颗粒物质金属形态逐级提取技术问题的探讨

本文综述了国内外对颗粒物质中金属形态逐级提取测定技术方面的研究情况，重点阐述了颗粒物质金属形态分离方法，并对各相态的浸取技术和金属总量提取方法进行了讨论．从而为开展颗粒物质的金属化学形态的分析和研究，提出几点认识．     

水泥窑共处置过程中水泥生料对砷的吸附/冷凝特性

针对水泥生料开展了氮吸附与SEM测试分析,研究了水泥生料的比表面积,孔径结构和微观表面积。同时,利用管式回转炉和控温立式炉联用装置研究了砷元素在水泥生料上的吸附冷凝特性。结果表明,水泥生料的比表面积很小,微观表面结构致密无孔,砷元素主要是冷凝在生料表面上。进入吸附冷凝炉的重金属可以分为3部分,第1部分冷凝在管壁上,占80%左右;第2部分吸附/冷凝在生料上,占10%左右;第3部分随烟气释放到空气中,不到10%。水泥生料对砷的吸附冷凝量随时间的增加而增加,随温度的升高而降低。水泥生料对砷的吸附冷凝特性可用双常数速率方程拟合,拟合效果较好,计算得表观活化能在6~7 kJ/mol之间。此外,砷的初始浓度对水泥生料的吸附冷凝特性影响很小。     

酸性矿井水中和沉淀法除铁优化

针对山西某煤矿高矿化度、高铁酸性矿井水除铁效果差、出水容易返色等问题,采用NaOH中和调pH、曝气及化学氧化等处理工艺进行酸性矿井水中和沉淀法除铁优化实验研究。结果表明,采用NaOH中和沉淀法除铁时,投加中和剂使出水pH达6.7以上时,出水中铁含量低于10 mg/L,满足排放要求。对于本实验废水NaOH所需投加量为2.8 g/L,铁的去除率可达到99.75%;以H2O2对原水进行氧化处理,可迅速将Fe(Ⅱ)氧化成Fe(Ⅲ),其用量与原水中Fe(Ⅱ)的含量成正比。当其用量为1.6 mL/L时,可将原水中的Fe(Ⅱ)完全转化为Fe(Ⅲ),投加中和剂使出水pH达到4.5以上时,能使出水中铁含量满足排放要求。对于实验废水所需的NaOH投加量为2.0 g/L,比直接中和沉淀所需的NaOH用量要节省28.6%。曝气处理对原水中Fe(Ⅱ)的氧化效果不明显。     

基于安全度与运营格局的油库选址优先级评价方法研究

从安全性和运营角度对油库选址的影响因素及评价指标分析对油库的安全稳定及有效运营具有重要的意义。该文选取与安全和运营有关的人口企业数量、安全管理能力、消防设施规划、地形地质条件、铁路公路数量、市场投资收益、政策支持情况等影响因子进行重要性及合理程度分析,综合运用安全度与运营格局影响因素多元耦合关系,构建了油库区安全与运营评价体系,改进了原有的模糊层次法评价模型,并对某油库区安全度与运营格局进行了评估验证。结果表明:利用改进模糊层次法能够较好地评价不同地址的优先级,评价模型具有一定应用性,能够对不同地址的特点及评价权重进行有效分析,可见油库选址优先级评价方法是实用且有效的。该研究方法及结果可以为油库区地址的优选提供一定参考与建议。     

过氧化钙缓释材料对河道水固磷及底泥控磷的机理研究

用聚乙二醇2000(PEG2000)和硬脂酸(SA)包埋粉末过氧化钙(CP)成功制备了CP缓释材料CP@PEG2000-SA。比较了粉末CP和CP@PEG2000-SA对上覆水中溶解性总磷的影响和对底泥中磷酸铝盐(Al-P)、磷酸铁盐(Fe-P)和磷酸钙盐(Ca-P)的影响。结果表明,CP@PEG2000-SA投加量宜为1.8kg/m2,在CP用量相同的条件下计算得到粉末CP投加量为1.0kg/m~2。投加粉末CP在10d内上覆水中溶解性总磷浓度迅速降至最低后又上升,而投加CP@PEG2000-SA可以实现35d内溶解性总磷持续缓慢下降。上覆水中的内源性磷一般来自底泥中Fe-P的释放。投加粉末CP虽能固定Fe-P含量,但起不到长效作用,甚至可能导致Al-P的释放。投加CP@PEG2000-SA可控制氧气释放速率,稳定pH,使得上覆水中溶解性总磷向底泥中的Al-P、Ca-P和Fe-P转化,起到长效抑制底泥中内源性磷向水体释放并同时吸收水体中磷的双重效应,达到了控磷目的。     

Mechanism of the intermittent motion of two-phase debris flows

A typical two-phase debris flow exhibits a high and steep flow head consisting of rolling boulders and cobbles with intermittent or fluctuating velocity. The relative motion between the solid phase and the liquid phase is obvious. The motion of a two-phase debris flow depends not only on the rheological properties of the flow, but also on the energy transmission between the solid and liquid phases. Several models have been developed to study two-phase debris flows. An essential shortcoming of most of these models is the omission of the interaction between the two phases and identification of the different roles of the different materials in two-phase debris flows. The tracer particles were used for the velocity of solid phase and the velocity of liquid phase was calculated by the water velocity on the surface of the debris flow in the experiments. This paper analyzed the intermittent feature of two-phase debris flows based on videos of debris flows in the field and flume experiments. The experiments showed that the height of the head of the two-phase debris flow increased gradually in the initiation stage and reached equilibrium at a certain distance from the start of the debris flow. The height growth and the velocity of the flow head showed fluctuating characteristics. Model equations were established and the analyses proved that the average velocity of the two-phase debris flow head was proportional to the flood discharge and inversely proportional to the volume of the debris flow head.     

UV/Fenton技术处理某工厂高浓度乳化油废水

研究了UV/Fenton技术对高浓度金属清洗乳化油废水的处理效果,考察了亚铁与双氧水浓度、pH、反应时间和搅拌对COD去除效果的影响。实验结果表明,UV/Fenton技术对高浓度乳化油废水(COD平均浓度为35 000 mg/L)具有较高的去除效果,最佳工艺条件为:亚铁与双氧水浓度分别为2 400 mg/L和6 000 mg/L,pH为3,经过2 h反应,COD可降低至1 050 mg/L,去除率为97%。搅拌会降低COD的去除率。研究表明,UV/Fenton技术对高浓度乳化油废水具有很好的降解效果,且药品消耗较低,为目前此类高浓度有机废水的处理提供了技术参考。     

邻苯二甲酸二丁酯暴露对雄性大鼠生精细胞功能影响

观察不同剂量的邻苯二甲酸二丁酯(DBP)对成年大鼠生精细胞损伤、端粒酶和端粒酶逆转录酶(TERT)表达影响.对40只健康雄性SD大鼠随机分成4组,分别为500mg·kg-1·d-1、250mg·kg-1·d-1、50mg·kg-1·d-1 3个染毒组和1个对照组,灌胃量为5mL·kg-1体重,灌胃法连续给药6周.对体重...     

Arbuscular mycorrhizal fungi alter the response of growth and nutrient uptake of snap bean（Phaseolus vulgaris L.） to O_3

The effects of arbuscular mycorrhizal fungi (AMF) Glomus mosseae on the responses to elevated O3 in growth and nutrition of snap bean (Phaseolus vulgaris L. cv Guangzhouyuan) were investigated. Exposure was conducted in growth chambers by using three O3 concentrations (20 (CF), 80 (CFO1) and 120 nL/L (CFO2); 8 hr/day for 75 days). Results showed that elevated O3 slightly impacted overall mycorrhizal colonization, but significantly decreased the proportional frequency of hypha and increased the proportional frequency of spores and vesicles, suggesting that O3 had significant effects on mycorrhizal structure. Elevated O3 significantly decreased yield, dry mass and nutrient contents (N, P, K, Ca and Mg) in both non-mycorrhizal and mycorrhizal plants. However, significant interactive effects were found in most variables due to that the reduction by O3 in the mycorrhizal plants was less than that in the non-mycorrhizal plants. Additionally, AMF increased the concentrations of N, P, Ca, and Mg in shoot and root. It can be concluded that AMF alleviated detrimental effects of increasing O3 on host plant through improving plant nutrition and growth.     

Biostability in distribution systems in one city in southern China：Characteristics, modeling and control strategy

This study investigated the bacterial regrowth in drinking water distribution systems receiving finished water from an advanced drinking water treatment plant in one city in southem China. Thirteen nodes in two water supply zones with different aged pipelines were selected to monitor water temperature, dissolved oxygen （DO）, chloramine residual, assimilable organic carbon （AOC）, and heterotrophic plate counts （HPC）. Regression and principal component analyses indicated that HPC had a strong correlation with chloramine residual. Based on Chick-Watson＇s Law and the Monod equation, biostability curves under different conditions were developed to achieve the goal of HPC 100 CFU/mL. The biostability curves could interpret the scenario under various AOC concentrations and predict the required chloramine residual concentration under the condition of high AOC level. The simulation was also carded out to predict the scenario with a stricter HPC goal （≤50 CFU/mL） and determine the required chloramine residual. The biological regrowth control strategy was assessed using biostability curve analysis. The results indicated that maintaining high chloramine residual concentration was the most practical way to achieve the goal of HPC ≤ 100 CFU/mL. Biostability curves could be a very useful tool for biostability control in distribution systems. This work could provide some new insights towards biostability control in real distribution systems.