simulated results are experimentally validated. A simplified equivalent circuit model of the antenna has been developed and analyzed to quantify the power loss due to input impedance mismatch at each resonance frequency. By using the EM model of the proposed antenna in the Keysight ADS verification test bench its suitability to operate in the system environment has been confirmed.     

多口三环CSRR微带低通滤波器的研究与设计

提出一种新型的多口三环CSRR结构,利用CSRR谐振器的单极点低通特性和环与微带线之间的耦合,构成低通滤波器.分析该结构的等效电路模式,指出谐振频率的计算公式.使用HFSS适当优化参数,可以得到性能良好的低通滤波器.其-3 dB截止频率8.76 GHz,通带内插入损耗小于0.3306 dB,通带内回波损耗小于-13.810 2 dB,衰减15 dB以上阻带带宽达到10.31 GHz.为了改善通带内的回波损耗,在微带线两侧加载并联开路枝节.其-3 dB截止频率8.385 GHz,通带内插入损耗小于0.174 7 dB,通带内回波损耗小于-19.707 7 dB,衰减15 dB以上阻带带宽达到10.7 GHz.     

Novel configuration of ultra‐wide band uni‐planar configuration of complementary split ring resonator composite right/left‐handed based band pass filter with sharp roll off and good stopband attenuation

In this paper, a compact novel simple design of ultra‐wide bandpass filter with high out of band attenuation is presented. The filter configuration is based on combining an ultra‐wide band composite right/left‐handed (CRLH) band pass filter (BPF) with simple uni‐planar configuration of complementary split ring resonator (UP‐CSRR). By integrating two UP‐CSRR cells, the ultra‐wideband CRLH filter roll‐off and wide stopband attenuation are enhanced. The filter has 3 dB cutoff frequencies at 3.1 GHz and 10.6 GHz with insertion loss equals 0.7 dB in average and minimum and maximum values of 0.48 dB and 1.05 dB, respectively over the filter passband. Within the passband. The transition band attenuation from 3 dB to 20 dB is achieved within the frequency band 1.9 GHz to 3.1 GHz (48%) at lower cutoff and the frequency band 10.6 GHz to 11.4 GHz (7%) at upper stopband. Moreover, the filter has a wide stopband attenuation >20 dB in frequencies 11 GHz to 13.6 GHz (21%) and ends with 3 dB cutoff frequency at 14.8 GHz. Furthermore, the designed filter size is very compact (23 × 12 mm²) whose length is only about 0.17 λ_g at 6.85 GHz. The filter performance is examined using circuit modeling, full‐wave simulations, and experimental measurements with good matching between all of them.     

倾斜波束圆极化天线的CSRR-FS结构设计研究

为了拓展倾斜波束圆极化天线(Circularly Polarized Antenna with Tilted Beam,CPA-TB)的带宽,在分析了该天线结构及其特征的基础上,提出了一种花纹式螺旋臂(Flower-Spiral,FS)协同互补开口谐振环(complementary split ring resontor,CSRR)的CSRR-FS结构.该结构通过FS增加了天线表面电流路径,实现了天线驻波比(voltage standing wave ratio,VSWR)的拓展;利用CSRR改变了低频点反射板的电流分布,实现反射板小型化的同时,减小了天线的交叉极化分量,增强了天线的辐射性能,拓展了天线的轴比带宽.仿真和实测结果表明:与普通的平面反射板相比,在保证圆极化、波束倾角30°的条件下,基于CSRR-FS结构的CPA-TB相对带宽为24%(5.5-7GHz),天线工作带宽拓展了1.8倍.CSRR-FS结构的提出为CPA-TB带宽的拓展提供了新的途径.     

Compact four‐port MIMO antenna on slotted‐edge substrate with dual‐band rejection characteristics

A compact ultra‐wideband (UWB) multiple‐input‐multiple‐output (MIMO) antenna with dual band elimination characteristics is presented. The proposed MIMO antenna is comprised of four identical elliptical shaped monopole radiators located orthogonally to each other. A second order Koch fractal geometry is applied on the edges of the ground planes of the radiating elements; to reduce the overall size of the MIMO antenna, without compromising the lower frequency response. Further, in order to eliminate the undesired resonant bands (3.5 and 5.5 GHz) from UWB, an elliptical complementary split ring resonator is introduced in the monopole radiator. For reducing inter‐element coupling in the proposed MIMO antenna, a different approach (of slotted edge substrate) is used, as a substitute of traditional decoupling stub/elements. In the entire operating band of 3 to 13.5 GHz, inter‐element isolation more than 22 dB and envelope correlation coefficient less than 0.008 are obtained. The measured parameters of the fabricated prototype antenna are found in good agreement with the simulated results.     

Band‐pass filter design using modified CSRR‐DGS

In this article, a novel compact band‐pass filter (BPF) with sharp cutoffs and a wide stop‐band is presented. The BPF is basically designed by cutting a modified complementary split‐ring resonator (CSRR) from the ground of two separated microstrip feed lines and has a 71% fractional bandwidth from 4.1 to 9 GHz. Because of the high insertion loss, the designed filter should be packed in a metallic cavity that has undesirable resonances in the stop‐band of the BPF. For eliminating cavity resonances, an evolutionary optimization technique based on changing the pixels of the CSRR defected ground structure is used. A prototype of the final structure obtained from the optimization technique is fabricated. The measurement results show that the optimized filter have a pass band from 4 to 8 GHz with a rejection better than 15 dB from 4 to 15 GHz. The designed filters have compact dimensions of 12 × 12 × 0.787 mm³. © 2014 Wiley Periodicals, Inc. Int J RF and Microwave CAE 24:544–548, 2014.     

A new design of substrate integrated waveguide diplexer using complementary split ring resonators

Design method for achieving the acceptable electrical responses (isolation and impedance matching) of a mixer in two‐close frequency with substrate integrated waveguide (SIW) is presented. SIW diplexer with complementary split ring resonators and an open stub is proposed. The SIW loaded diplexer is operated below the cutoff frequency of the equivalent waveguide for SIW; therefore, the size of the structure is compacted. Input and output ports matching are realized in the light of open microstrip stub. The diplexer with optimum dimensions is designed and fabricated. The measurement results verified the design procedures. They also show that operation frequencies are very close together, and also the proposed structure is suitable for long term evolution frequency bands.     

基于非谐振节点的盒型拓扑结构基片集成波导滤波器设计

针对微波带通滤波器小型化、高性能的应用需求,提出使用单模和双模基片集成波导谐振器相结合设计广义切比雪夫带通滤波器.该结构可实现盒型拓扑结构,并且双模基片集成波导谐振器中的主模TE₁₀₁作为非谐振节点提供一条额外的交叉耦合路径,并能增加一个有限的传输零点;该结构不需要传统负耦合结构就能实现两个有限传输零点,并且该传输零点可以位于通带上方或下方,具有设计灵活的特点.为了进一步提高滤波器的选择性,研究了在四阶滤波器上蚀刻互补开环谐振器设计拓展的盒型拓扑结构滤波器,并实现五阶滤波功能三个有限传输零点.为了验证结构的合理性,设计了两款中心频率为10GHz的对称和非对称响应的四阶滤波器、一款中心频率为5.8GHz的五阶滤波器,并给出相应的含非谐振节点的盒型拓扑结构耦合矩阵进行验证,最后进行加工和测试.耦合矩阵响应、仿真和测试结果一致性较好,表明了该结构设计高性能滤波器的可行性.