Electrokinetic power generation of non-Newtonian fluids in a finite length microchannel

In order to examine the effects of the fluid type as the electrolyte solvent on the efficiency of electrokinetic energy conversion, a comparative numerical study among three different fluid types of a transient electrokinetic flow through a single circular finite length microchannel has been conducted. The system was initially at an equilibrium non-flow state, and a step change in flow was applied and the calculation proceeding until steady state was achieved. The analysis was based on non-dimensional transport governing equations that were scaled using Debye length as the characteristic length scale and diffusion time as characteristic time scale. The fluid types considered were shear thinning, Newtonian, and shear thickening, and a power law modeled them with the scaled flow behavior index having values of 0.2, 1.0, and 1.8. In order to isolate the electrokinetic effects of the different relationships between the shear strain rate and shear stress, the flow consistency index was adjusted so that in all the cases the flow rate and total pressure drop matched that of water at 25 °C. All other fluid and interfacial properties were the same for all cases. The key observational difference between the various fluid types was that their different axial velocity profile acted on essential the same free charge density profiles. Consequently, the convection current density (i.e., the radial distribution of charge being advected along the channel) was strongly affected by the fluid type. Integration of this quantity to calculate the convection current showed that for the particular fluid properties chosen the shear thinning fluid was 20 % higher than the Newtonian fluid, while the shear thickening fluid was only 4 % lower than the Newtonian fluid. Combined with the effects, these different currents have on the streaming potential, the shear thinning fluid was 50 % more effective in converting flow work to electrical work than the Newtonian fluid, while the shear thickening fluid was only 16 % lower than the Newtonian fluid.     

Control of bandwidth,resonant frequency,and modelling of bandpass filter using open stub resonator for K-band application

Microsystem Technologies - In this paper, we present the implementation of a new compact end coupled bandpass filter (BPF) in coplanar waveguide (CPW) technology. The proposed BPF is exposed with...     

Design and analysis of RF MEMS shunt switch for V-band applications

Microsystem Technologies - In this paper, we have designed and simulations of RF MEMS shunt switch. The electro-mechanical and electromagnetic analysis of the switch have been done using COMSOL...     

Impact of Flood Spreading on Groundwater Level Variation and Groundwater Quality in an Arid Environment

In arid and semiarid areas, bimodal and high rainfall leads to infrequent flood that can be extremely damaging. To reduce the impacts of persistent intra-seasonal drought and also to reduce flood damaging in arid and semiarid areas, rainwater storage is a prerequisite that keeps water far from evapotranspiration, increases groundwater level and decreases flood hazards modification to exchange between surface water and groundwater through flood spreading, dams, etc. The purpose of this paper is to delineate and explain variations in groundwater recharge and groundwater quality along an ephemeral stream that has been modified by flood spreading. Groundwater samples were collected from 14 deep wells located at different distances from flood spreading projection area (FSPA) in 1 month interval during September 2005 to September 2008. Groundwater quality was followed via Na⁺, K⁺, Ca²⁺, Mg²⁺, Cl^-, Hco₃^- SO₄^2-, Electrical Conductivity (EC) and pH measurements for two time periods between 2005 and 2008. The results show significant impact of flood spreading in groundwater table and groundwater salinity variation. Groundwater table decreased in all study wells, but groundwater drawdown increased by increasing the distance to FSPA (during 4 years study, 11.02 m in the well located at 20 m of FSPA versus 38.88 in the well located at 1,825 m). Also ion concentration increased in all of the wells during the study period, but the increasing ion concentration was significantly less important in FSPA closeness.     

Rheological and thermal stability of novel weak gels based on sulfonated polyacrylamide/scleroglucan/chromium triacetate

The present study deals with weak gels based on sulfonated polyacrylamide (SPA)/scleroglucan (SC)/Cr³⁺ with an exceptional thermal stability in electrolyte media. The rheological results showed that on increasing the SC concentration the shear viscosity and storage modulus of the SPA/SC/Cr³⁺ system were increased and the dependence of the storage modulus on frequency became weaker. The yield stress of the SPA/SC/Cr³⁺ system was higher than that of the corresponding SPA/SC system. The thermochemical stability increased with increasing relaxation time. The SPA/SC/Cr³⁺ semi‐interpenetrating network exhibited the lowest viscosity loss in electrolyte media; therefore this system may be a potential candidate for enhanced oil recovery applications. © 2016 Society of Chemical Industry     

The electroreduction kinetics of silver sulfite complexes

The electroreduction kinetics of silver sulfite complexes was investigated by rotation disk electrode (RDE) voltammetry, chronopotentiometry (CP) and electrochemical impedance spectroscopy (EIS). The stability constants of the silver sulfite complexes, pβ₂ = 7.9 and pβ₃ = 8.53 were determined. For the series of isopotential solutions investigated, a reaction order of 0.67 was obtained, the diffusion coefficient of the silver complexes varies in the range of 3.36 × 10⁻⁶ to 5.54 × 10⁻⁶ cm² s⁻¹ and the silver degree of complexation (2.31-2.67) were found. The analysis of the RDE, CP data and EIS spectra indicate the existence of a slow stage of the silver electrocrystallization in the region of the equilibrium potential and at stronger polarization of the electrode at initial time moments.     

Stabilization loop of a two axes gimbal system using self-tuning PID type fuzzy controller

The application of inertial stabilization system is to stabilize the sensor's line of sight toward a target by isolating the sensor from the disturbances induced by the operating environment. The aim of this paper is to present two axes gimbal system. The gimbals torque relationships are derived using Lagrange equation considering the base angular motion and dynamic mass unbalance. The stabilization loops are constructed with cross coupling unit utilizing proposed fuzzy PID type controller. The overall control system is simulated and validated using MATLAB. Then, the performance of proposed controller is evaluated comparing with conventional PI controller in terms of transient response analysis and quantitative study of error analysis. The simulation results obtained in different conditions prove the efficiency of the proposed fuzzy controller which offers a better response than the classical one, and improves further the transient and steady-state performance.     

Transport phenomena within the liquid phase of a laboratory-scale circular methanol pool fire

The effects of altering the lower thermal boundary condition of a methanol pool from −5 °C to 50 °C was investigated within a 90 mm diameter and 12 mm deep quartz burner under steady state burning condition in a quiescent air environment. Both the burning rate and the flame height were observed to increase by 15% with increasing bottom temperature over this range of bottom boundary conditions. The temperature and velocity within the liquid were measured by a single thermocouple traversed through the pool and PIV, respectively, in order to better understand the transport of mass and energy in the liquid. Temperature measurements revealed a distinct two-layer vertical thermal structure with the upper layer of the pool being almost uniform and near the boiling temperature of the fuel, while the lower layer experienced an increasing temperature gradient as the bottom boundary temperature was lowered. The thickness of the thermally uniform layer increased as the bottom temperature was increased. The measured fluid velocity showed a complementary two-layer structure with the upper layer being dominated by a pair of counter-rotating vortices that kept this portion of the liquid well mixed and transferred heat from the hot pool wall to the pool center, while the flow in the lower layer was uniformly low in value and vertical. A model was presented to aid in understanding the energy transfer within the liquid phase. In the lower layer, the Peclet Number was in the order of unity and required that the energy transfer throughout the liquid phase to be modeled as a combination of conduction and convection. Using this physical model, the change in burning rate over the full 55 °C change in bottom temperature was predicted within 2%, thereby supporting the proposed mechanism for energy transfer into the pool’s depth.     

Mathematical modelling of mass transfer in the concentration polarisation layer of flat‐sheet membranes during clarification of pomegranate juice

Evaluation of membrane clarification of pomegranate juice showed that a cake layer is created at the beginning of the process. This evaluation was used as the basis for modelling the solute concentration in the concentration polarisation layer to control the fouling of the membrane. The model of changes in concentration as a function of time and distance (in its dimensionless form) was solved numerically using the Forward‐Time/Central‐Space (FTCS) method. Programming was performed using MATLAB software, and the predicted concentration on the membrane surface was compared with experimental data; the prediction fit well with the experimental data. The model showed that the solute concentration increased as distance to the membrane surface decreased, time increased, transmembrane pressure increased and velocity decreased. Also, the model matched the experimental data in that it showed the cake layer to be created in the early stages of the membrane clarification process.     

Paleomagnetic evidence of a low-temperature origin of carbonate in the Martian meteorite ALH84001

Indirect evidence for life on Mars has been reported from the study of meteorite ALH84001. The formation temperature of the carbonates is controversial; some estimates suggest 20 degrees to 80 degrees C, whereas others exceed 650 degrees C. Paleomagnetism can be used to distinguish between these possibilities because heating can remagnetize ferrimagnetic minerals. Study of two adjacent pyroxene grains from the crushed zone of ALH84001 shows that each possesses a stable natural remanent magnetization (NRM), implying that Mars had a substantial magnetic field when the grains cooled. However, NRM directions from these particles differ, implying that the meteorite has not been heated significantly since the formation of the internal crushed zone about 4 billion years ago. The carbonate globules postdate this brecciation, and thus formed at low temperatures.