Effect of gamma irradiation on the optical properties of CR-39 polymer

The UV-Visible absorption spectra of virgin and gamma irradiated (20–800 kGy) CR-39 polymer have been deduced by using Shimadzu Double beam Double Monochromator UV-Visible Spectrophotometer (UV-2550). The existence of the peaks, their shifting and broadening as a result of gamma irradiation has been discussed. Finally the indirect and direct band gap in virgin and gamma irradiated CR-39 has been determined. The values of indirect band gap have been found to be lower than the corresponding values of direct band gap.     

为RS-232C接口通信设计可视光链路

图1所示的设计是一条看得见的光链路,可供需要观看被传送的数据的人使用。该设计的一个附加优点是隔离电平高达5000V以上。对该系统的测试使用了数据采集系统的COM输入端以及标准PC的COM端口。MC1489将RS-232C的数据变换成TTL信号,7404门电路再将TTL信号倒相。7404的输出信号驱动Q1,即2N3055型功率晶体管。该功率晶体管驱动3只发光二极管(LED),以组成一个光源。     

Model for drying during fluidized-bed combustion of wet low-rank coals

An unsteady state heat conduction model with a convective boundary condition is proposed for the drying of low-rank, high-porosity coals, such as lignites, during fluidized-bed combustion. The drying front is assumed to be the receding surface of a wet core. The solution technique for this moving boundary problem is based on the heat balance integral approach with immobilization of the moving boundary by a change in space variable. The governing cubic equation describing the drying curve in dimensionless form may be solved easily by the Newton—Raphson method. The model predictions are compared with experimental data for Mississippi lignite with excellent agreement. A correlation for estimation of total drying time is proposed. The temperature profiles obtained may be used for the study of the coupled drying and devolatilization in fluidized-bed combustors. The profiles could also be of importance in the study of formation of fissures/cracks in lignites subjected to intense heating conditions encountered during fluidized-bed combustion.     

Experimental investigation of impact of diesel particulate filter on smoke and NO<Subscript>x</Subscript> emissions of a Euro-I compression ignition engine with active and off-board regeneration

Old engines (Euro III or earlier) produce more emissions, and it will be difficult to entirely stop their usage especially in developing and under-developed nations; hence, it is desired that appropriate emission reduction technologies are tested on such engines to analyze their feasibility and economical acceptability. While most such studies have been conducted on constant speed stationary engines and modern engines, this study tried to analyze the effectiveness of an uncoated wall-flow type ceramic diesel particulate filter on a Euro-I, water-cooled, direct injection, variable speed, compression ignition engine in a laboratory set-up in India. Also, this study focused on diesel particulate filter regeneration by two methods: active regeneration by diesel injection in the particulate filter using an electronic control unit and off-board regeneration by taking out and heating the diesel particulate filter in an electrical resistance furnace at 650 °C for 10 h. The results, in the form of smoke emission, NO_x emission and engine performance, obtained using both the regeneration methods were analyzed, and conclusions were drawn. It was found that using diesel particulate filter, particulate matter emissions (smoke) were almost entirely eliminated. It was also found that off-board regeneration had numerous advantages compared to active regeneration. Since a furnace would be needed for off-board regeneration, an exchange process for diesel particulate filter is suggested.     

Note: Compact high voltage pulse transformer made using a capacitor bank assembled in the shape of primary

The experimental results of an air-core pulse transformer are presented, which is very compact (<10 Kg in weight) and is primed by a capacitor bank that is fabricated in such a way that the capacitor bank with its switch takes the shape of single-turn rectangular shaped primary of the transformer. A high voltage capacitor assembly (pulse-forming-line capacitor, PFL) of 5.1 nF is connected with the secondary of transformer. The transformer output voltage is 160 kV in its second peak appearing in less than 2 μS from the beginning of the capacitor discharge. The primary capacitor bank can be charged up to a maximum of 18 kV, with the voltage delivery of 360 kV in similar capacitive loads.     

Trout‐Skin Gelatin‐Based Edible Films Containing Phenolic Antioxidants: Effect on Physical Properties and Oxidative Stability of Cod‐Liver Oil Model Food

Abstract: Trout‐skin (Oncorhynchus mykiss) gelatin‐based films containing antioxidants (epigallocatechin gallate (EGCG), 50 and 250 ppm w/w) and green tea powder (1% and 20% w/w of gelatin) were tested for tensile strength, elastic modulus, and elongation, and oxygen and water vapor transmission rates, in vitro antioxidant activity using the DPPH (2,2‐diphenyl‐1‐picrylhydrazyl) assay and effect on stabilizing cod‐liver oil held under mild thermal abuse conditions. Cod‐liver oil overlaid with films was stored at 40 °C for 20 d and analyzed for peroxide value (PV) and thiobarbituric acid reactive substances (TBARS). Antioxidant activity was retained in films containing green tea powder, but was reduced (P < 0.05) in EGCG films (20 d, 23 °C). Water vapor transmission rate of the films incorporated with antioxidants did not change significantly (P > 0.05), but the oxygen transmission rate for films with 50 ppm EGCG and 20% green tea powder was significant (P < 0.05). Other physical properties varied with antioxidant incorporation. The TBARS and PV of control oil increased from 0.05 ± 0.01 to 4.71 ± 0.30 g MDA/kg oil and from 3.6 ± 0.2 to 178.3 ± 24.5 millieq peroxides/kg oil, respectively, after 20 d. For cod‐liver oil covered with control or antioxidant‐containing films, TBARS remained below 0.37 g MDA/kg oil and PV below 7 millieq peroxides/kg oil. Incorporation of antioxidants to the films did not reduce oil oxidation (P > 0.05) at the levels tested and this was confirmed by activation energy calculations. The rate of oil oxidation was more dependent upon the inherent oxygen barrier property of the films than the presence of antioxidants. Practical Application: This research has the potential to enhance the utilization of fish skins, a valuable food processing by‐product, as edible films with natural antioxidants to extend the shelf life of foods. The film physical properties and barrier to oxygen and water are investigated.     

Holding State Performance Amelioration by Exploitation of NMOS Body Effect in 1T DRAM Cells

In this study curtailing of idle current in 1T1C and 1T1M DRAM cells by increasing threshold voltage during holding state is analyzed. This is attained by connecting the bulk to source in the active phases and pulling it below source potential throughout the holding phase. The proposed technique leads to body effect which affects the threshold voltage improving leakage current. The 1T1C and 1T1M discussed in this paper are volatile and non-volatile (memristor based) respectively. Memory design is fast becoming the pacemaker in the modern technology design which now requires DRAM cells with prolonged holding period and low idle power hence the need for lowering the leakage current. The dynamic nature of the 1T1C is due to charge leakage and the leakage current flowing through the 1T1M cell affects mem-resistance all this leading to state distortion. Idle current has of-late become one of the major contributors of power in large memory arrays in which in-active periods now dominates active period and by this technique idle power is reduced in both volatile and non-volatile cells. The proposed technique was implemented and simulations were done at different voltage levels at 45 nm technology. The method improved the leakage current, holding time and leakage power but at the expense of area and writing power.