Plasma-assisted CO2 reforming of methane over Ni-based catalysts: Promoting role of Ag and Sn secondary metals

Carbon dioxide (CO₂) and methane (CH₄) are the primary greenhouse gases (GHGs) that drive global climate change. CO₂ reforming of CH₄ or dry reforming of CH₄ (DRM) is used for the simultaneous conversion of CO₂ and CH₄ into syngas and higher hydrocarbons. In this study, DRM was investigated using Ag–Ni/Al₂O₃ packing and Sn–Ni/Al₂O₃ packing in a parallel plate dielectric barrier discharge (DBD) reactor. The performance of the DBD reactor was significantly enhanced when applying Ag–Ni/Al₂O₃ and Sn–Ni/Al₂O₃ due to the relatively high electrical conductivity of Ag and Sn as well as their anti-coke performances. Using Ag–Ni/Al₂O₃ consisting of 1.5 wt% Ag and 5 wt% Ni/Al₂O₃ as the catalyst in the DBD reactor, 19% CH₄ conversion, 21% CO₂ conversion, 60% H₂ selectivity, 81% CO selectivity, energy efficiency of 7.9% and 0.74% (by mole) coke formation were achieved. In addition, using Sn–Ni/Al₂O₃, consisting of 0.5 wt% Sn and 5 wt% Ni/Al₂O₃, 15% CH₄ conversion, 19% CO₂ conversion, 64% H₂ selectivity, 70% CO selectivity, energy efficiency of 6.0%, and 2.1% (by mole) coke formation were achieved. Sn enhanced the reactant conversions and energy efficiency, and resulted in a reduction in coke formation; these results are comparable to that achieved when using the noble metal Ag. The decrease in the formation of coke could be correlated to the increase in the CO selectivity of the catalyst. Good dispersion of the secondary metals on Ni was found to be an important factor for the observed increases in the catalyst surface area and catalytic activities. Furthermore, the stability of the catalytic reactions was investigated for 1800 min over the 0.5 wt% Ag-5 wt% Ni/Al₂O₃ and 0.5 wt% Sn-5 wt% Ni/Al₂O₃ catalysts. The results showed an increase in the reactant conversions with an increase in the reaction time.     

Effect of nickel concentration on biohydrogen production: Organic solid waste vs. glucose

In recent years, alternative renewable energy generation sources have been investigated, highlighting the dark fermentation process due to it’s potential to obtain hydrogen-rich gas, which can be used as an energy source. Different trace metals intervene in this biological process. Nickel is one of the most important because it is a component of the [Ni–Fe] hydrogenase enzyme that catalyzes the oxidation of H₂ in numerous bacteria. The aim of this study was to evaluate the effect of nickel on biohydrogen production from organic solid waste (OSW). The experimental setup was carried out in batch tests using OSW as the substrate, glucose as a reference compound and the valuation of Ni²⁺ doses on the operation in a Sequencing Batch Reactor. The results of the batch tests showed that when using glucose as a substrate, 2 mg Ni²⁺/g VS_inoculum generated the highest hydrogen production (774 ± 7.3 mL H₂/L/d) and highest yield (55.8 ± 3.4 mL H₂/g of glucose), which was 34.4% higher than the control. Testing of different concentrations of nickel using OSW as a carbon source showed that the highest production was obtained without Ni²⁺ addition since the nickel concentration in the residue was 0.17 ± 0.06 mgNi/gVS; consequently, hydrogen production was not affected by the lack of Ni. The addition of 0.5 mg Ni²⁺/g VS_inoculum decreased acetate and butyrate production and increased caproate production.     

异种铁素体耐热钢接头界面组织及其影响

综述了铁素体与铁素体异种金属焊缝（dissimilar metal welds，DMWs）接头界面组织及其影响。结果表明，在焊后热处理或运行温度下的铁素体钢DMWs接头的不均匀界面组织中，通常会形成脱碳层和增碳层。在铁素体钢DMWs焊接接头界面组织影响因素中，焊缝金属的化学成分有重要影响；焊后热处理规范（温度和时间）、工作温度下运行时间的影响较为突出；焊接工艺参数的影响亦不可忽略。异种钢接头界面处近缝区裂纹的产生，以及接头的蠕变强度随Larson Miller 参数增大而下降等不利影响，均为异种钢界面碳迁移行为所导致。焊缝成分控制法是接头界面组织控制或改善的必要条件，而脱碳层部位转移法能有效防止裂纹发生，亦是接头安全运行的重要工艺措施之一。     

The short- and long-run efficiency of energy,precious metals,and base metals markets: Evidence from the exponential smooth transition autoregressive models

The aim of this paper is to investigate the long and short-run relationship between spot and futures prices of the energy, precious metals, and base metals markets. We analyze daily data from January 1985 to February 2019. The empirical findings based on the cointegration test, which follows a nonlinear process, suggest that the spot prices of energy and metals assets have long-run relationships with their futures prices. Nonparametric Granger causality test results also indicate bi-directional causality among futures and spot prices. These findings indicate that the energy and metals markets are informationally efficient in the sense of Fama (1970).     

广州市郊填埋场附近蔬菜重金属检测与讨论

蔬菜是人们餐桌上必不可少的食物,重金属在受污染的自然环境中又无处不在,而蔬菜中的重金属含量尤其令人担忧。本文使用原子吸收分光光度法(石墨炉)和原子荧光分光光度法检测了广州市郊某垃圾填埋场附近所种植蔬菜中重金属含量。结果:抽样由2013年10月至2014年9月共持续一年,共抽样检测12次,按平均每个月一次的频率,检测结果并未发现有蔬菜超出国家规定的限量值。     

The Electron–Phonon Interaction of Low-Dimensional and Multi-Dimensional Materials from He Atom Scattering

Atom scattering is becoming recognized as a sensitive probe of the electron–phonon interaction parameter λ at metal and metal-overlayer surfaces. Here, the theory is developed, linking λ to the thermal attenuation of atom scattering spectra (in particular, the Debye–Waller factor), to conducting materials of different dimensions, from quasi-1D systems such as W(110):H(1 × 1) and Bi(114), to quasi-2D layered chalcogenides, and high-dimensional surfaces such as quasicrystalline 2ML-Ba(0001)/Cu(001) and d-AlNiCo(00001). Values of λ obtained using He atoms compare favorably with known values for the bulk materials. The corresponding analysis indicates in addition, the number of layers contributing to the electron–phonon interaction, which is measured in an atom surface collision.     

岩矿稀有金属化学分析技术浅析

分析当前较为常用的岩矿稀有元素分析技术方法,并对几种常见的稀有元素分析方法进行了阐述,希望为我国矿产勘探领域提供一些有价值的参考借鉴。     

金属泡沫材料研究进展

综述了金属泡沫材料的各种制备方法。液相法制备金属泡沫材料包括气体吹入法、固体发泡剂法和固体—气体共晶凝固法、熔模铸造法、渗流铸造法、喷射沉积法以及粉末加压熔化法等制备方法。采用金属粉末烧结法、浆料发泡法等制备工艺可以从固相制备金属泡沫材料。电沉积法以及气相沉积法可用于制备高孔隙率的金属泡沫材料。最后简要总结了金属泡沫材料的应用。     

Eu2+激活的碱土金属铝酸盐磷光体的研究进展

主要概述了Eu^2 激活的碱土金属铝酸盐磷光体的光谱特性，总结了近年来在铝酸盐基质研究以及长余辉机理研究等方面所取得的进展，同时对今后的研究提出了展望。