不同种植密度对机采辣椒品种性状和产量的影响

为明确不同种植密度对机采辣椒品种性状、产量的影响,以适宜机采的辣椒‘辣研102’为研究对象,设置4个种植密度（P0:38 480株/hm²、P1:51 307株/hm²、P2:76 961株/hm²、P3:102 615株/hm²）,分别于贵阳、遵义两地开展田间小区试验。结果表明,随着种植密度的增加,辣椒株高呈增加趋势,茎粗呈下降趋势。辣椒根部、地上部生物量均在高密植条件下（P3）时达到最小。辣椒的发病率与病情指数均随种植密度的增加而显著提高,高密植处理条件下（P3）达到最大,发病率分别为41.67%（贵阳）、43.33%（遵义）,病情指数分别为31.05%（贵阳）、29.86%（遵义）。过高的种植密度导致单株辣椒光合作用大幅下降:P1、P2、P3处理条件下光合速率分别较P0处理显著降低13.94%、24.73%、29.66%（遵义）;P1、P2、P3处理条件下辣椒叶片蒸腾速率较P0降低10.02%、19.81%、42.12%（贵阳）。辣椒总产量随种植密度增加而显著提高,而商品果产量随种植密度的增加呈先增加后降低的趋势。商品果产量在P1条件下获得最大值,相对于P0、P2、P3贵阳辣椒商品果产量显著提高了16.43%、32.81%、41.67%,遵义提高了20.25%、26.67%、61.02%。综合辣椒生长与商品果产量,贵州机采辣椒‘辣研102’最佳种植密度为51307株/hm²。     

不同阶段猪用颗粒饲料物理性能的对比分析

对某饲料厂不同阶段猪用4种颗粒饲料的物理性能包括直径、长度、硬度、容重、含粉率和耐久性指数（Pellet Durability Index, PDI）等进行测定,对结果进行归类总结并采用统计学的方法参照有关标准进行分析。结果表明,4种颗粒饲料直径在2.87~3.94 mm之间,母猪料直径最大,小猪料最小,两两之间差异显著（P<0.05）,而且随着猪只年龄的增加,颗粒饲料的直径呈递增趋势。颗粒长度在8.62~11.94 mm之间,以大猪料最长,小猪料最短,长径比偏高。颗粒硬度在3.86~6.47 kg之间,以大猪料最大,小猪料最小,中小猪料显著低于大猪料和母猪料（P<0.05）,只有小猪料符合有关要求。颗粒容重在576.7~614.6 g/L之间,母猪料最大,小猪料最小,两两之间差异显著（P<0.05）,与直径呈相同的增减趋势。含粉率以小猪料最大,且只有小猪料与大猪料之间差异显著（P<0.05）。颗粒PDI以大猪料最大,小猪料最小,各阶段猪料的含粉率和PDI均符合有关要求。建议饲料厂家注重颗粒饲料物理性能指标的控制,调整饲料配方和工艺参数,不断改进颗粒饲料的质量。     

不同行距配比对玉米光合生理指标及茎秆特性的影响

以‘大丰30’为试验材料,在同一密度下（75000株/hm²）设置5种不同行距配比,研究不同行距配比对玉米光合生理指标及茎秆力学特性的影响。结果表明：行距配比为40 cm×80 cm时,棒三叶的叶绿素含量(SPAD)在灌浆期达到峰值;行距配比为30 cm×90 cm时,棒三叶净光合速率在灌浆期最高。大口期开始,行距配比为40 cm×80 cm时,叶面积指数(LAI)最高。单株干物质积累量以40 cm×80 cm最高。各行距配比的茎秆硬皮穿刺强度与茎秆弯曲性能随着节位的下降均呈逐渐增强的趋势,从大到小为 40 cm×80 cm>50 cm×70 cm>30 cm×90 cm>60 cm×60 cm>20 cm×100 cm。穗长、穗粗、千粒重和穗粒数各处理间均有不同变化,行距配比为40 cm×80 cm时产量最高,比等行距60 cm×60 cm增产7.96%。由此可见,行距配比为40 cm×80 cm,有利于大穗型品种‘大丰30’的光合性能和茎秆强度的提高,从而达到抗倒伏增产的目的。     

动物饲料国际贸易、养殖密度与环境氮磷平衡的关系

粮食和饲料的国际贸易促进了许多国家农业生产系统的专业化和集约化。专业化动物养殖越来越多地依赖进口大豆和玉米,虽然提高了动物生产力,但也促使作物和动物生产系统在空间上的分离。本文综述了几十年来全球范围内大豆和玉米的贸易变化,并将其与养殖密度和整个食品系统中营养平衡的变化联系起来。这一变化与不同的营养管理条例的差异和动物饲养密度的空间变化有关。深入解析这些变化有助于理解动物饲料国际贸易、养殖密度与氮磷平衡之间的复杂关系。     

施氮水平对7S亚基缺失大豆根系形态和结瘤固氮的影响

为有效推广功能型大豆7S亚基缺失品种,以7S亚基缺失大豆品系东富2号为研究对象,设置4种施氮水平(纯N),N0(0 mg·kg~(-1))、N1(25 mg·kg~(-1))、N2(50 mg·kg~(-1))、N3(75 mg·kg~(-1)),采用桶栽法研究大豆根系形态和结瘤固氮对不同施氮水平的响应。结果表明:N1(25 mg·kg~(-1))水平下根系干重加大,根冠比增大,根瘤固氮潜力高,单株产量较高。N2(50 mg·kg~(-1))水平下根长、根表面积、根体积在生育后期增长较快,根系干重较大,根冠比低,固氮酶活性最高,单株籽粒产量最高。N3(75 mg·kg~(-1))水平下植株干重较大,无效生长较多,根瘤数少,固氮潜力和根冠比低,单株产量不高。综合籽粒产量和根系特性指标,功能型大豆7S亚基缺失品系东富2号的适宜施肥量为25~50 mg·kg~(-1)。     

栽植密度对不同种源芡实生长的影响

对不同栽植密度条件下,不同种源地芡实的生长情况进行了调查研究,结果表明:不同栽植密度间芡实的叶均直径、叶最大直径、果径、果长、果质量、粒数、粒质量均无明显差异,不同栽植密度间产量存在差异;不同种源地间8项物理性状指标均无明显差异;除果长与栽植密度的交互作用对产量无影响外,其余6种性状与栽植密度的交互作用均存在差异,表明交互作用对产量有影响。7种性状与种源地的交互作用下,种源地与产量间的关联不大。     

青霉菌发酵液对大豆幼苗生长及生理特性的影响

采用室内生理检测及生物化学方法,研究了青霉菌发酵液对大豆幼苗生长及生理特性的影响。结果表明:用一定浓度的青霉菌发酵液对大豆浸种和茎叶处理,大豆幼苗的生长呈明显上升趋势,处理后大豆的株高、根长、株鲜重和根鲜重均明显得到了提高,且生长状态好于对照,不同浓度处理间具有明显差异,在发酵液浓度为5 g·L-1时,效果最佳。尤其是对根鲜重的影响,促进率最高可达56.21%,同时增强了幼苗根系活力,最大可以提高57.82%,浸种和茎叶处理后,分别提高了叶绿素含量41.25%和15.40%;超氧化物歧化酶活性12.20%和11.70%;过氧化物酶31.33%和29.95%;过氧化氢酶活性42.8%和20.0%,这为发酵液在大豆田推广应用、提高大豆产量提供了重要理论依据。     

Compatibility of root growth and tuber production of potato cultivars with dynamic and static water‐saving irrigation managements

The important root characteristics of root length density (RLD) and root mass density (RMD) generally differ among irrigation managements and potato cultivars. The objective of this study was to investigate the RLD and RMD variations and their functional relationships with gross potato tuber yield for two commercial potato cultivars, Agria and Sante, under different irrigation strategies. Full irrigation and water‐saving irrigation strategies, deficit and partial root drying irrigations, were applied statically (S) and dynamically (D) based on daily crop evapotranspiration. Results showed that SPRD had significantly greater RLD (3.64 cm/cm³) and RMD (132.7 μg/cm³) than other irrigation treatments. Between the potato cultivars, Agria had significantly larger values of RLD (3.50 cm/cm³) and RMD (138.7 μg/cm³) than Sante. The functional relationship between the root growth characteristics and tuber yield showed that under water‐saving irrigations, Agria increased root mass at the expense of gross tuber yield but Sante increased root mass to maintain larger gross tuber yields. However, Agria produced more roots and gross tuber yield than Sante, and it is concluded that Agria is a more drought‐tolerant potato cultivar, which is recommended for tuber production in regions where water might be scarce. It was shown that larger root production in potatoes was associated with improved tolerance to water stress.     

Establishing an eyeball-weight relationship for Litopenaeus vannamei using machine vision technology

This study aimed to establish a shrimp eyeball-weight relationship model for Litopenaeus vannamei using machine vision technology. A total of 295 shrimp were sampled from a recirculating aquaculture system (RAS). The long-axis length (d), body length (L), and body weight (W) of each individual was measured. The long axis length of the shrimp eyeball was identified and measured using machine vision technology. Continuous fitting and piecewise fitting models were used to construct the eyeball-weight relationship model for L. vannamei. The continuous fitting relationship model was described as: W = 38.865d^2.7914, while the piecewise model was described as: d < 2 mm, W = 0.0326d^3.7363, R² = 0.9288; 2 mm ≤ d < 3.9 mm, W = 0.0401d^3.104, R² = 0.9629; 3.9 mm ≤ d < 5.8 mm, W = 0.0421d^3.0311, R² = 0.9216; 5.8 mm < d, W = 0.103d^2.6226, R² = 0.9457. The root mean square error (RMSE) of the piecewise fitting model (0.0244, 0.1575, 0.5034, 0.7072) was smaller than the continuous fitting model (0.8229). The correlation coefficient (R²) of the piecewise model (0.9288, 0.9629, 0.9216, and 0.9457) was similar to that of the continuous fitting model (R² = 0.9621). The results indicated that the piecewise fitting model is suitable for calculating the biomass of L. vannamei in RAS and provides a novel way of estimating the biomass of L. vannamei cultured in RAS. The piecewise fitting model can also provide the foundation of evaluating the production of shrimp using underwater image recognition in intelligent aquaculture systems.