Morphological stability of copper-silver multilayer thin films at elevated temperatures

The kinetics of breakdown of Cu-Ag polycrystalline multilayers during aging at elevated temperatures was investigated. Microlaminates with Cu:Ag layer thicknesses of 2:2, 1:4, 4:1, and 4:0.1 μm were aged for 10 minutes to 192 hours (t), at temperatures ranging from 700 to 900 K. The asdeposited microlaminates had a fine-grained columnar microstructure with well-defined interfaces. Upon annealing, the morphology evolved over three time regimes. In the first regime, the grains in each phase grew quickly to an apparent terminal size, which depended on both the layer thickness and annealing temperature. Next, grooves formed at the intersections of grain boundaries and layer interfaces and grew with a t ^0.25 dependence. The groove growth appeared to be independent of layer thickness and was approximately equal in Cu and Ag. The microlaminates started to break down in the third regime, as grain-boundary grooves on opposite sides of a layer bridged its thickness. Models for grain growth and grooving in thin films were modified for multilayer microlaminates and were shown to fit the experimental data reasonably well. This suggests that the terminal grain size is reached when groove drag overcomes the capillary forces driving grain growth, and that grooving kinetics are dominated by interfacial diffusion.     

Friction factors for flow of near-critical helium in curved tubes

Friction factors have been measured for turbulent flow, 1.9(10)⁴ < Re < 1.1(10)⁵, of near critical helium in a helically wound (D/d = 194) circular, 4-mm id tube of high aspect ratio (L/d = 4.6(10)⁴). These measurements are in close agreement with the classical results of lto for curved pipes. Measured pressure drops in a heated test section with large fluid expansion ratios (Δv/v up to 13) agreed well with calculated pressure drops. Results are also given for a 1.32 mm diameter sharp edge orifice flow meter operating in near-critical-helium.     

Mechanism of alamethicin insertion into lipid bilayers

Alamethicin adsorbs on the membrane surface at low peptide concentrations. However, above a critical peptide-to-lipid ratio (P/L), a fraction of the peptide molecules insert in the membrane. This critical ratio is lipid dependent. For diphytanoyl phosphatidylcholine it is about 1/40. At even higher concentrations P/L > or = 1/15, all of the alamethicin inserts into the membrane and forms well-defined pores as detected by neutron in-plane scattering. A previous x-ray diffraction measurement showed that alamethicin adsorbed on the surface has the effect of thinning the bilayer in proportion to the peptide concentration. A theoretical study showed that the energy cost of membrane thinning can indeed lead to peptide insertion. This paper extends the previous studies to the high-concentration region P/L > 1/40. X-ray diffraction shows that the bilayer thickness increases with the peptide concentration for P/L > 1/23 as the insertion approaches 100%. The thickness change with the percentage of insertion is consistent with the assumption that the hydrocarbon region of the bilayer matches the hydrophobic region of the inserted peptide. The elastic energy of a lipid bilayer including both adsorption and insertion of peptide is discussed. The Gibbs free energy is calculated as a function of P/L and the percentage of insertion phi in a simplified one-dimensional model. The model exhibits an insertion phase transition in qualitative agreement with the data. We conclude that the membrane deformation energy is the major driving force for the alamethicin insertion transition.     

Habit-specific locus of control scales for drinking, smoking, and eating

A modified version of capillary isoelectric focusing (cIEF) was developed to separate hemoglobin variants contained within single human erythrocytes. Laser-induced native fluorescence with 275 nm excitation was used to detect the separated hemoglobins. In this method, baseline fluctuations were minimized and detection sensitivity was improved by using dilute solutions of anolyte, catholyte, and carrier ampholytes (with methylcellulose). Since electroosmotic flow was used for mobilization of the focused bands, separation and detection were integrated into a single step. The capillary was first filled with only ampholyte solution, and the cell (or standard) was injected as in capillary zone electrophoresis. The approximately 90 fl injection volume for individual cells is 7 x 10(4) times lower than those previously reported. Adult (normal and elevated A1), sickle (heterozygous), and fetal erythrocytes were analyzed with the amounts of hemoglobins AO, A1c, S and F determined. The pH gradient for cIEF was linear (r = 0.9984), which allowed tentative identification of Hb Fac. Variants differing by as little as 0.025 pl units were resolved.     

Membrane thinning caused by magainin 2

Magainin 2 is a 23-residue antibiotic peptide found in the skin of Xeonpus laevis (African clawed frog). It belongs to a broad class of alpha-helical peptides which interact directly with the lipid bilayer. Very little is presently known about the nature of this peptide/lipid interaction on the molecular level. We have performed a sequence of lamellar X-ray diffraction experiments to provide some insight into the nature of this interaction. We have found that, at concentrations below the critical concentration for lysis, the peptide causes the membrane thickness to decrease roughly in proportion to the peptide concentration. We further show that this thinning is consistent with a model where the peptide adsorbs within the headgroup region of the lipid bilayer at these concentrations. The energy cost of this thinning may also explain why the peptide inserts at high concentrations. We have already shown that a similar interaction exists for alamethicin interacting with diphytanoylphosphatidylcholine, and it should hold for a wide variety of peptide/lipid systems.     

A mixture model for population codes of Gabor filters

Population coding is a coding scheme which is ubiquitous in neural systems, and is also of more general use in coding stimuli, for example in vision problems. A population of responses to a stimulus can be used to represent not only the value of some variable in the environment, but a full probability distribution for that variable. The information is held in a distributed and encoded form, which may in some situations be more robust to noise and failures than conventional representations. Gabor filters are a popular choice for detecting edges in the visual field for several reasons. They are easily tuned for a variety of edge widths and orientations, and are considered a close model of the edge filters in the human visual system. In this paper, we consider population codes of Gabor filters with different orientations. A probabilistic model of Gabor filter responses is presented. Based on the analytically derived orientation tuning function and a parametric mixture model of the filter responses in the presence of local edge structure with single or multiple orientations a probability density function (pdf) of the local orientation in any point (x, y) can be extracted through a parameter estimation procedure. The resulting pdf of the local contour orientation captures not only angular information at edges, corners or T-junctions but also describes the certainty of the measurement which can be characterized in terms of the entropy of the individual mixture components.