一种新型硫酸亚铁单液法调剖剂

本文提出用尿素作为ｐⅡ调节剂，加快硫酸亚铁单液法调剖剂中亚铁离子在地层温度下的沉淀，增大沉淀率，提高封堵效能。岩芯流动试验结果表明，１５％ＦｅＳＯ４．７ＩＩ ２Ｏ／５％尿素调剖剂体系的封堵能力比不含尿素的体系增大近一倍。     

尿素合成塔检测技术

综述了尿素合成塔在使用过程中可能出现的腐蚀和缺陷形态,并根据失效的可能性给出了有效的检测方法,包括宏观检查、厚度检测、磁粉检测、渗透检测、硬度检测、声发射检测、金相检查和金属磁记忆检测等技术.分别介绍了这些无损检测方法的特点,以及如何在尿素合成塔检验中进行实施.     

尿素合成塔腐蚀情况及原因分析

针对尿素合成塔的腐蚀问题,详细介绍了从投产使用到现在该设备的腐蚀现状.并从不同角度进行详细分析,提出了解决问题的办法及日常运行中应注意的问题.     

Molecular association complex of urea with polyethylene: 3. Structural studies of the complex

The crystal structure of urea-polyethylene complex in the hexagonal form, obtained by one of our preparation methods, is analysed by X-ray power diffractometry. In this analysis, the fixed molecular parameters of urea are used, and three models with respect to rotational disorder of the guest polyethylene molecule are assumed. It is shown that the host lattice structure constructed by urea molecules is essentially the same as that of urea-n-paraffin complex. Effects of the disorder structure of the guest on X-ray scattering of the complex are presented. However, there is a difficulty in identifying the disorder structure by X-ray analysis. With the aid of a potential energy calculation between the hexagonal urea tunnel and the guest molecule, a rotational disorder model is preferred.     

The influence of soil properties on the effectiveness of phenylphosphorodiamidate (PPD) in reducing ammonia volatilization from surface applied urea

Urea can be an inefficient N source due to rapid hydrolysis by soil urease leading to NH₃ volatilization. The current study investigated the effect of the urease inhibitor phenylphosphorodiamidate (PPD) incorporated at two concentrations (0.5% and 1% w/w) within the fertilizer granule on NH₃ volatilization from surface applied urea. The daily rates of NH₃ loss from 20 soils of widely differing properties from Northern Ireland were measured over 14 days using ventilated enclosures under simulated spring conditions. Cumulative loss rates were calculated and fitted to a logistic model from which total NH₃ loss (Amax) and the time to maximum rate of loss (Tmax) were determined. Stepwise multiple linear regression analysis related the effectiveness of PPD in reducing NH₃ volatilization from urea to soil properties.The total cumulative loss of ammonia from unamended urea varied from 0.37 to 29.2% depending on soil type. Ammonia volatilization appeared to be greatest on a soil with a high pH (R² = 0.65), a low titratable acidity (TA) (R² = 0.63) and a soil that was drying out (R² = 0.50). Soil pH was negatively correlated with TA (r = –0.826, P < 0.001) suggesting that soils with a low TA may have received recent lime. Including cation exchange capacity (CEC) and % N as well as pH-KCl in the multiple linear regression equation explained 86% of the variance.The effectiveness of PPD in reducing Amax varied between 0% to 91% depending on soil type, the average over all 20 soils being 30 and 36% for 0.5% and 1% PPD respectively. The most important soil properties influencing the effectiveness of the urease inhibitor were soil pH-H₂O and TA accounting for 33% and 29% of the variance respectively. PPD was less effective on a soil with a high pH and low TA. These were the soil conditions that led to high NH₃ volatilization from unamended urea and may explain why PPD had limited success in reducing ammonia loss on these soils. Multiple linear regression analysis indicated that 75% of the variation in the % inhibition of NH₃ loss by PPD could be significantly accounted for by pH-H₂O, initial soil NO ₃ ^- -N concentration, % moisture content and % moisture loss.The delay in Tmax by PPD ranged from 0.19 to 7.93 days, the average over all 20 soils being 2.5 and 2.8 days for 0.5% and 1% PPD respectively. TA, % moisture content, urease activity and CEC were soil properties that significantly explained 83% of the variation in the % delay in Tmax by PPD in multiple linear regression analysis. However, none of these soil properties were significant on their own. As urea hydrolysis occurs rapidly in soil, delaying Tmax under field conditions would increase the chance of rain falling to move the urea below the soil surface and reduce NH₃ volatilization. A urease inhibitor should be more effective than PPD on soils with a high pH and low TA to be successful in reducing high NH₃ losses.     

机械松衬尿素合成塔衬里的修复

机械松衬尿素合成塔衬里的修复白玲，唐联生，向均，江伟（成都化肥厂）关键词尿素合成塔，衬里，检修成都化肥厂尿素合成塔如图１所示，外筒采用多层１５ＭｎＶｇＣ板包扎而成，总厚度８８ｍｍ，衬里是机械松衬６ｍｍ厚０Ｃｒ１７Ｍｎ１３Ｍｏ２Ｎ钢板，现在已使用１０年...     

尿素改性热塑性酚醛树脂的合成及应用

先用尿素、甲醛合成二羟甲脲，然后在酸性介质下把二羟甲脲滴加在苯酚中反应合成尿素改性的热塑性酚醛树脂。研究了反应浑浊点和二羟甲脲的滴加速度，同时研究了二羟甲脲与苯酚的尿酚比与物料的出料温度、产品产率及树脂理化性能指标的关系。结果表明：（1）二羟甲脲滴加速度的合适范围是0．012－0．029mol/mol.min；（2）本树脂的出料温度为125℃以下；（3）产品收率，游离酚，软化点随尿比的增长而递增，凝胶速度变化不大。另介绍了这种树脂在酚醛模塑料中的应用。     

耐水性木材用脲醛粘合剂的研究

研究了改进胶合板用脲醛粘合剂的耐水性的方法。针对脲醛粘合剂耐水性低的原因,提出在胶液中添加碱性物质——耐水添加剂,可显著改善胶合板的耐水性,几种添加剂并用,胶合板可达一级耐水板的水平。     

尿液喷浆造粒--生产复合肥的一种新工艺

介绍了在团粒法工艺的基础上，用尿素熔融尿液或尿素车间二段蒸发器的尿液进行喷浆造粒生产复合肥的改造方案、改造内容、改造效果和投资情况。     

Surface chemistry and kinetics of the hydrolysis of isocyanic acid on anatase

In order to meet the stricter NO_x and particulate emission limits for commercial vehicles, the selective catalytic reduction (SCR) with urea is currently seen having the highest potential. The conversion of urea into ammonia and carbon dioxide consists of two consecutive reactions, in which isocyanic acid is an intermediate that is hydrolyzed over TiO₂. The intrinsic kinetics and the surface chemistry for this reaction are explored. Up to a temperature of 132 °C the reaction was in the intrinsic kinetic regime (E_A = 73 kJ/mol), while at higher temperatures the reaction was limited by pore and external diffusion constraints, respectively. In the presence of NO, NH₃ and NO₂, the catalytic activity was negatively influenced, increasing in severity in the sequence mentioned indicating that nitrates formed from NO₂ were most effective in blocking cations and anions of TiO₂. IR spectroscopy indicates that dissociative adsorption of HNCO on TiO₂ forms Ti–NCO and hydrogen bonded OH species. In the presence of water, isocyanic acid was so rapidly hydrolyzed that only adsorbed ammonia was observed on the catalyst surface. The presence of NO, NH₃ and NO₂ retards hydrolysis leading to the appearance of isocyanate species on the surface.