Simultaneous removal of cyanobacterial blooms and production of clean water by coupling flocculation with a rotary drum filter

Environmental Science and Pollution Research - A mechanical harvesting technology based on coupling flocculation with a rotary drum filter (RDF, 35-μm) was applied to remove cyanobacterial...     

Subsurface nutrient modelling using finite element model under Boro rice cropping system

Boro rice, an emerging low-risk crop variety of rice, cultivated using residual or stored water after Kharif season. To enhance the quality and production of rice, potassium (K) and phosphorus (P) are the common constituents of agricultural fertilizers. However, excess application of fertilizers causes leaching of nutrients and contaminates the groundwater system. Therefore, assessment and optimization of fertilizer dose are needed for better management of fertilizers. Towards this, the present study determines the path, persistence, and mobility of K and P under the Boro rice cropping system. The experimental site consisted of four plots having Boro rice with four different fertilizer doses of nitrogen (N), P, K viz. 100%, 75%, 50%, and 25% of the recommended dose. Disturbed soil samples were analysed for K and P from pre-sown land to tillering stage at 0–5, 5–10, 10–15, 15–30, 30–45, and 45–60 cm depths. Simultaneously, K and available P were also simulated in the subsurface soil layers through the HYDRUS-1D model. The statistical comparisons were made with RMSER, E, and PBIAS between the modelled values and laboratory-measured values. Although, the results showed that all the treatments considered had agreeable simulations for both K and P, the K simulations were found to be better as compared to P simulations except for 25% where P simulations outperformed K. The simulated concentration at all doses was found most appropriate when measured for the subsurface layers (up to 45 cm), while showed an underestimation in the bottom layers (45–60 cm) of soil.

     

Injection-Molded Bioblends from Lignin and Biodegradable Polymers: Processing and Performance Evaluation

This paper investigates the effects of the incorporation of lignin and small quantities of epoxidized natural rubber (ENR) as an impact modifying agent on blends of poly(3-hydroxybutyrate-co-3-hydroxyvalerate) (PHBV) and poly(ε-caprolactone) (PCL). The addition of lignin resulted in a slight improvement of flexural strength and modulus of the ternary blending system. Incorporation of ENR into the blend resulted in an increase in notched Izod impact strength from 40 to 135% depending on the concentration of ENR. The addition of lignin into the blend resulted in an improvement of thermal stability of the ternary blend system. Morphological analysis showed a good dispersion of PHBV phases and lignin within the PCL matrix. Rheological characterization revealed that the presence of lignin resulted in increased storage modulus of the bioblend.     

Determination of the residue dynamics and dietary risk of thiamethoxam and its metabolite clothianidin in citrus and soil by LC-MS/MS

A modified quick, easy, cheap, effective, rugged and safe (QuEChERS) method was developed for the determination of thiamethoxam and its metabolite clothianidin in citrus (including the whole citrus, peel and pulp) and soil samples by liquid chromatography-tandem mass spectrometry. The sample was extracted with acetonitrile and purified with octadecylsilane. The detection limits of both compounds were 0.0001–0.0002?mg kg^–1, while the limit of quantification of thiamethoxam was 0.002?mg kg^–1 and the limit of quantitation of metabolites was 0.001?mg kg^–1. The recovery was 70.37%–109.76%, with inter-day relative standard deviations (RSD) (n?=?15) values ≤9.46% for the two compounds in the four matrices. The degradation curve of thiamethoxam in whole citrus and soil was plotted using the first-order kinetic model. The half-life of the whole citrus was 1.9–6.2?days, and the half-life of the soil was 3.9–4.2?days. The terminal residue of thiamethoxam (the sum of thiamethoxam and clothianidin, expressed as thiamethoxam) was found to be concentrated on the peel. The final residual amount of thiamethoxam in the edible portion (pulp) was less than 0.061?mg kg^–1. The risk quotient values were all below 1, indicating that thiamethoxam as a citrus insecticide does not pose a health risk to humans at the recommended dosage.     

Assessing groundwater quality and its sustainability in Joypurhat district of Bangladesh using GIS and multivariate statistical approaches

Sustainable groundwater quality is a key global concern and has become a major issue of disquiets in most parts of the world including Bangladesh. Hence, the assessment of groundwater quality is an important study to ensure its sustainability for various uses. In this study, a combination of multivariate statistics, geographical information system (GIS) and geochemical approaches was employed to evaluate the groundwater quality and its sustainability in Joypurhat district of Bangladesh. The results showed that the groundwater samples are mainly Ca–Mg–HCO₃ type. Principal component analysis (PCA) results revealed that geogenic sources (rock weathering and cation exchange) followed by anthropogenic activities (domestic sewage and agro-chemicals) were the major factors governing the groundwater quality of the study area. Furthermore, the results of PCA are validated using the cluster analysis and correlation matrix analysis. Based on the groundwater quality index (GWQI), it is found that all the groundwater samples belong to excellent to good water quality domains for human consumption, although iron, fluoride and iodide contaminated to the groundwater, which do not pose any significant health hazard according to World Health Organization’s and Bangladesh’s guideline values. The results of irrigation water quality index including sodium adsorption ratio (SAR), permeability index and sodium percentage (Na %) suggested that most of the groundwater samples are good quality water for agricultural uses. The spatial distribution of the measured values of GWQI, SAR, Fe (iron), EC (electrical conductivity) and TH (total hardness) were spatially mapped using the GIS tool in the study area.     

Fluoride removal and its impact on oral health in Sri Lanka's dry zone: Discussion and recommendation

Fifty percent of the dry zone areas in Sri Lanka have fluoride levels above 1 ppm. This paper discusses the ground conditions and recommends an appropriate range of fluoride in drinking water which can support preventive practices for improving the oral health of children 8-years old and younger. In efforts to address the Chronic Kidney Disease of Unknown etiology (CKDU), water treatment to reduce contaminant level in potable water has been implemented. Such treatment would also remove fluoride and has resulted in potable water with various fluoride levels, depending on concentrations in the raw water. While it is important to reduce fluoride levels, it is important to have appropriate residual levels for prevention of dental caries. It needs, however, to be noted fluoride in excess can cause dental fluorosis. In Sri Lanka's dry zone areas increasing prevalence of dental fluorosis with decreasing prevalence of dental caries has been noted. Consumption of tea and powdered milk could increase total intake of fluoride. Fluoridated toothpaste, when used properly, may, however, result in negligible intake of fluoride. Sri Lanka's hot tropical climate which results in substantial intake of fluids reinforces the need to consider reduction in water fluoride. Consideration of local studies and international standards indicate fluoride levels should be in the range of 0.225–0.500 ppm. In the range of 0.225–0.500 ppm, the prevalence of dental fluorosis and caries was only 14% and 8%, respectively, in an endemic district. When fluoride levels are above 0.500 ppm, the issue of dental fluorosis shall need to be addressed. When levels are below 0.225 ppm, oral health care services shall need to be directed at preventing dental caries.     

Improvement of Impact Toughness of Biodegradable Poly(butylene succinate) by Melt Blending with Sustainable Biobased Glycerol Elastomers

Poly(butylene succinate) (PBS) was melt blended with glycerol based polyesters (PGS) synthesized from pure and technical glycerol aiming to improve the impact strength of PBS. It was found that after addition of 30 wt% PGS to PBS its impact strength was significantly increased by 344% (from 31.9 to 110 J/m) and its elongation at break was maintained at 220%. Infrared spectra of the blends showed the presence of hydroxyl groups from the PGS phase suggesting that hydrogen bonding between the phases could be responsible for a good stress transfer and an efficient toughening in the PBS/PGS blends. Scanning electron microscopy imaging showed a good dispersion of PGS phase into PBS with a PGS particle size of 10 μm and less and no agglomeration. Addition of PGS to PBS was shown to be an effective strategy for improvement of PBS impact resistance without serious detrimental effects on its thermal and rheological properties.     

Greenlandic water and sanitation systems—identifying system constellation and challenges

A good water supply and wastewater management is essential for a local sustainable community development. This is emphasized in the new global goals of the UN Sustainable Development, where the sixth objective is to: “Ensure availability and sustainable management of water and sanitation for all” (United Nations 2015). This obviously raises the question of how this can be achieved considering the very different conditions and cultures around the globe. This article presents the Greenlandic context and elucidates the current Greenland water supply system and wastewater management system from a socio-technical approach, focusing on the geographic, climatic and cultural challenges. The article identifies a diverse set of system constellations in different parts of Greenland and concludes with a discussion of health and quality of life implications.     

Traditional agriculture in transition: examining the impacts of agricultural modernization on smallholder farming in Ghana under the new Green Revolution

Following the renewed effort at achieving a new green revolution for Africa, emphasis has been placed on modernizing smallholder agriculture through the deployment of improved inputs especially mechanized technologies. In Ghana, the government has in the last decade emphasized the provision of subsidized mechanized ploughing services to farmers alongside a rapidly growing private sector tractor service market. While mechanized technology adoption rates have increased rapidly, the deployment of these technologies has been without critical analysis of the impacts on production patterns and local agrarian systems. This paper examines the distributional impacts of agriculture mechanization on cropping patterns and farm sizes of smallholder farmers in northern Ghana using Geographic Information Systems (GIS) techniques, and semi-structured interviews with smallholder farmers (n=60). Specifically, comparative analysis of the field sizes and cropping patterns of participant farmers prior to and after the adoption of mechanized technologies was conducted. In-depth interviews were used to contextualize the experiences of smallholder farmers toward understanding how mechanization may be impacting traditional agriculture. Our findings reveal a mechanization paradox in which farm sizes are expanding, while cropping patterns are shifting away from traditional staple crops (pearl millet and sorghum bicolor) to market-oriented crops (maize, rice and groundnuts). This transition we argue, has adverse implications on the cultural dimension of food security, the organization of social life, and climate change adaptation. We recommend a retooling of the current agricultural policy focus to ensure context sensitivity for a more robust battle against food insecurity.