Geochemical characteristics of the Yufuin outflow plume, Beppu hydrothermal system, Japan

Thermal water at Yufuin (Kyushu Island, Japan) is tapped through about 820 shallow wells and used mainly for hot-spring bathing purposes. Chemical and isotopic data for fluids from wells and fumaroles in Yufuin and Beppu indicate that the thermal activity at Yufuin represents a dilute, westward-flowing hydrothermal outflow plume from the Beppu hydrothermal system. Two other (eastward-flowing) outflow plumes have long been recognized at Beppu, but the Yufuin outflow plume is first recognized here. The Yufuin outflow plume is apparently a mixture of two end-member fluids: (1) deep high-temperature (250–300°C) fluid from the Beppu system having high chloride concentration (1400–1600 mg/L) and a δ¹⁸O value near −6.0%, and (2) meteoric water having low chloride concentration (≤7 mg/L) and a δ¹⁸O value near −9.2%.A permeable conduit for the vertical and lateral transport of deep fluid from the Beppu system is provided by the Yufuin Fault zone, which extends westward from the southern flank of Mt. Tsurumi volcano to the town of Yufuin. Stable isotope ratios and chloride concentrations for shallow groundwaters near the eastern end of the fault, at an elevation near 700 m, are consistent with those required for the low-chloride meteoric end-member of the Yufuin thermal waters. Recharge of this meteoric water, as well as mixing with the Beppu deep fluid, may occur along the Yufuin Fault. Enthalpy-chloride relations indicate additional conductive heating of the Yufuin waters, in the amount of 350–500 kJ/kg beyond that which can be accounted for by mixing between Beppu deep fluid and meteoric water. This could be a result of conductive heating with convection to a depth of 1–2 km. Estimates of the magnitude of the heat source for the Beppu hydrothermal system should take into account the heat being discharged at Yufuin.     

Two patients with polymyositis or dermatomyositis complicated with massive pleural effusion

Two patients with polymyositis (PM) or dermatomyositis (DM) complicated with massive pleural effusion are reported here. Both patients presented a high-grade fever, pleural effusion prominent on the right, and good response to steroid therapy. In a 50-year-old woman with PM, combined process of pleural inflammation, cardiomyopathy and coexisting hypothyroidism were considered to be responsible for the accumulation of the massive pleural effusion. However, in a 34-year-old man with DM, pleural inflammation associated with interstitial pneumonia or pleural microvasculopathy in DM was considered to be responsible for the accumulation of the massive pleural effusion.     

Path planning for an autonomous mobile robot considering a region with a velocity constraint in a real environment

Recently, many research projects and competitions have attempted to find an autonomous mobile robot that can drive in the real world. In this article, we consider a path-planning method for an autonomous mobile robot that would be safe in a real environment. In such a case, it is very important for the robot to be able to identify its own position and orientation in real time. Therefore, we applied a localization method based on a particle filter. Moreover, in order to improve the safety of such autonomous locomotion, we improved the path-planning algorithm and the generation of the trajectory so that it can consider a region with a limited maximum velocity. In order to demonstrate the validity of the proposed method, we participated in the Real World Robot Challenge 2010. The experimental results are given.     

培哚普利与缬沙坦对高胆固醇兔脑组织AngⅡ的影响及其抗氧化应激作用

目的探讨高胆固醇兔脑组织RAAS与氧化应激的关系及培哚普利、缬沙坦的干预效果;方法:32只健康新西兰白兔随机分为4组:正常组,高脂组,培哚普利组,缬沙坦组。喂饲8周后,测定血清总胆固醇(Total cholesterol,TC)及低密度脂蛋白(Low den-sity lipoprotein,LDL)浓度。取脑组织测血管紧张素Ⅱ(AngiotensinⅡ,AngⅡ),血红素氧合酶(hemo oxygenase-1,HO-1)的表达及超氧化物岐化酶(SOD)活力,丙二醛(MDA)含量;结果:与正常组相比,高脂组AngⅡ,HO-1表达明显增强,SOD活力下降,MDA升高,培哚普利可降低AngⅡ,而缬沙坦不能,二者均可使HO-1表达上调,SOD活力升高,MDA降低;结论:1)高胆固醇血症时脑组织处于氧化应激状态,肾素血管紧张素醛固酮系统(Rennin-angiotensin-aldosterone system RAAS)激活;2)培哚普利和缬沙坦对组织具有抗氧化应激的保护作用。     

One-step formation of ethyl methyl ketone from 1-butene and water on ultrastable Y-type zeolite catalyst

Proton exchanged ultrastable Y-type zeolite with silica/alumina = 40 showed a pronounced catalytic activity for the formation of ethyl methyl ketone directly from 1-butene and water. The formation rate of ethyl methyl ketone was much higher than those on MoO₃-based catalysts in the oxidation of 1-butene by oxygen. It was suggested that the basic site necessary for the formation of ethyl ketone directly from 1-butene and water would be the pentacoordinated Al.     

Relationship between crystallinity and device characteristics of In‐Sn‐Zn oxide

We have reported that the transistors having the c‐axis‐aligned crystalline (CAAC) In‐Ga‐Zn oxide (IGZO) show good performance. Recently, In‐Sn‐Zn Oxide (ITZO) has attracted much attention because of its high electron mobility, as well as IGZO. However, it has been reported that ITZO field effect transistors (FET) tend to have positive Vth (normally‐on characteristics) and poor reliability compared with IGZO‐FETs. We have reported that high‐performance and high‐reliability OS‐FETs can be fabricated by using CAAC‐IGZO, which has high crystallinity and has no clear grain boundaries, as an active layer. Therefore, we have fabricated CAAC‐ITZO thin films to improve performance of ITZO‐FETs by using CAAC‐ITZO as an active layer. In addition, FETs employing CAAC‐ITZO have better characteristics and reliability than FETs using nano‐crystal ITZO. Furthermore, constant photocurrent method (CPM) measurement was carried out in order to estimate density of deep‐level defect states caused by oxygen vacancies in oxide semiconductors. The results show that CAAC‐ITZO has lower density of deep‐level defect states than nano‐crystal ITZO. We attribute the improvement in reliability of ITZO‐FETs to a decrease in deep‐level defect states of an ITZO active layer, as is the case with IGZO.     

Concentration of Antifouling Biocides and Metals in Sediment Core Samples in the Northern Part of Hiroshima Bay

Accumulation of Ot alternative antifoulants in sediment is the focus of this research. Much research had been done on surface sediment, but in this report, the accumulation in the sediment core was studied. The Ot alternative antifoulants, Diuron, Sea-Nine211, and Irgarol 1051, and the latter’s degradation product, M1, were investigated in five samples from the northern part of Hiroshima Bay. Ot compounds (tributyltin (TBT) and triphenyltin (TPT)) were also investigated for comparison. In addition, metal (Pb, Cu, Zn, Fe and Mn) levels and chronology were measured to better understand what happens after accumulation on the sea floor. It was discovered that Ot alternative antifoulant accumulation characteristics in sediment were like Ot compounds, with the concentration in the sediment core being much higher than surface sediment. The concentration in sediment seems to have been affected by the regulation of Ot compounds in 1990, due to the concentration of Ot alternative antifoulants and Ot compounds at the survey point in front of the dock, showing an increase from almost the same layer after the regulation.     

Principle and application of ball SAW devices

A thin beam of waves usually diverges due to diffraction, which is a limitation of any device using such waves. However, a surface acoustic wave (SAW) on a sphere with an appropriate aperture does not diverge but is collimated, realizing ultra‐multiple roundtrips along an equator of the sphere. This effect is caused by the balance between diffraction and focusing on a spherical surface, and it enables realization of high‐performance ball SAW sensors. © 2009 Wiley Periodicals, Inc. Electr Eng Jpn, 168(1): 41–51, 2009; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20817     

Interactions between nano-spacing flying head sliders and ultra-thin liquid lubricant films with non-uniform distribution in hard disk drives

This paper describes the effect of ultra-thin liquid lubricant films on air bearing dynamics and flyability of less than 10 nm spacing flying head sliders in hard disk drives. In particular, the effect of non-uniform lubricant film distributions on head/disk interface dynamics are studied. The disks with lubricant on one half of disk surface thicker than the other half were used in this study. The dynamics of sliders is monitored using acoustic emission (AE) and the interactions between the slider and disk are investigated experimentally. The disks were also examined with a scanning micro-ellipsometer before and after each test. Complicated slider responses were observed and clarified. In addition, it was found that the periodic lubricant film thickness modulations or non-uniformity caused by the slider-disk contact interactions could be observed. It is suggested that this lubricant film thickness non-uniformity will be one of the technical issues in order to achieve ultra-low head/disk contact interface of less than 10 nm.