Structural manipulation of pyrochlores: Thermal evolution of metastable Gd2(Ti1−yZry)2O7 powders prepared by mechanical milling

The structural and microstructural characteristics of metastable Gd₂(Ti_1−yZr_y)₂O₇ powders prepared by mechanical milling have been studied by a combination of XRD and Raman spectroscopy. Irrespective of their Zr content, as-prepared powder phases present an anion-deficient fluorite-type of structure as opposed to the pyrochlore equilibrium configuration obtained for the same solid solution by other synthetic routes. These fluorites are stable versus thermal activation, at least up to temperatures of 800 °C. For the Ti-rich compositions, thermal treatments at higher temperatures facilitate the rearrangement of the cation and anion substructures and the relaxation of mechanochemically induced defects whereas for compositions with high Zr content, the fluorite crystal structure is retained even at temperatures as high as 1200 °C. Interestingly enough, transient pyrochlores showing a very unusual cation distribution were observed during the thermally induced defect-recovery process.     

Kinetics of the solution polymerization of dioxolane in the presence of water

Water acts as a cocatalyst in the polymerization of dioxolane initiated by the ion pair ～Si^⊕HSO₄^?. The dependence of the reaction rate on the water concentration exhibits a maximum, the width of which strongly depends on the concentration of dioxolane. The change of the coordinates of the maximum and its shape with the decrease of the monomer concentration causes the reaction rate to decrease with increasing conversion. The point at which the slope of the conversion curve changes is a function of initial concentration of water. There is a very fast decrease of the concentration of free water in the polymerizing system. The consumption of water is associated with some peculiarities. The amount of free water which remains in the system is a function of the concentration of the original initiator. The ratio [H₂O]_∞/[initiator] is constant over a rather broad range of initial concentration of water.     

Simulation of aerated lagoon using artificial neural networks and multivariate regression techniques

The aim of this study was to develop an empirical model that provides accurate predictions of the biochemical oxygen demand of the output stream from the aerated lagoon at International Paper of Brazil, one of the major pulp and paper plants in Brazil. Predictive models were calculated from functional link neural networks (FLNNs), multiple linear regression, principal components regression, and partial least-squares regression (PLSR). Improvement in FLNN modeling capability was observed when the data were preprocessed using the PLSR technique. PLSR also proved to be a powerful linear regression technique for this problem, which presents operational data limitations.     

Capillary zone electrophoresis of cationic and anionic drugs in methanol

The actual mobilities and dissociation constants of acidic and basic pharmaceuticals were determined in methanol. Actual mobilities were derived from the dependence of the effective mobilities of the analytes on the pH of the methanolic background electrolyte solution (pH(MeOH)). The pKa values of the pharmaceuticals in methanol (pK(a,MeOH)) were calculated by non-linear curve fitting to the measured mobility values. It was found that the shift in pKa value (when compounds were transferred from water to methanol) increased with the acidity of the analyte. The average pKa shift for compounds exhibiting acidic properties in water was ca. 5.5 units, and the shift for basic compounds about 2 units. As was shown for a mixture of beta-blockers, the calculated actual mobilities and pKa values can be utilised in the optimisation of pH conditions for separation. The practical value of the method was illustrated by the analysis of urine samples.     

Room-temperature synthesis and conductivity of the pyrochlore type Dy2(Ti1−yZry)2O7 (0?y?1) solid solution

Different compositions in a solid solution of general formula Dy₂(Ti_1−yZr_y)₂O₇, showing high oxygen ion conductivity, have been successfully prepared at room temperature via mechanochemical synthesis. Stoichiometric mixtures of the constituent oxides were dry milled together in a planetary ball mill by using zirconia vials and balls. Chemical changes in the powder mixtures as a function of composition and milling time were followed by X-ray diffraction and revealed that, in all cases and after milling for 19 h, the powder mixtures consisted of a single phase. Electrical properties were measured on sintered pellets as a function of frequency, temperature and zirconium content, revealing an increase in conductivity of more than one order of magnitude for y?0.4, which, as observed in the similar Y₂(Ti_1−yZr_y)₂O₇, has been related with the onset of disordering of the anion sublattice. Despite increasing structural disorder with increasing Zr content, conductivity remains almost constant for y>0.6, reaching a maximum value of ∼5×10⁻³ for Dy₂Zr₂O₇ at 900 °C.     

Rearrangement of spiro-benzimidazolines: preparation of N-alkenyl- and N-alkyl-benzimidazol-2-ones

A synthetically useful protocol has been developed for the preparation of highly functionalized N-alkenyl-benzimidazol-2-ones. Reaction of commercially available o-phenylenediamines with variously substituted cyclic ketones provides spiro-benzimidazolines. Treatment of these spiro-benzimidazolines with triphosgene in the presence of potassium carbonate results in rapid rearrangement and formation of N-alkenyl-benzimidazol-2-ones in modest to excellent yield for the two-step sequence. Extension of this methodology toward the preparation of a μ opiate receptor antagonist and droperidol, a potent antiemetic and antipsychotic agent, currently a marketed pharmaceutical is also described. Upon treatment of spiro-benzimidazolines with triphosgene in the presence of sodium triacetoxyborohydride, N-alkyl-benzimidazol-2-ones were formed.     

A more convenient and general procedure for O-monobenzylation of diols via stannylenes: a critical reevaluation of the Bu2SnO method

A more consistent, straightforward, and economical protocol for generation of stannylene species and their reaction with BnBr leading to products of O-monobenzylation of diols has been set. It has shown to be specially indicated for substrates bearing vicinal trans 1,2-diol moieties on cyclohexane backbones, which are more resistant to these transformations. Such protocol has been successfully applied to myo-inositol derivatives and acyclic diols.     

From anisole to 1,2,4,5‐tetramethoxybenzene: Theoretical study of the factors that determine the conformation of methoxy groups on a benzene ring

Unhindered ortho‐dimethoxy‐substituted phenyl rings often display a coplanar conformation. A theoretical study of a series of methoxybenzenes consisting of methoxybenzene (anisole), the three dimethoxybenzenes, and 1,2,4,5‐tetramethoxybenzene, at the DFT/B3LYP/6‐311++G** level of theory, allows us to identify the factors influencing the conformational preference and attribute the coplanarity of such methoxy groups to mesomeric effects. © 2006 Wiley Periodicals, Inc. Int J Quantum Chem, 2007     

High-throughput chemistry toward complex carbohydrates and carbohydrate-like compounds

In the area of peptide and nucleic acid chemistry and biology, high-throughput synthesis has played an important role in providing useful small-molecule-based chemical probes in understanding the structure and function relationships. The past several years, there has been a constant rise in interest toward understanding the biological roles and functions of another important class of biomolecules, i.e., carbohydrates and carbohydrate conjugates. Although at early stages, in recent years, several groups have developed high-throughput synthetic methods to obtain complex carbohydrates or carbohydrate-like small-molecules. The present review article summarizes some of these developments.