全文获取类型
收费全文 | 75979篇 |
免费 | 7957篇 |
国内免费 | 4837篇 |
学科分类
工业技术 | 88773篇 |
出版年
2024年 | 158篇 |
2023年 | 1107篇 |
2022年 | 2008篇 |
2021年 | 3150篇 |
2020年 | 2409篇 |
2019年 | 1957篇 |
2018年 | 2120篇 |
2017年 | 2401篇 |
2016年 | 2227篇 |
2015年 | 3214篇 |
2014年 | 4024篇 |
2013年 | 4870篇 |
2012年 | 5444篇 |
2011年 | 5798篇 |
2010年 | 5557篇 |
2009年 | 5355篇 |
2008年 | 5111篇 |
2007年 | 4826篇 |
2006年 | 4562篇 |
2005年 | 3762篇 |
2004年 | 2764篇 |
2003年 | 2529篇 |
2002年 | 2571篇 |
2001年 | 2295篇 |
2000年 | 1757篇 |
1999年 | 1419篇 |
1998年 | 936篇 |
1997年 | 822篇 |
1996年 | 784篇 |
1995年 | 627篇 |
1994年 | 504篇 |
1993年 | 387篇 |
1992年 | 309篇 |
1991年 | 196篇 |
1990年 | 171篇 |
1989年 | 135篇 |
1988年 | 111篇 |
1987年 | 63篇 |
1986年 | 52篇 |
1985年 | 41篇 |
1984年 | 17篇 |
1983年 | 18篇 |
1982年 | 25篇 |
1981年 | 18篇 |
1980年 | 16篇 |
1979年 | 14篇 |
1962年 | 42篇 |
1961年 | 39篇 |
1960年 | 16篇 |
1951年 | 8篇 |
排序方式: 共有10000条查询结果,搜索用时 15 毫秒
2.
Peng Wang Yan Li Yujiao Qu Baowei Wang Jingxin Sun Chunwei Miao Ming Huang He Huang Congxiang Zhang 《International Journal of Food Science & Technology》2022,57(6):3428-3439
The effects of cellulose microfibres (CMFs, Average size: 100 ± 5 μm) and cellulose nanofibres (CNFs, Average size: 60 ± 3 nm) on the properties of myofibrillar protein (MP) gels from duck breast meat were studied. The results demonstrated that CMFs and CNFs were mostly connected to MP by non-covalent bonds, the diffusion and cross-linking of MP molecules was promoted, and a denser and more complete gel network was formed. With the increases of CMFs and CNFs concentration (0–10%), the hardness was increased by 13.15% and 19.78% for CMFs10% and CNFs10% gels, respectively, and the elasticity was increased by 40% and 80%, respectively. At the same concentration (0–10%), the increase in gel hardness, viscoelasticity and immobilised water content was greater in the CNFs-MP group than in the CMFs-MP group. The CNFs-MP group had a tighter gel network, and CNFs had a better potential to improve the gelation performance of MP. 相似文献
3.
4.
5.
Xiehuan Li Dan Ye 《International Journal of Adaptive Control and Signal Processing》2022,36(1):104-121
In this article, the memory-based dynamic event-triggered controller design issue is investigated for networked interval type-2 (IT2) fuzzy systems under non-periodic denial-of-service (DoS) attacks. For saving limited network bandwidth, a novel memory-based dynamic event-triggered mechanism (DETM) is proposed to schedule data communication. Unlike existing event-triggered generators, the developed memory-based DETM can utilize a series of newly released signals and further save network resources by introducing interval dynamic variables. Moreover, to improve design flexibility, an IT2 fuzzy controller with freely selectable fuzzy rule number and premise membership functions (MFs) is synthesized. Then, a new switched time-delay system with imperfectly matched MFs is established under the consideration of memory-based DETM and DoS attacks simultaneously. Besides, based on the property of MFs, the boundary information of membership grades and slack matrices are introduced in the stability analysis. Furthermore, by using a piecewise Lyapunov–Krasovskii method, membership-functions-dependent criteria are deduced to ensure the asymptotic stability of built fuzzy switched systems. Finally, the effectiveness of proposed control strategies is demonstrated by simulation examples. 相似文献
6.
7.
8.
9.
利用改进的索氏提取回流法测量碳纤维原丝含油率.研究了溶剂回流温度、回流时间、环境湿度对测试结果的影响,结果表明:随着回流温度的提高,2小时内回流清洗效果不断增强,当回流温度大于54℃,次数大于12次,油剂清洗效果基本保持不变.可通过提高回流温度以提高单位时间内的回流次数,优化纤维含油率测试的准确性和测试效率.环境湿度对索氏提取测纤维含油率有显著影响:控制环境湿度在50~52%RH范围内,可将纤维吸潮质量变化控制在纤维质量的0.005%,油剂相对含量的0.2%~0.6%,可将测试稳定差值降低至≤0.05%,测试方法差值<0.1%,满足油剂测试工艺要求.回流时间≥2 h,回流温度≥54℃,测试环境湿度50~52%RH,索氏提取回流法油剂测试误差<0.05%. 相似文献
10.
梯度分层铝合金蜂窝板是一种有效的吸能结构,本工作在梯度铝蜂窝结构的基础上根据梯度率的概念,通过改变蜂窝芯层的胞壁长度,设计了4种质量相同、梯度率不同的铝蜂窝夹芯结构。通过准静态压缩实验,并结合非线性有限元模拟准静态及冲击态下梯度铝蜂窝夹芯结构的变形情况及其力学性能,分析对比了相同质量下梯度铝蜂窝夹芯结构在准静态下的变形模式以及冲击载荷下分层均质蜂窝结构和不同梯度率的分层梯度蜂窝结构的动态响应和能量吸收特性。结果表明:在准静态压缩过程中,铝蜂窝梯度夹芯板的变形具有明显的局部化特征,蜂窝芯的变形为低密度优先变形直至密实,层级之间的密实化应变差随芯层密度的增大而逐渐减小;在高速冲击下,梯度蜂窝板并非严格按照准静态过程中逐级变形直至密实,而是在锤头冲击惯性及芯层密度的相互作用下整体发生的线弹性变形、弹性屈曲、塑性坍塌及密实化;另外,在本工作所设计的梯度率中,当梯度率为γ1=0.0276时,梯度蜂窝夹芯板的吸能性达到最好,相较于同等质量下的均质蜂窝夹芯板,能量吸收提高了10.63%。 相似文献