High areal capacitance of FeOOH-carbon nanotube negative electrodes for asymmetric supercapacitors

The relatively low capacitance of negative electrodes, as compared to the capacitance of advanced positive electrodes, poses a serious problem, since this limits the development of asymmetric supercapacitor (SC) devices with a large voltage window and enhanced power-energy characteristics. We fabricate negative SC electrodes with a high capacitance that match the capacitance of advanced positive electrodes at similar active mass loadings, as high as 37?mg?cm^?2. Cyclic voltammetry, impedance spectroscopy, galvanostatic charge-discharge data and the power-energy characteristics of the asymmetric SC device exhibit good electrochemical performance for a voltage window of 1.6?V. Our approach involves the development and application of particle extraction through liquid-liquid interface (PELLI) methods, new extraction mechanisms and efficient extractors to synthesize α-FeOOH and β-FeOOH electrode materials. The use of PELLI allows agglomerate-free processing of powders, which facilitates their efficient mixing with multiwalled carbon nanotubes (MWCNT) and allows improved electrolyte access to the particle surface. Experiments to determine the properties of FeOOH-MWCNT composites provided insight into the influence of the electrode material and the structure of extractor molecules on the composite properties. The highest capacitance of 5.86?F?cm^?2 for negative electrodes and low impedance were achieved using α-FeOOH-MWCNT composites and a 16-phosphonohexadecanoic acid (PHDA) extractor. This extractor allows adsorption on particles, not only at the liquid-liquid interface, but also in the bulk aqueous phase and can potentially be used as a capping agent for particle synthesis and as an extractor in the PELLI method.     

Scaling planar silicon devices

The generation-over-generation scaling of critical CMOS technology parameters is ultimately bound by nonscalable limitations, such as the thermal voltage and the elementary electronic charge. Sustained improvement in performance and density has required the introduction of new device structures and materials. Partially depleted SOI, a most recent MOSFET innovation, has extended VLSI performance while introducing unique idiosyncrasies. Fully depleted SOI is one logical extension of this device design direction. Gate dielectric tunneling, device self-heating, and single-event upsets present developers of these next-generation devices with new challenges. Strained silicon and high-permittivity gate dielectric are examples of new materials that will enable CMOS developers to continue to deliver device performance enhancements in the sub-100 nm regime.     

Properties of poly(ethylene terephthalate)–poly(ethylene naphthalene 2,6‐dicarboxylate) blends with montmorillonite clay

The production and properties of blends of poly(ethylene terephthalate) (PET) and poly(ethylene naphthalene 2,6‐dicarboxylate) (PEN) with three modified clays are reported. Octadecylammonium chloride and maleic anhydride (MAH) are used to modify the surface of the montmorillonite–Na⁺ clay particles (clay–Na⁺) to produce clay–C18 and clay–MAH, respectively, before they are mixed with the PET/PEN system. The transesterification degree, hydrophobicity and the effect of the clays on the mechanical, rheological and thermal properties are analysed. The PET–PEN/clay–C18 system does not show any improvements in the mechanical properties, which is attributed to poor exfoliation. On the other hand, in the PET–PEN/clay–MAH blends, the modified clay restricts crystallization of the matrix, as evidenced in the low value of the crystallization enthalpy. The process‐induced PET–PEN transesterification reaction is affected by the clay particles. Clay–C18 induces the largest proportion of naphthalate–ethylene–terephthalate (NET) blocks, as opposed to clay–Na⁺ which renders the lowest proportion. The clay readily incorporates in the bulk polymer, but receding contact‐angle measurements reveal a small influence of the particles on the surface properties of the sample. The clay–Na⁺ blend shows a predominant solid‐like behaviour, as evidenced by the magnitude of the storage modulus in the low‐frequency range, which reflects a high entanglement density and a substantial degree of polymer–particle interactions. Copyright © 2005 Society of Chemical Industry     

Age-related changes in innervation in hypertrophic pyloric stenosis

BACKGROUND/PURPOSE: Recent reports have identified abnormal innervation of the circular muscle layer involving the fine intramuscular nerve fibers in hypertrophic pyloric stenous (HPS). HPS presenting after 3 months of age is rare. The aim of this study was to determine the distribution pattern of nerve fibers in the smooth muscle layers in HPS and correlate this with age at presentation. METHODS: Full-thickness pyloric muscle biopsy specimens were obtained from eight patients with HPS (five age 3 to 5 weeks, two age 3 months, and one age 7 months) and five controls with normal pylorus (age 5 days to 3 years). All specimens were stained with monoclonal antibody to the neural cell adhesion molecule (NCAM) using immunohistochemistry. RESULTS: There were many NCAM-positive nerve fibers in the circular and longitudinal muscle layers in the controls. No NCAM positive nerve fibers were seen in the circular or longitudinal muscle layers in the five cases of HPS in which the patients were less than 5 weeks old. In the two cases in which the patients were 3 months old, occasional NCAM-positive nerve fibers were seen in the circular layer, and moderate numbers of NCAM positive fibers were seen in the longitudinal muscle layers. Moderate numbers of NCAM-positive nerve fibers in the circular muscle layer and many NCAM positive nerve fibers in the longitudinal muscle layers were identified in the 7-month-old HPS patient. CONCLUSIONS: The data suggest that the pyloric muscle lacks innervation in the young HPS infant. Whereas, at 3 months of age the hypertrophied pyloric muscle is partially innervated, and at 7 months of age the pyloric muscle has practically normal innervation.     

Powder Deposition in Three Parallel-Oriented Dies of Different Shapes

Uniformity of bulk density distribution during the die filling process is required to minimize quality problems, such as distortion and cracking, for powder compacts. Understanding the die filling process is necessary in ensuring a uniform powder deposition. The second-generation pressure deposition tester (PDT-II) was used to investigate the deposition process and final pressure distribution of powder filling in toroidal, cylindrical, and E-shaped dies. All tests were conducted using a spray-dried free-flowing granular powder. The results indicated that for toroidal dies: (1) the area around 0° orientation (the leeward end) had the highest pressure values (1186.7 to 2498.0 Pa), with the average pressure values of the remaining area 353.7-648.0 Pa; (2) the pressure distribution was symmetrical about the centerline parallel to the feed shoe movement direction; (3) the highest feed shoe speed (500 mm/s) led to the most nonuniform pressure distribution among the three speeds; (4) higher feed shoe speed did not always result in higher final pressure values; and (5) the right die tended to have higher final pressure values (215.0 to 2498.0 Pa) than the center die (95.4 to 2052.5 Pa). For E-shaped dies: (1) the final pressure values of the middle leg (308.9 to 760.7 Pa) were higher than those of the left and the right legs (148.9 to 530.3 Pa); (2) the area along the backside had the highest final pressure value (1054.6 to 1303.8 Pa); (3) the pressure distribution was symmetrical about the centerline parallel to the feed shoe movement direction; and (4) neither the center die nor the right die always had higher pressure values than the other one at all locations. Comparison between cylindrical and toroidal dies indicated that: (1) neither of the two die shapes (cylinder and toroid) led to consistently higher or lower final pressure values at all locations and (2) for all three feed shoe speeds, the toroidal die had higher average final pressure values in the 0° orientation.     

Detection of West Nile virus by the polymerase chain reaction and analysis of nucleotide sequence variation

A polymerase chain reaction (PCR) assay was developed to rapidly detect and identify West Nile (WN) virus. The RNA from seven isolates of WN virus from six countries and four other flaviviruses (Kunjin, Japanese encephalitis, St. Louis encephalitis, and yellow fever viruses) was reverse-transcribed (RT) and amplified by PCR. The nucleotide sequences of the amplified products were determined by a rapid, automated DNA sequencing method. The WN virus RT/PCR assay detected the target gene segment of sequencing method. The WN virus RT/PCR assay detected the target gene segment of isolates from both the African-Middle Eastern group and the Indian group with a sensitivity of approximately 0.05 pg of viral RNA. Kunjin virus was the only other flavivirus tested that produced a band of the appropriate size. Five of seven WN virus isolates showed 92-98% homology in the nucleotide sequence of their PCR products. The sequence of one isolate was virtually identical to the published sequence of the Nigerian isolate (99.5% homology). No correlation was established between the degree of nucleotide homology, geographic location, time of isolation, or source of the isolates.     

Serum enzyme abnormalities in protein energy malnutrition

A semi-quantitative right coronary artery score (RCA score) was derived from the ratio of the number of the major left ventricular branches of the right coronary artery to the total of the right coronary and left circumflex arteries, to stratify the extent of perfusion in patients with right coronary artery dominance. Thirty-seven patients with one-vessel coronary disease involving a dominant right coronary artery proximal to the left ventricular branches were selected for study. Thallium scintigraphy was performed after right intracoronary injection in 11 patients, and 26 patients underwent conventional stress thallium scintigraphy (24 exercise thallium and two dipyridamole thallium scintigraphy). Thallium scores of perfusion region size after right intracoronary thallium injection and perfusion defect size in stress thallium studies were quantitated from planar thallium images. Both the RCA score and the regional thallium scores spanned over a wide range. The RCA score (range 0.23-0.85) correlated best with the posterior (70 degrees left anterior oblique view) plus lateral segment (40 degrees left anterior oblique view) thallium score (r = 0.88 and 0.53 for intracoronary and stress thallium studies respectively). It also correlated with the summed thallium scores in the posterior, lateral, apical and inferior segments (r = 0.73 and 0.54 respectively) but not with thallium scores in the apex or inferior segment alone. The proposed RCA score quantitates the variable posterolateral perfusion territory of the right coronary artery, and could stratify the area of myocardium at risk from coronary stenosis in the majority of patients with right coronary dominance.     

Active collagen synthesis by pulmonary arteries in pulmonary hypertension complicated by congenital diaphragmatic hernia

BACKGROUND: Patients with spinal cord injury (SCI) have an increased prevalence of gallstones. AIMS: To study prospectively the incidence of gallstones and gall bladder contractility in patients with SCI. PATIENTS AND METHODS: Thirty six consecutive patients with SCI were studied: 18 patients with SCI above thoracic 10 neuronal segment (> T10) and 18 patients with SCI below T10 (< T10). An equal number each of disease controls (multiple fractures) and healthy controls were also studied. All patients and controls underwent serial ultrasonography to detect development of gallstones and ultrasonographic measurement of gall bladder contractility. RESULTS: A significantly higher number (9/18) of patients with SCI > T10 developed biliary sludge compared with patients with SCI < T10 (2/18), disease controls (2/18), and healthy controls (1/18) (p < 0.05). No patient developed gallstones. The gall bladder fasting volume was significantly decreased in patients with SCI > T10 (20.56 ml; 95% confidence intervals (CI) 19.74 to 21.38) compared with that in patients with SCI < T10 (27.33 ml, 95% CI 26.17 to 28.49; p < 0.05), disease controls (27.92 ml, 95% CI 26.69 to 29.15; p < 0.05), and healthy controls (28.35 ml, 95% CI 27.25 to 29.45; p < 0.05). Gall bladder contractility was normal in patients with SCI as shown by normal gall bladder residual volume and emptying time. CONCLUSIONS: Patients with SCI above T10 have an increased incidence of biliary sludge and a decreased gall bladder fasting volume. Gall bladder contractility is, however, normal.     

Plumbagin,a Biomolecule with (Anti)Osteoclastic Properties

Plumbagin is a plant-derived naphthoquinone that is widely used in traditional Asian medicine due to its anti-inflammatory and anti-microbial properties. Additionally, plumbagin is cytotoxic for cancer cells due to its ability to trigger reactive oxygen species (ROS) formation and subsequent apoptosis. Since it was reported that plumbagin may inhibit the differentiation of bone resorbing osteoclasts in cancer-related models, we wanted to elucidate whether plumbagin interferes with cytokine-induced osteoclastogenesis. Using C57BL/6 mice, we unexpectedly found that plumbagin treatment enhanced osteoclast formation and that this effect was most pronounced when cells were pre-treated for 24 h with plumbagin before subsequent M-CSF/RANKL stimulation. Plumbagin caused a fast induction of NFATc1 signalling and mTOR-dependent activation of p70S6 kinase which resulted in the initiation of protein translation. In line with this finding, we observed an increase in RANK surface expression after Plumbagin stimulation that enhanced the responsiveness for subsequent RANKL treatment. However, in Balb/c mice and Balb/c-derived RAW264.7 macrophages, these findings could not be corroborated and osteoclastogenesis was inhibited. Our results suggest that the effects of plumbagin depend on the model system used and can therefore either trigger or inhibit osteoclast formation.