Formulation,optimization, hemocompatibility and pharmacokinetic evaluation of PLGA nanoparticles containing paclitaxel

Objective: Paclitaxel (PTX)-loaded polymer (Poly(lactic-co-glycolic acid), PLGA)-based nanoformulation was developed with the objective of formulating cremophor EL-free nanoformulation intended for intravenous use.

Significance: The polymeric PTX nanoparticles free from the cremophor EL will help in eliminating the shortcomings of the existing delivery system as cremophor EL causes serious allergic reactions to the subjects after intravenous use.

Methods and results: Paclitaxel-loaded nanoparticles were formulated by nanoprecipitation method. The diminutive nanoparticles (143.2?nm) with uniform size throughout (polydispersity index, 0.115) and high entrapment efficiency (95.34%) were obtained by employing the Box–Behnken design for the optimization of the formulation with the aid of desirability approach-based numerical optimization technique. Optimized levels for each factor viz. polymer concentration (X1), amount of organic solvent (X2), and surfactant concentration (X3) were 0.23%, 5?ml %, and 1.13%, respectively. The results of the hemocompatibility studies confirmed the safety of PLGA-based nanoparticles for intravenous administration. Pharmacokinetic evaluations confirmed the longer retention of PTX in systemic circulation.

Conclusion: In a nutshell, the developed polymeric nanoparticle formulation of PTX precludes the inadequacy of existing PTX formulation and can be considered as superior alternative carrier system of the same.     

Enhanced electron harvesting in next generation solar cells by employing TiO2 nanoparticles prepared through hydrolysis catalytic process

Titanium dioxide (TiO₂) nanoparticles (NPs) were synthesized through solvothermal route by changing the rate of hydrolysis in the catalytic process. In order to change the hydrolysis rate, the concentration of acetic acid, as additive, was varied as 2 M, 3 M and 4 M. The synthesized NPs were examined by various physico-chemical characterization techniques. The powder X-ray diffraction (PXRD) analysis of the NPs reveals only the anatase phase of TiO_2. The spherical shaped morphology of the NPs was observed in the high-resolution transmission electron microscopy (HR-TEM) analysis. The optical behaviour such as absorption, bandgap, diffuse reflectance and photoluminescence (PL) emission of the NPs were studied. The material's nature and behaviors were scrutinized and they were employed as photoanode in dye sensitized solar cell (DSSC) and as electron transport layer (ETL) in carbon-based perovskite solar cell (C-PSC). The charge transfer at the interface of the devices was studied with electrochemical impedance spectroscopy (EIS). The fabricated DSSC and C-PSC show highest power conversion efficiency (PCE) of 6.1% and 10.6%, respectively. The highest current collection was detected in C-PSC and the results are discussed in detail.     

Studies on long-term storage stability of biodiesel (B100) and its blend (B20) using Box-Behnken response surface method

The gradual depletion of fossil fuels has greatly enhanced the necessity to look for alternative fuels for automobile engines. In response to this, biodiesel is being considered as a promising and potential alternative substitute to conventional petroleum diesel. However, long-term storage stability of biodiesel is poorer compared to conventional petroleum diesel. The aim of the project work is to study the long-term storage stability of biodiesel (B100) and its blend (B20) prepared from used frying oil in different conditions of storage. In this work, the effect of antioxidants and temperature on long storage stability of biodiesel obtained from with respect to storage period is analysed using response surface methodology (RSM). The long storage of biodiesel obtained from used frying oils were optimised by varying parameters such as antioxidant concentration, storage period by Box-Behnken RSM. The properties such as the acid value and the viscosity of biodiesel were initially measured. The results of the investigation showed that the addition of sufficient concentration of antioxidant (pyrogallol) significantly maintains the acid value and viscosity of biodiesel and helps to store for a longer storage period at the given storage temperature.     

Optimization of waste quail eggshells as biocomposites for polyaniline in ammonia gas detection

A simple, cost-effective, and novel chemical sensor for ammonia (NH₃) gas detection was developed from polyaniline (PANI)/quail eggshell (QES) composites. QES is a natural waste enriched in calcium carbonate. In this work, pure PANI was synthesized from chemical oxidation method and PANI/QES composites were prepared from physical mixing of QES with the synthesized PANI at different mass ratio. A series of complementary techniques including Fourier transform infrared and ultraviolet-visible spectrometers, scanning electron microscope with energy dispersive detection coupled with mapping, thermogravimetric analysis, and X-ray diffractometer were used to characterize the physicochemical and textural properties of the biocomposites. From the results, PANI/QES composite with a mass ratio of 1 exhibited the lowest NH₃ detection limit of 5.24 ppm with a linear correlation coefficient (R²) of close to unity (0.9932) between the signal and NH₃ gas concentration. As a whole, the PANI/QES biocomposites synthesized from this work exhibited excellent selectivity toward NH₃ gas even in the presence of other gas impurities, such as acetone, ethanol, and hexane. For the sensor reusability, the PANI/QES biocomposites can be reused in the application of NH₃ gas detection for at least 4 cycles.     

Blast Fragility and Sensitivity Analyses of Steel Moment Frames with Plan Irregularities

Fragility functions are determined for braced steel moment frames (SMFs) with plans such as square-, T-, L-, U-, trapezoidal-, and semicircular-shaped, subjected to blast. The frames are designed for gravity and seismic loads, but not necessarily for the blast loads. The blast load is computed for a wide range of scenarios involving different parameters, viz. charge weight, standoff distance, and blast location relative to plan of the structure followed by nonlinear dynamic analysis of the frames. The members failing in rotation lead to partial collapse due to plastic mechanism formation. The probabilities of partial collapse of the SMFs, with and without bracing system, due to the blast loading are computed to plot fragility curves. The charge weight and standoff distance are taken as Gaussian random input variables. The extent of propagation of the uncertainties in the input parameters onto the response quantities and fragility of the SMFs is assessed by computing Sobol sensitivity indices. The probabilistic analysis is conducted using Monte Carlo simulations. The frames have least failure probability for blasts occurring in front of their corners or convex face. Further, the unbraced frames are observed to have higher fragility as compared to counterpart braced frames for far-off detonations.     

Influence of Electric Poling on Pb0.9Bi0.1Fe0.55Nb0.45O3 Multiferroic

This paper analyzes the influence of electric poling on structure, magnetism, and ferroelectricity by temperature-dependent Raman scattering (180 K–500 K), magnetic susceptibility, and ferroelectric measurements on Pb_0.9Bi_0.1Fe_0.55Nb_0.45O₃ (PBFNO) multiferroic. X-ray diffraction (XRD) has confirmed the monoclinic structure for PBFNO sample before and after poling. Rietveld refined XRD for poled and unpoled sample shows the influence of electric poling on Fe-O1, Fe-O2, Nb–O, and Bi-O modes with small variation in the lattice parameters. The unpoled PBFNO exhibits broad and overlapping 10 active modes at room temperature (100 to 1300 cm^?1) at 147, 212, 255, 431, 479, 561, 700, 795, 835, and 1112 cm^?1. In case of a poled sample, Pb–O and Nb–O-Nb modes become more active compared to the unpoled sample. Changes observed in the temperature-dependent magnetic measurements, i.e., ZFC/FC and M-H loop, evidence the poling effects on Fe–O and Nb–O active modes. By poling the improvement in ferroelectric domain, ordering occurs, and it is confirmed by P-E loops. The consequences of numerous investigations on electric poling of PBFNO will provide the foundation for future device development and design.

     

Lipid extraction from natural plant source of Adenanthera pavonina using mixed solvent by superheated extractor

The lipid content was extracted from the saga seed by superheated condition and soxhlet apparatus. The mixture of hexane, chloroform and methanol was utilized as a mixed solvent for these extraction operations. Different parameters such as different solvent, temperature, mean particle size and solvent flow have been examined. The optimized lipid extraction was achieved as 26.2 wt% by using superheated condition from the saga seed powder at 90 °C for 120min. Then the fatty acids profile of the optimized Adenanthera pavonina oil were analyzed by gas chromatography. Unsaturated fatty acid was high as 83.7% compared with saturated fatty acid barely 15.4% by relative.     

Discrete Wavelet Transform based Denoising of TOFD Signals of Austenitic Stainless Steel Weld at Elevated Temperature

Russian Journal of Nondestructive Testing - Abstract—Time of flight Diffraction technique is an advanced ultrasonic NDE methods, adopted in weld integrity testing. During the Time of flight...