Microstructural and electrical changes in Ca0.9R0.1CeNbMoO8 (R = Y,Sm, Nd,La) ceramics induced by rare-earth ion doping

Rare-earth ions doped Ca_0.9R_0.1CeNbMoO₈ (R = Y, Sm, Nd, La) ceramics have been successfully prepared by solid-state method, and their modifications to the microstructure and electrical properties are also investigated. The rare-earth ions doped ceramics exhibit the scheelite structure. With the increase in the radius of rare-earth ions, the lattice distortion and bond interaction will be enhanced, and the consistency of grain size will be reduced. The ceramics exhibit negative temperature coefficient (NTC) thermistor characteristics in the temperature range of 473 K-1273 K, and the activation energy decreases with the increase of the radius of rare-earth ions. Rare-earth ions doping can increase the content of Ce³⁺ ions and promote the conductivity of ceramics. Except for Sm³⁺-doped ceramics, the high-temperature aging rate of other ceramics is less than 2%. The existence of some metastable Sm²⁺ ions in Sm³⁺-doped ceramics not only increases the activation energy, but also reduces the high-temperature stability of the ceramics.     

基于虚拟仪器功率测试分析系统

介绍基于虚拟仪器的功率测试分析系统的构成，软件设计以及数据采集、信号处理和整体结构。该系统已在实际应用中取得很好效果。     

对流扩散方程的离散技术及数值实验

本文研究了对流扩散方程的离散技术,并进行了大量数值实验。研究表明,scharfetter—Gummel的广义形式可以良好地消除内部的非物理振荡,且对边界层生成振荡的传播有抑制作用,但不能有效地消除边界层振荡。     

层状边坡的地震动输入方法研究

层状边坡是自然界中最常见的边坡之一,研究其动力响应规律对边坡的稳定性评价具有重要意义。为真实模拟弹性波在层状地基中的传播过程,首先建立层状地基的黏弹性人工边界模型,然后根据波动力学理论推导了考虑介质交界面的一次反射的等效荷载计算公式,并通过两层地基算例验证该输入方法的精度;针对层状边坡,采用本文提出的地震动输入方法和一种传统的输入方法分别研究其动力响应规律。研究表明:在两层地基算例中,本文提出的地震动输入方法能较好满足工程抗震的精度要求;在边坡的动力分析中,与传统方法相比,采用本文方法的边坡塑性应变能累积效应更加明显,且动力安全系数相对较小。     

Facile Fabrication of Poly(vinyl alcohol)/Polyquaternium-10 (PVA/PQ-10) Anion Exchange Membrane with Semi-Interpenetrating Network

Anion exchange membranes (AEMs) are one of the core components of AEM fuel cells. A series of poly(vinyl alcohol)/polyquaternium-10 (PVA/PQ-10) AEMs with semi-interpenetrating networks (s-IPNs) are prepared by a simple solution-casting method using glutaraldehyde (GA) as a cross-linking agent. Subsequently, the prepared PVA/PQ-10 cross-linked membranes are characterized by Fourier transform infrared spectroscopy, scanning electron microscopy, thermogravimetric analysis, mechanical analysis, water uptake and swelling ratio tests, ion exchange capacity (IEC) tests, ionic conductivity measurements, and oxidative/alkaline stability tests. The effects of the mass ratio of PVA and PQ-10 and the amount of cross-linking agent GA on the performance of the PVA/PQ-10 cross-linked membranes are systematically explored. The results show that the cross-linked PVA/PQ-10 AEMs have high IEC and low water uptake and swelling ratio, and its maximum ionic conductivity can reach 79.37 mS cm^–1 at 80 °C. In addition, the PVA/PQ-10 cross-linked membrane has good oxidative and alkaline stability under optimal preparation conditions. These results may provide valuable insights toward more effective scheme designs and new, simple preparation methods for AEMs with s-IPN structures.     

LiNi0.6 Co0.2 Mn0.2 O2@LiMn0.6 Fe0.4 PO4/C复合正极材料的制备及性能

采用简单的机械球磨混合法制得NCM@LMFP/C(LiNi_0.6 Co_0.2 Mn_0.2 O₂@LiMn_0.6 Fe_0.4 PO₄/C)复合正极材料,系统地研究了NCM与LMFP/C复合比例(9∶1,8∶2,7∶3,6∶4,5∶5)对材料电化学性能和热稳定性的影响.使用X射线衍射仪(XRD)、扫描电子显微镜(SEM)和差示扫描量热仪(DSC)对复合正极材料的结构与形貌进行表征研究.研究结果表明:当NCM与LMFP/C复合比例小于8∶2时,亚微米级LMFP/C出现富集、团聚,将NCM包埋其中.当NCM与LMFP/C复合比例为8∶2时,LMFP/C均匀地包覆在NCM颗粒表面或填充于其颗粒空隙中,材料的电化学性能最优、热稳定性良好:电流为0.1 C和1 C时的放电比容量分别为180.1和165.0 mAh/g,均高于理论测算容量(178.9和164.3 mAh/g);循环80周后容量保持率为95.7%,优于NCM(94.9%);复合正极材料热失控温度相比于NCM提高了25℃且放热量更低.     

含B4C中性盐浴渗硼工艺问题的研究

在含Ｂ４Ｃ中性盐浴渗硼的高温反应研究的基础上，对该盐浴存在的工艺问题进行了分析研究。指出了渗硼能力均匀性，工件表面腐蚀斑与玻璃体的关系，分析了老化盐致使工件清洗困难的成因。     

Effects of hydrogen on the transition layers between diamond films and Zr, Hf substrates

Highly purified polycrystalline wafers of Zr and Hf were chosen as substrates for diamond deposition by means of the d.c. arc discharge plasma CVD method. Polycrystalline diamond films were formed on both substrates. Scanning electron microscopy and high resolution X-ray diffraction were used to investigate the surface morphology of the diamond films and the composition of the interface layers between the diamond films and substrates. The experiments showed that the transition layer between the diamond films and Zr substrates was ZrC, ZrH and ZrC_0.32H_1.2. For Hf substrates, in addition to HfC, it is supposed that there were also some hydrides or carbohydrides in the transition layer, because several X-ray reflections appeared which could not be assigned to Hf, HfC or diamond.     

Efficient object detection based on selective attention

In this paper, we make use of biologically inspired selective attention to improve the efficiency and performance of object detection under clutter. At first, we propose a novel bottom-up attention model. We argue that heuristic feature selection based on bottom-up attention can stably select out invariant and discriminative features. With these selected features, performance of object detection can be improved apparently and stably. Then we propose a novel concept of saccade map based on bottom-up attention to simulate the saccade (eye movements) in vision. Sliding within saccade map to detect object can significantly reduce computational complexity and apparently improve performance because of the effective filtering for distracting information. With these ideas, we present a general framework for object detection through integrating bottom-up attention. Through evaluating on UIUC cars and Weizmann–Shotton horses we show state-of-the-art performance of our object detection model.