Low-carbon energy technology (LC) innovation contributes to both environmental protection and economic development. Using the panel data of 30 provinces/autonomous regions/municipalities in China from 1998 to 2017, this paper constructs a two-layer logarithmic mean Divisia index (LMDI) model to uncover the factors influencing the variation of the innovation of LC in China’s industrial sectors, including the alternative energy production technology (AEPT) and the energy conversation technology (ECT). The results show that China’s industrial LC patent applications rapidly increased after 2005 and AEPT patent applications outweighed ECT patent applications all the time with a gradually narrowing gap. Low-carbon degree played the dominant role in promoting the increase in China’s industrial LC patent applications, followed by the economic scale, R&D (research and development) efficiency, and R&D share. Economic structure contributed to the increases in LC patent applications in the central and the western regions, while led to the decreases in the eastern region, the north-eastern region, and Chinese mainland Xizang(Tibet) Autonoomous Region is not considered due to lack of data. This note applies to the entire article.. Low-carbon degree and economic scale were two main contributors to the growths of both industrial AEPT patent applications and ECT patent applications in Chinese mainland and the four regions. Several policy recommendations are made to further promote industrial innovation in China. 相似文献
This study investigates the mixing effects of primary and secondary jets on flame stability as fuel/air is injected into a bluff-body burner. A two-dimensional spray combustion model, based upon a SIMPLER method, is used for numerical studies of combusting flow. The influence of the jet-to-air velocity ratio on the recirculation zone behind the bluff body, the center axial velocity and the temperature profiles is studied in detail. The results show that mixing between the two jets is controlled by two vortex eddies on the inside and outside of the bluff-body. With a proper bluff-body blockage ratio, cone angle and jet-to-air velocity ratio a more stable flame can be achieved. 相似文献
Sodium-doped hydroxylapatite powder was synthesized by the wet chemical method. Powder behavior, thermal stability, mechanical strength and biocompatibility were investigated.
The synthesized hydroxylapatite powder consisted of needles 1800 Å in width and 260 Å in length. The particle size, specific area (BET) and Ca/P atomic ratio were 0·1–0·3 μm, 29·9 m2/g and 1·62 respectively. A large amount of absorbed water existed in the powder, and evaporated on heating to 1000°C. Differential thermal analysis showed that no phase transformation occurred during heating to 1250°C. After heating at 1250°C for 1 h, the O---H bond was still found in the synthesized powder, by IR spectrophotometry. The optimum sintering condition was heating at 1200°C for 4 and this resulted in 680 MPa compressive strength, 1-1·3 μm mean grain size and 99% T.D.
The synthesized hydroxylapatite showed no cytotoxicity and had excellent tissue compatibility. This powder possesses a high potential for bone implantation. 相似文献
STUDY OBJECTIVE: To determine whether an intensive educational campaign of emergency department personnel on the organ donor and procurement process would result in both increased organ donor referrals and organs procured. METHODS: A retrospective review of the performance of an urban teaching ED in identifying and referring potential organ donor candidates was performed. Subsequently an intensive educational campaign of all ED staff, in conjunction with the Regional Organ Procurement Agency of Southern California (ROPA), was initiated. Physicians and nurses were educated about the procurement process, and a ROPA representative was on call 24 hours a day to assist in this process. The need for aggressive resuscitation and vital sign maintenance in potential donors as a strategy to promote organ recovery was emphasized. Reeducation by ROPA occurred every 2 to 3 months. The identification and referral rates were then retrospectively reviewed to evaluate any improvement. RESULTS: In 1994 the initial referral rate of potential organ donors from the ED was 30% (3 of 10) resulting in no organs procured. After the intervention the referral rate increased to 100% (25 of 25) in 1995 (P < .0001). The number of actual donors procured was 0 in 1994, 5 in 1995, and 9 in 1996. The increased ED referrals resulted in 14 and 32 organs procured in 1995 and 1996, respectively. CONCLUSION: Emergency physicians are in a unique position as first caregivers to interact with both potential donors and their families. With intensive education of ED staff, proper identification and referral, as well as timely intervention by organ procurement representatives, the consent and donation rate of organs for transplantation can be increased and maintained. 相似文献
A polymerase chain reaction (PCR) method for the rapid diagnosis of tuberculous meningitis (TBM) was used to study prospectively 47 cerebrospinal fluid (CSF) samples from 45 patients. Twenty CSF samples were from patients with clinically suspected TBM and another 27 samples came from patients without clinically suspected TBM. Mycobacterial DNA was detected in 15 CSF samples (14 from patients with clinically suspected TBM and 1 from a patient not suspected of having TBM). Of the PCR-positive samples, 4 were also positive for mycobacterial culture. However, 32 PCR-negative samples were all culture-negative. All samples were negative for the acid-fast bacillus by direct smear. The single PCR-positive patient in the clinically unsuspected TBM group was initially diagnosed as suffering from aseptic meningitis on the basis of his clinical features. The mycobacterial culture of his CSF specimen was also positive and a revised diagnosis of an aseptic type of TBM was made. The estimations of specificity and sensitivity in this study were 100% and 70% respectively. The results showed that using a PCR to detect mycobacterial DNA in CSF for the early diagnosis of TBM is not only a rapid but also an accurate method. 相似文献
BACKGROUND: Determining the ratio of free to total prostate specific antigen (f-PSA to t-PSA, calculated as the percentage of f-PSA [f-PSA%]) in serum allow for a clearer distinction between patients with prostate carcinoma (PCa) and patients with benign prostate hyperplasia (BPH) than determining the level of t-PSA alone. To find influencing factors on f-PSA%, the authors investigated prostate volume, TNM classification, and tumor stage. METHODS: The authors measured f-PSA and t-PSA in 36 men with untreated PCa (tumor classification: T1, 2, 3pNO, MO), 44 patients with BPH, and 54 healthy controls. Prostate volume was determined by transrectal ultrasound. RESULTS: The median values of t-PSA and f-PSA% were 7.8 micrograms/L and 10.5% in PCa patients, 4.3 micrograms/L and 20.8% in patients with BPH, and 1.4 micrograms/L and 23.6% in the control group. Patients with PCa had a significantly lower proportion of f-PSA than BPH patients and healthy men. There was no correlation of f-PSA% to TNM stage or tumor grade. In PCa patients a significant positive correlation (correlation coefficient [r] = 0.51, P < 0.001) was found between f-PSA% and prostate volume, whereas there was no significant correlation in BPH patients (r = -0.27, P > 0.05). There was a significant difference in f-PSA% between PCa and BPH patients with prostate volumes smaller than 40 cm3 (9.0% vs. 21.6%, P < 0.01) but not between patients in these 2 groups with prostate volumes exceeding 40 cm3 (15.1% vs. 18.2%, P = 0.11). CONCLUSIONS: Determining the ratio of f-PSA to t-PSA to discriminate between PCa and BPH patients yields significant results only in men with a prostate volume of less than 40 cm3. 相似文献
Initiation and early propagation of pitting and filiform corrosion on bare alloy AZ91 (9% Al, 1% Zn) are investigated by natural immersion corrosion tests, electrochemical measurements and microanalytical studies. Initiation sites are few. Corrosion spreads from these sites first in the form of filiform corrosion for a limited period of time and pitting which later develops into a cellular type of etching. The important factors affecting filiform corrosion are temperature, material structure and degree of polarization at the anodic sites. Filiform attack on AZ91, unlike the classical mechanisms of filiform corrosion on coated metals, is driven by hydrogen evolution reaction on the cathodic sites of the surface, occurs under significant anodic control, propagates at a high, constant speed independent of degree of polarization along preferential paths determined by compositional and crystallographic factors, and is a temporary phenomenon under open circuit conditions. Pitting corrosion is more predominant with decreasing anodic polarization. 相似文献
Steady-state compressive creep rate of La0.5Sr0.5Fe0.5Co0.5O3−δ (LSFC) and La0.5Sr0.5CoO3−δ (LSC) is reported in the temperature region 900°–1050°C and stress range 5–28 MPa. The stress exponents for the two materials were 1.71±0.18 and 1.24±0.15, respectively. The activation energy for creep was considerably higher for LSC (619±56 kJ/mol) than for LSFC (392±28 kJ/mol). The grain size exponent for LSC was 1.28±0.14. Considerably higher creep rates were observed for both materials in N2 compared with air. Relaxation by creep of chemical-induced stresses in oxygen-permeable membranes is addressed, especially at low partial pressure of oxygen. 相似文献