A survey of parental knowledge about car seats in children

Motor vehicle accidents are the main cause of death and disability between 1 and 4 years of age. Since 1980 the Academy of Pediatrics has been promoting the correct use of car seats. The major reason that car seats are not fulfilling their full potential is their incorrect or lack of use. In order to evaluate parental knowledge about car seat use for children and their actual use in the population visiting HURRA, a survey was performed which demonstrated that only 57.6% of the parents interviewed had infant car seats and that only 83.3% of owners actually use it. As many as 94.4% had correct knowledge about car seat use, but the majority of correct information was not provided by the medical staff. The majority of parents use seat belts for their own protection but a significantly smaller percentage use car seats for their own children.     

Stereoselective Synthesis and Antiallodynic Activity of 3-Hydroxylated Paroxetines

The design, stereoselective synthesis and in vivo antiallodynic activity of four novel paroxetine analogs, named 3-hydroxy paroxetines (3HPXs), is reported herein. Among the novel synthesized compounds, three showed an antiallodynic effect, while (R,R)-3HPX was found to be 2.5 times more bioactive than (-)-paroxetine itself in neuropathic rats. Consequently, the current investigation not only discloses a novel promising analgesic drug, but also reveals that functionalization at the C3 position of paroxetine could be as effective as the common functionalization at either C4 or within the sesamol group.     

Mechanisms of Hf dopant incorporation during the early stage of chemical vapor deposition aluminide coating growth under continuous doping conditions

A laboratory-scale chemical vapor deposition (CVD) reactor was used to perform “continuous” Hf doping experiments while the surface of a single-crystal Ni alloy was being aluminized to form an aluminide (β-NiAl) coating matrix for 45 minutes at 1150 °C. The continuous doping procedure, in which HfCl₄ and AlCl₃ were simultaneously introduced with H₂, required a high HfCl₄/AlCl₃ ratio (>∼0.6) to cause the precipitation of Hf-rich particles (∼0.1 μm) at grain boundaries of the coating layer, with the overall Hf concentration of ∼0.05 to 0.25 wt pct measured in the coating layer by glow-discharge mass spectroscopy (GDMS). Below this ratio, Hf did not incorporate as a dopant into the growing coating layer from the gas phase, as the coating matrix appeared to be “saturated” with other refractory elements partitioned from the alloy substrate. In comparison, the Hf concentration in the aluminide coating layer formed on pure Ni was in the range of ∼0.1 wt pct, which was close to the solubility of Hf estimated for bulk NiAl. Interestingly, the segregation of Hf and the formation of a thin γ′-Ni₃Al layer (∼0.5 μm) at the coating surface were consistently observed for both the alloy and pure-Ni substrates. The formation of the thin γ′-Ni₃Al layer was attributed to an increase in the elastic strain of the β-NiAl phase, associated with the segregation of Hf as well as other refractory alloying elements at the coating surface. This phenomenon also implied that the coating layer was actually growing at the interface between the γ′-Ni₃Al layer and the β-NiAl coating matrix, not at the gas/coating interface, during the early stage of the coating growth.     

Immunogenicity of four Plasmodium falciparum preerythrocytic antigens in Aotus lemurinus monkeys

Aotus lemurinus monkeys were immunized with pools of either lipid-tailed peptides injected in PBS or peptides in Montanide ISA-51, all derived from four Plasmodium falciparum pre-erythrocytic antigens, namely, LSA1, LSA3, SALSA, and STARP. These formulations were well tolerated. Their immunogenicity was demonstrated by the induction of both B- and T-cell responses to most of the peptides studied (of the 12, 10 induced antibody production, 9 induced T-cell proliferative responses, and all 12 induced gamma interferon secretion). Immune responses proved to be long lasting, since some were still detectable 210 days after immunization. Of particular importance is the fact that B- and T-cell responses elicited in this way by synthetic peptides were specific for native parasite proteins on P. falciparum sporozoites and liver stage parasites.     

Assignment of the 2.03 ppm resonance in in vivo <Superscript>1</Superscript>H MRS of human brain tumour cystic fluid: contribution of macromolecules

MRI and MRS are established techniques for the evaluation of intracranial mass lesions and cysts. The 2.03 ppm signal recorded in their ¹H-MRS spectra is often assigned to NAA from outer volume contamination, although it has also been detected in non-infiltrating tumours and large cysts. We have investigated the molecular origin of this resonance in ten samples of cystic fluids from human brain tumours. The NMR detected content of the 2.03 ppm resonance in 136 ms echo time spectra, assuming an N- CH₃ origin, was 3.19 ± 1.01 mM. Only one third (34 ± 12%) of the N-acetyl containing compound (NAC) signal could be extracted by perchloric acid (PCA) indicating that most of it originated in a macromolecular PCA-insoluble component. Chemical analysis of the cyst fluids showed that sialic acid bound to macromolecules would account for 64.3% and hexuronic containing compounds for 29.2% of the NMR-detectable ex vivo signal, 93.4% of the signal at TE 136 ms. Lactate content measured by NMR (6.4 ± 4.4 mM) and the predominance of NAC originating in sialic acid point to a major origin from tumour rather than from plasma for this 2.03 ppm resonance.     

Effect of temperature on hot-air drying rate and on retention of antioxidant capacity in apple leathers

Fruit leathers are pectic gels, eaten as snack or dessert, obtained by dehydrating fruit purees. In this work, apple leathers were prepared by a hot-air drying process which allows the formation of a gel, following the “saccharide–acid–high methoxyl pectin” gelation mechanism. Leathers were produced at 50, 60 and 70 °C, from two formulations: control and added with potassium metabisulphite (KM) as antioxidant. The drying process was studied applying a diffusive model, while antioxidant capacity (AC) losses were represented by a first-order model. Activation energy for drying (20.6 kJ/mol) was lower than those estimated for AC losses in control (31.5 kJ/mol) and KM-added (37.9 kJ/mol) leathers. Therefore, the drying time reduction achieved by increasing air temperature is not sufficient to decrease AC losses in the range covered. AC retention decreased in both formulations at increasing air temperature. KM-added samples showed higher AC retention than the controls, except for those dried at 70 °C. Kinetic constants were lower for KM-added samples, suggesting a protective effect of the additive, especially at moderate air temperatures. In the most favorable situation, AC retention was of only 16%. Therefore, the functional character of these products may not be preserved if dried with hot air and the research on economically viable, less-severe drying technologies should be intensified.     

The effects of morphological changes and mineral matter on H2S evolution during coal pyrolysis

The H₂S release profiles of five important Colombian coals have been monitored using temperature programmed pyrolysis. It was found that there was no correlation between the amount of H₂S and the sulphur content of the original coals. Coals which had been treated to remove all of the mineral matter and inorganic sulphur showed a good correlation with the free swelling index of the coals. This was explained by the physical trapping of H₂S in closed porosity formed during pyrolysis. A similar result was found for demineralised coals with pyrite present. The H₂S for untreated coals showed no systematic variation with rank, the coal sulphur content or free swelling index. This was because certain coals were rich in finely dispersed calcium which could chemically prevent H₂S release.     

Assessment of production efficiency,physicochemical properties and storage stability of spray‐dried chlorophyllide,a natural food colourant,using gum Arabic,maltodextrin and soy protein isolate‐based carrier systems

The aim of this research was to study spray drying as potential action to protect chlorophyllide from environmental conditions for shelf‐life extension and characterisation of the powders. Six formulations were prepared with 7.5 and 10 g of carrier agents [gum Arabic (GA), maltodextrin (MA) and soybean protein isolate (SPI)]/100 mL of chlorophyllide solutions. The powders were evaluated for morphological characteristics (SEM), particle size, water activity, moisture, density, hygroscopicity, cold water solubility, sorption isotherms, colour and stability, during 90 days. All the powders were highly soluble, with solubility values around 97%. A significant lower hygroscopicity was observed for GA powders, whilst the lower X_m values obtained by GAB equation fitting of the sorption isotherms was observed for the 7.5 g MA/100 mL samples. All formulations, but the 1 (7.5 g SPI/100 mL of chlorophyllide), provided excellent stability to the chlorophyllide during 90 days of storage even at room temperature.