A Survey on Advanced Multiple Access Techniques for 5G and Beyond Wireless Communications

Wireless Personal Communications - This paper summarizes the ongoing research initiatives based on the advanced multiple access techniques towards the fifth generation (5G) wireless communication...     

Fuzzy Multiobjective and Linear Programming Based Management Models for Optimal Land-Water-Crop System Planning

In this article, linear programming and fuzzy optimization models are developed for planning and management of available land-water-crop system of Mahanadi-Kathajodi delta in eastern India. The models are used to optimize the economic return, production and labour utilization, and to search the related cropping patterns and intensities with specified land, water, fertilizer and labour availability, and water use pattern constraints. Due to extreme backwardness of the study area, it has been decided to keep all the three objectives of the linear programming models at the same priority level to obtain the compromised solution in a fuzzy environment that incorporates the imprecision in fuzzy goals and fuzzy constraints. These non-structural models facilitate the conjunctive use of available surface water and groundwater resources. A comparative evaluation along with the benefit-cost ratios of the existing and proposed farming systems is also presented.     

Book review

CLIMATIC FLUCTUATIONS AND WATER MANAGEMENT. by M. A. Abu‐Zeid and A. K. Biswas Butterworth Heinemann, Oxford, 1992, 356 pp, £50.00.     

Identification of pole-like structures from mobile lidar data of complex road environment

Pole-like structures (PLSs) located in road environment are important roadway assets. They play a vital role in road safety inspection and road planning. The use of light detection and ranging (lidar) based mobile mapping technology for mapping of PLSs is an important area of research as it holds the potential for automation. Point cloud data of rural, peri-urban, and urban road environment are used in this study, which pose special challenge in view of the complexity of terrain, unlike well-planned roads, which have been the subject of interest in existing literature for identification of PLSs. A new five-step method is proposed in this article. The first two steps, i.e. ground filtering and voxelization of filtered non-ground points, are used for data size reduction. Next three steps are used to extract PLSs from reduced data. The proposed method was tested on point cloud data of three test sites having different levels of complexities. PLSs including partially occluded pole, tilted pole, pole situated very close to other objects, and vertical pole attached to tilted pole were accurately identified. Average correctness and completeness, respectively of 92.6% and 94.9%, were achieved in three different complex test sites, i.e. urban, peri-urban, and rural sites, respectively. Computation complexity shows that our proposed method delivers fast and computationally efficient solution for identifying the PLSs from volumetric mobile lidar point cloud. Impact of PLSs on road safety and road planning is also addressed for these selected test sites.     

Improved device performance based on crosslinking of poly (3-hexylthiophene)

Diode devices (glass/ITO/polymer/Al) have been fabricated using poly (3-hexylthiophene) (P3HT) crosslinked with two different biaryl crosslinkers. Crosslinking was performed by exposing the thin films with different wt% of crosslinker to UV irradiation and progress of crosslinking was monitored by IR spectroscopy. An increase in hole mobility of two orders of magnitude has been observed after crosslinking.     

Antibacterial and dye degradation potential of zero‐valent silver nanoparticles synthesised using the leaf extract of Spondias dulcis

The present study reports a simple and low cost synthesis of zero‐valent silver nanoparticles (ZVSNPs) from silver nitrate using the leaf extract of Spondias dulcis. The ZVSNPs showed a unique peak at 420 nm in UV–vis spectrum. The SEM image portrayed cuboidal shaped particles. The EDX spectrum designated the elemental silver peak at 3 keV. In XRD, a sharp peak at 32.47° denoted the existence of (1 0 1) lattice plane and the average crystallite size was calculated as 48.61 nm. The lattice parameter was determined as 0.39 nm. The FTIR spectra of the leaf extract and ZVSNPs showed shifts in the specific functional group bands which ascertained the involvement of phytoconstituents in the formation and capping of nanoparticles. The average hydrodynamic size was measured as 59.66 nm by DLS method. A low PDI, 0.187 witnessed the monodispersity. A negative zeta potential value of −15.7 mV indicated the negative surface charges of the nanoparticles. The bactericidal action of ZVSNPs was demonstrated against two pathogens S.typhimurium and E.coli during which a dosage dependent zone of inhibition results was observed. Additionally, the catalytic potential of ZVSNPs was examined for the degradation of methylene blue dye in which an accelerated degradation of the dye was observed.Inspec keywords: antibacterial activity, crystallites, electrokinetic effects, scanning electron microscopy, nanoparticles, particle size, ultraviolet spectra, X‐ray chemical analysis, microorganisms, light scattering, nanofabrication, materials preparation, X‐ray diffraction, visible spectra, silver, dyes, Fourier transform infrared spectraOther keywords: wavelength 420.0 nm, Ag, voltage ‐15.7 mV, size 59.66 nm, size 0.39 nm, size 48.61 nm, electron volt energy 3.0 keV, Fourier transform infrared spectra, methylene blue dye, bactericidal action, dynamic light scattering, lattice parameter, Escherichia coli, Salmonella typhimurium, Spondias dulcis, negative zeta potential, polydispersity index, crystallite size, leaf extract, X‐ray diffraction, energy dispersive X‐ray spectrum, cuboidal‐shaped particles, scanning electron microscopy image, ultraviolet–visible spectrum, silver nitrate, zero‐valent silver nanoparticles     

Water classification in the Tanshui river basin in Taiwan

This paper is based on a study conducted to assess and classify the Tanshui river in Taiwan, taking into consideration several relevant parameters. The classification was performed using a new approach. First, the current general uses of the river were assessed; classification was then made by river area, and the priority uses of each. Second, existing water quality was assessed using an indexing approach, specifically the River Pollution Index (RPI). This takes into account all relevant pollutant variables, eg DO, BOD, coliform count, etc, to determine the level of water quality at different reaches of the river. Finally, a classification of the Tanshui river based on its existing water quality and specific best usage was made.     

Synthesis and characterisation of rubber seed oil trans-esterified biodiesel using cement clinker catalysts

The synthesis of biodiesel using rubber seed oil by a transesterification reaction using cement clinker catalysts was studied. The mineral composition and morphology of both the catalysts were analysed using X-ray diffraction and scanning electron microscopy. The gas chromatography–mass spectrometry, Fourier transform infrared spectroscopy and nuclear magnetic resonance studies were used to find the Fatty acid methyl ester content and various compounds of esters in the synthesised biodiesel, which showed an efficient conversion of rubber seed oil to biodiesel. The highest yield of 80% was obtained from calcium oxide catalyst (1.5?g) activated at 50°C with a methanol-to-oil ratio of 6:1. The highest yield of 70% biodiesel was obtained using a cement clinker catalyst (0.5?g) activated at 50°C with a methanol-to-oil ratio of 6:1. The significant physical properties of biodiesel flash point, acid value and saponification value were found, and the results are within the American standard test method (ASTM D6751) limits.     

Paper mill sludge as a renewable substrate for the production of acetone-butanol-ethanol using Clostridium sporogenes NCIM 2337

In the present study, pre-treated paper mill sludge (PMS) was evaluated extensively as a substrate for production of acetone-butanol-ethanol using Clostridium sporogenes NCIM 2337. The PMS was subjected to three types of pre-treatment methods namely alkali, mechanical, and thermal treatment and was analyzed by SEM. The pre-treatment of PMS by alkali was observed to be more effective over the other pre-treatment methods. The alkali pre-treated sludge was then made to undergo fermentation, which showed the conventional process of acidogenesis followed by solventogenesis. The acetone, butanol, and ethanol concentration for 15% alkali pre-treated PMS was estimated to be maximum.