光稳定剂对木粉/回收聚乙烯复合材料老化性能的影响

选用了6种光稳定剂,通过分析老化前后添加不同光稳定剂的木塑复合材料性能变化,考察了常用光稳定剂品种对于木塑复合材料抗老化性能的影响。结果表明：光稳定剂能够有效增加WPC的抗老化能力,减少老化过程导致的力学性能下降;光稳定剂品种对于老化过程WPC静曲强度下降的影响有明显差异,位阻胺类与二苯甲酮类优于苯并三唑类;光稳定剂品种对于老化过程WPC吸水率的增加有明显差异,位阻胺类最优,二苯甲酮类次之,苯并三唑类最差;光稳定剂品种对于老化前后WPC色差的影响没有明显差别。     

焦化场地PAHs污染土壤的电动-化学氧化联合修复

焦化场地土壤多环芳烃(PAHs)污染严重,目前的修复技术都存在不同程度的弊端。通过研究化学氧化、电动及其联合技术对焦化场地高浓度多环芳烃污染土壤的修复效果,比较了两种技术组合方式对修复效果的影响。结果表明,单一技术及联合技术对焦化场地PAHs均有一定的去除效果。在单一技术处理中,电动处理、芬顿和活化过硫酸钠对多环芳烃的去除率分别为24.86%、10.27%和22.19%;在联合技术处理中,活化过硫酸钠-电动组合、电动-活化过硫酸钠组合、芬顿-电动组合和电动-芬顿组合对多环芳烃的去除率分别为49.65%、41.73%、36.72%和31.39%。电动-化学氧化联合技术对PAHs的去除效果较单一技术提高了6.53%~27.46%。两种技术的组合方式及氧化剂类型均对联合处理效果产生影响,化学氧化-电动处理的多环芳烃去除率较电动-化学氧化处理高5.33%~7.92%,其差异主要由化学氧化去除率差异所引起;应用活化过硫酸钠试剂的组合对多环芳烃的去除率高出应用芬顿试剂的组合12.93%~10.34%。经联合处理后,污染物的残留量及毒性当量浓度均有不同程度降低,说明电动-化学氧化联合技术是一种有效的预处理方法。     

More evidence that anaerobic oxidation of methane is prevalent in soils: Is it time to upgrade our biogeochemical models?

Estimating future fluxes of CH₄ between land and atmosphere requires well-conceived process-based biogeochemical models. Current models do not represent the anaerobic oxidation of methane (AOM) in land surface soils, in spite of increasing evidence that this process is widespread. Our objective was to determine whether AOM, or potential AOM, commonly occurs in 20 hydromorphic soils spanning a wide range of chemical properties. Bulk soil samples were collected under shallow water near the shoreline of 15 recently drained fish ponds in southern Bohemia (Czech Republic), as well as from below the water table at 3 peatland locations in northeast Scotland and 2 acid sulfate soils on the southern coast of Finland. Each soil slurry was incubated under both oxic and anoxic conditions, with or without the addition of alternative electron acceptors (SO₄²⁻ and NO₃⁻) or H₂PO₄⁻. Here, “oxic” and “anoxic” conditions refer to anoxic soil respectively incubated in a headspace containing air or argon. Using the isotope dilution method, we determined the gross production and oxidation rates of CH₄ after 2 days incubation under oxic headspace conditions, and after 2, 21 and 60 days incubation under anoxic conditions. Large differences in net CH₄ fluxes were observed between soil types and between incubation conditions. AOM was detected in each of the 20 bulk soil samples, which spanned >6 pH units and 2 orders of magnitude in organic C content. Significant positive relationships were found between AOM and gross CH₄ production rates under anoxic conditions, resulting in AOM rates that were sometimes higher than CH₄ oxidation rates under oxic headspace conditions. There was no relationship between net and gross CH₄ production rates, such that 2 soil types could display similar low net rates, yet conceal very large differences in gross rates. The effects of alternative electron acceptors on AOM were idiosyncratic and resulted in no net trend. We did find, however, a negative effect of SO₄²⁻ and H₂PO₄⁻ on gross CH₄ production rates under anoxic and oxic conditions respectively. Under oxic headspace conditions, CH₄ oxidation was related to soil organic C content. Taken collectively, our results suggest that AOM, or potential AOM, is prevalent over a wide range of soil types, that AOM may contribute substantially to CH₄ oxidation in soils, and that AOM in soils should be integrated to current process-based CH₄ cycling models.     

Black carbon estimation in French calcareous soils using chemo‐thermal oxidation method

We studied the black carbon (BC) content of ca. 405 samples from French topsoil and artificial soil and carbonate mixtures. Our protocol involved three main steps: (i) decarbonation by HCl, (ii) elimination of non‐pyrogenic organic carbon in a furnace at 375 °C, and (iii) quantification of residual carbon by CHN analysis. BC content increased for calcareous soils according to their carbonates content. Subsequent analyses confirmed the existence of a methodological artefact for BC determination only in calcareous soils. Decarbonation changes the thermal properties of organic matter, creating more recalcitrant carbon than in the initial sample. Higher CaCO₃ and organic carbon content results in a more pronounced artefact. The reversal of the first two steps of the chemo‐thermal oxidation method (i.e. thermal oxidation before soil decarbonation) eliminates this artefact. Overall, our results suggest that BC content may have been overestimated in a large number of studies on calcareous soils.     

Contributions of ammonia-oxidizing archaea and bacteria to nitrification in Oregon forest soils

Ammonia oxidation, the first step of nitrification, is mediated by both ammonia-oxidizing archaea (AOA) and bacteria (AOB); however, the relative contributions of AOA and AOB to soil nitrification are not well understood. In this study we used 1-octyne to discriminate between AOA- and AOB-supported nitrification determined both in soil-water slurries and in unsaturated whole soil at field moisture. Soils were collected from stands of red alder (Alnus rubra Bong.) and Douglas-fir (Pseudotsuga menziesii Mirb. Franco) at three sites (Cascade Head, the H.J. Andrews, and McDonald Forest) on acidic soils (pH 3.9–5.7) in Oregon, USA. The abundances of AOA and AOB were measured using quantitative PCR by targeting the amoA gene, which encodes subunit A of ammonia monooxygenase. Total and AOA-specific (octyne-resistant) nitrification activities in soil slurries were significantly higher at Cascade Head (the most acidic soils, pH < 5) than at either the H.J. Andrews or McDonald Forest, and greater in red alder compared with Douglas-fir soils. The fraction of octyne-resistant nitrification varied among sites (21–74%) and was highest at Cascade Head than at the other two locations. Net nitrification rates of whole soil without NH₄⁺ amendment ranged from 0.4 to 3.3 mg N kg⁻¹ soil d⁻¹. Overall, net nitrification rates of whole soil were stimulated 2- to 8-fold by addition of 140 mg NH₄⁺-N kg⁻¹ soil; this was significant for red alder at Cascade Head and the H.J. Andrews. Red alder at Cascade Head was unique in that the majority of NH₄⁺-stimulated nitrifying activity was octyne-resistant (73%). At all other sites, NH₄⁺-stimulated nitrification was octyne-sensitive (68–90%). The octyne-sensitive activity—presumably AOB—was affected more by soil pH whereas the octyne-resistant (AOA) activity was more strongly related to N availability.     

绿色环保型循环冷却水处理技术

分析了当前绿色环保的循环冷却水的处理工艺、现状、机理和应用情况，指出了绿色环保型循环冷却水的重要性，以期引起业内的重视并提供参考。     

微波辐射法竹浆纤维素的中性TEMPO氧化及表征

采用微波辐射法和中性2,2,6,6-四甲基哌啶-1-氧化物(TEMPO)自由基氧化工艺来预处理竹浆纤维素,之后用超声波机械处理制备微纤化纤维素。实验结果表明,在60℃下,TEMPO用量为0.15 mmol/g(以绝干浆计,下同),Na Cl O2用量为10 mmol/g,Na Cl O用量为1 mmol/g,微波氧化2 h,其羧基含量最高到达0.729 mmol/g,氧化效果最佳,超声波处理后微纤化纤维素得率高达85.7%。FT-IR分析表明纤维素氧化后引入羧基官能团;XRD结果揭示纤维素氧化反应只发生在纤维素的无定型区或结晶区表面;纤维素氧化前后的聚合度(Dp)结果表明相对于碱性氧化,微波辐射和中性TEMPO氧化对纤维的降解程度低,从而有效地保持了纤维素原本的长度。     

二氧化碳基塑料降解性能的研究

[目的]研究二氧化碳基塑料的降解性能.[方法]以PPC为原料,通过生物降解、热氧化降解和光降解研究了PPC的降解性能.利用乌式粘度计测定了降解过程中PPC塑料的分子量变化;利用傅里叶变换红外光谱仪表征了降解过程中PPC的红外光谱特性.[结果]PPC薄膜在27℃恒温培养箱中生物降解15 d后,降解效果明显.180℃热氧化降解36 h,PPC塑料的分子量减少了63％.光氧化降解5d后,PPC塑料的分子量减少了约85％.[结论]与生物降解相比,PPC塑料的热氧化和光降解程度更为明显.