Stability of large-scale coal-fired MHD channels

Stability of large-scale coal-fired MHD channels is studied by (1) linearized stability analysis, and (2) time-dependent 1-D analysis. The channel length is 15 m with 600 electrode pairs, and the output power ranges from 220.6 MW through 258.7 MW. Linearized stability analyses show that the Faraday channels operated with fixed loading resistance are stable, whereas the two waves of u and u–a (u, a: gas and sound velocity) become unstable in the Faraday channel with fixed loading factor. Two waves of u and u–a are unstable in the diagonal channel with fixed loading current and the u + a wave becomes unstable in the diagonal channel with fixed electrode current. Time-dependent one-dimensional analyses indicate that the Faraday channels with fixed load resistance are smooth without growth of fluctuation. The diagonal channels with fixed electrode current are smooth with no fluctuation, though the linear theory indicates that the u + a wave is unstable. The diagonal channel with fixed load current suffers large disturbance along the latter half of the channel, being consistent with the linearized analysis which indicates that the u - a and u waves are unstable.     

纳米Pt膜的晶粒尺寸及其对热导率的影响

采用电子束-物理气相沉积法（EB-PVD）制备了6个厚度为15-62nm的铂薄膜，研究了纳米薄膜的晶粒尺寸及其对热导率的影响规律．当薄膜厚度小于30nm时，晶粒平均尺寸接近于薄膜的厚度；晶粒尺寸随着薄膜厚度的增加而增大并趋于定值；当薄膜厚度大于30nm时，晶粒尺寸约为20nm．受薄膜的表面和内部晶界的综合影响，铂纳米薄膜的热导率大大低于体材料的值，并且纳米薄膜的热导率随着薄膜厚度的增加而增大并趋于一个低于体材料热导率的值．     

Diameter and Density Control of Single‐Walled Carbon Nanotube Forests by Modulating Ostwald Ripening through Decoupling the Catalyst Formation and Growth Processes

A continuous and wide range control of the diameter (1.9?3.2 nm) and density (0.03?0.11 g cm^?3) of single‐walled carbon nanotube (SWNT) forests is demonstrated by decoupling the catalyst formation and SWNT growth processes. Specifically, by managing the catalyst formation temperature and H₂ exposure, the redistribution of the Fe catalyst thin film into nanoparticles is controlled while a fixed growth condition preserved the growth yield. The diameter and density are inversely correlated, where low/high density forests would consist of large/small diameter SWNTs, which is proposed as a general rule for the structural control of SWNT forests. The catalyst formation process is modeled by considering the competing processes, Ostwald ripening, and subsurface diffusion, where the dominant mechanism is found to be Ostwald ripening. Specifically, H₂ exposure increases catalyst surface energy and decreases diameter, while increased temperature leads to increased diffusion on the surface and an increase in diameter.     

Piezoelectric Vibration-Type Tactile Sensor Using Elasticity and Viscosity Change of Structure

We propose a new tactile sensor utilizing piezoelectric vibration. This tactile sensor has a high sensitivity, wide measurement range, pressure resistance, flexibility, and self-sensing function. This tactile sensor comprises two piezoelectric materials. One is used for the vibration of the sensor element and the other is used for the measurement of the change in mechanical impedance induced by an external force. We achieved the wide measurement range by implementing two ideas. One was to apply the external force to the sensor element through an elastic body and the other was to use two or more modes of vibration. Moreover, for the elastic body, it is preferable to use a material whose elasticity and viscosity are easily changed by an external force, such as a gel. In this study, first, this tactile sensor was analyzed, and then its characteristics were derived. The analytical results qualitatively corresponded to the experimental results. Next, a prototype tactile sensor was fabricated and evaluated. The evaluation results showed that this tactile sensor can measure a pressure of 2.5 Pa or less and a pressure of 10 kPa or more and its pressure resistance is 1 MPa or more.     

添加合金元素对奥氏体不锈钢等离子渗氮和渗碳的影响

奥氏体不锈钢众所周知有良好的耐蚀性,但是在工业上没有用于承受摩擦的工件上,因为它的硬度低,摩擦磨损性能差。奥氏体不锈钢经低温等离子体渗氮或渗碳能生成一层特殊的氮化物或碳化物层,称为S相,它具有高的硬度和优良的耐蚀性。这项研究中各种奥氏体不锈钢都经低温等离子体渗氮或渗碳,用各种分析技术研究了添加合金元素对S相特性的影响,用了光学显微镜和电子显微镜观察,做了X射线衍射分析,在5%H2SO4溶液中测量阳极极化,用球对平面摩擦装置做摩擦磨损测试。氮化物或碳化物层厚度随处理温度增加而加厚,AISI316钢上生成的渗层厚度是所有的基体钢材中最厚的。超过临界温度,由于氮化铬工碳化铬沉淀使耐蚀性降低。临界温度由渗氮的基材决定。另一方面,在渗碳层中临界温度不随基材变化。大部分样品上S相层的耐蚀性比没有处理的不锈钢的低。但是,AISI316和JIS-SUS304J3钢在400℃渗碳后都有和未处理钢一样优良的耐蚀性。每种不锈钢经渗氮或渗碳后耐磨性都有明显的改进。     

Measurements of thermal conductivity and thermal diffusivity of alternative refrigerants in liquid phase with a transient short‐hot‐wire method

A transient short‐hot‐wire method has been proposed to simultaneously measure the thermal conductivity and thermal diffusivity of liquids. The method has been applied to the refrigerant HCFC‐22, alternative refrigerants HFC‐32, HFC‐125, HFC‐134a and refrigerant mixtures HFC‐32/125 [35/65, 50/50 (HFC‐410A), 68/32 wt%], HFC‐32/125/134a [23/25/52 (HFC‐407C) wt%]. From the present study, it is shown that the measured results agree well with the literature values on thermal conductivity and those on thermal diffusivity obtained from NIST's thermophysical property database, REFPROP Ver. 6.0. © 2004 Wiley Periodicals, Inc. Heat Trans Asian Res, 33(8): 540–552, 2004; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/htj.20032     

The Effect of Barley Adjuncts on Free Amino Nitrogen Contents in Wort

Free amino nitrogen (FAN) and other low‐molecular‐weight nitrogen compounds (LNC) are highly important as nutrients for yeast. Many different types of low‐malt beer exist around the world, some of which are produced with barley as an adjunct. In these cases, inhibitors contained in barley are known to influence the amount of LNC in wort. Accordingly, it is important to investigate which proteinase class is key in producing these compounds. By investigating the relationship between the FAN contained in wort produced from malt and barley (barley adjunct wort) and malt proteinase activity, it was found that cysteine proteinase and 1,10‐orthophenanthroline (O‐Phen)‐inhibitable metallo proteinases had a significant correlation to the barley adjunct wort FAN levels. In addition, the relationship between malting conditions and these proteinase activities was investigated and the conditions defined for maximal production of proteinases as follows: steeping degree, 50%; germination temperature, 12°C; germination days, 6 days; water spray, 3 times and concentration of gibberellic acid, 10 mg/kg (barley).     

The spontaneous formation of a J-like aggregate in Langmuir-Blodgett films of a squarylium dye

The physical properties of chalcogenide-containing squarylium (SQ) dyes with long alkyl chains were examined. The SQ dyes were deposited as Y-type films. The SQ dye of a 6-methylselenazole derivative spontaneously forms a J-like aggregate in Langmuir-Blodgett films at ambient conditions.