Isomorphism between two BL-general fuzzy automata

In this note first we develop the notion of general fuzzy automata (GFA) to a new one which is called “BL-general fuzzy automata” and for simplicity, we write BL-GFA, instead of BL-general fuzzy automata. Then we focus on derivation, active state set, membership assignment, output mappings, and concept of belonging to an output label according to the entrance input strings \( X \, (X \in \Upsigma^{ * } ) \) for BL-general fuzzy automata. Therefore, we define the concepts of run map and behavior of BL-GFA. After that we present the morphism with threshold \( \tfrac{{\tau_{1} }}{{\tau_{2} }} \) between two BL-general fuzzy automata. Moreover we give some examples, to clarify these notions. Finally, we prove some theorems. In particular, we show that the isomorphic BL-general fuzzy automata have the same behavior.     

Influence of the type of reducing agent (H2, CO,C3H6 and C3H8) on the reduction of stored NO X in a Pt/BaO/Al2O3 model catalyst

In this investigation, a comparative study for a NO _X storage catalytic system was performed focusing on the parameters that affect the reduction by using different reductants (H₂, CO, C₃H₆ and C₃H₈) and different temperatures (350, 250 and 150 °C), for a Pt/BaO/Al₂O₃ catalyst. Transient experiments show that H₂ and CO are highly efficient reductants compared to C₃H₆ which is somewhat less efficient. H₂ shows a significant reduction effect at relatively low temperature (150 °C) but with a low storage capacity. We find that C₃H₈ does not show any NO _X reduction ability for NO _X stored in Pt/BaO/Al₂O₃ at any of the temperatures. The formation of ammonia and nitrous oxide is also discussed.

     

Investigating the effect of varying block size on power and energy consumption of GPU kernels

The Journal of Supercomputing - Power consumption is likely to remain a significant concern for exascale performance in the foreseeable future. In addition, graphics processing units (GPUs) have...     

Zinc Oxide/Graphene Oxide as a Robust Active Catalyst for Direct Oxidative Synthesis of Nitriles from Alcohols in Water

Catalysis Letters - In this work, without using any linker or chemical modification of graphene oxide, a zinc oxide immobilized graphene oxide-based catalyst was used for the direct aerobic...     

Australian renewable energy progress

With some of the world's best solar and wind resources, Australia is a prime market for solar and wind energy. The growing renewable energy industry can take advantage of Australia's stable economy, good access to grid infrastructure and well organised financial and legal services.Although development has been slower than what was anticipated, but with the promises made by the new government, the renewable community hopes for a brighter future for solar and wind energy in Australia.The objective of this paper is to present an overview of the current status of solar and wind energy in Australia, then to take a closer look at solar and wind potential, current activities, and finally to discusses about Australian Government support and to predict the future outlook of solar and wind energy.     

A new reactor concept for combining oxidative coupling and steam re‐forming of methane: modeling and analysis

A new and very promising application of auto‐thermal reactors is the coupling of endothermic and exothermic reactions where the product of the endothermic reaction is the desired one. Therefore, in this work, a reactor in which oxidative coupling of methane (OCM) and steam re‐forming of methane (SRM) reactions take place simultaneously was modeled. The results were obtained in a wide range of different conditions such as inlet feed, inlet temperature, portions of OCM and SRM catalysts, and inlet velocity. In selection of the catalysts, more attention was drawn to prevent re‐forming of OCM products. The main parameters of each reaction under different conditions such as conversion of the feed components, products selectivity and yield, temperature in the length of reactor, and component's concentration in the reactor were considered in course of this study. The results revealed that simultaneous OCM and SRM reactions in one reactor will tend to be auto‐thermal, and the waste of energy will be reduced. The results also show that complete conversion of water and majority of methane and oxygen will decrease the amount of unwanted products at the reactor's discharge–a constraint that exists in single reactors of each reaction specially OCM. Copyright © 2011 John Wiley & Sons, Ltd.     

A knowledge based component/service repository to enhance analysts’ domain knowledge for requirements analysis

Knowledge of the business domain (e.g., insurance claim, human resources) is crucial to analysts’ ability to conduct good requirements analysis (RA). However, current practices afford little assistance to analysts in acquiring domain knowledge. We argue that traditional reuse repositories could be augmented by adding rich faceted information on component/services and artifacts such as business-process templates to help analysts acquire domain knowledge during RA. In this paper, we present the design of a Knowledge Based Component Repository (KBCR) for facilitating RA. Then, we report on the design and development of a KBCR prototype. We illustrate its application in a system that is populated with components and process templates for the auto insurance claim domain. An empirical study was conducted to assess its effectiveness in improving RA. Results showed that KBCR enhanced analysts’ business domain knowledge and helped them better prepare for RA. Our key research contribution is to offer analysts a rich repository (i.e., KBCR) containing domain knowledge that they could utilize to acquire domain knowledge that is crucial for carrying out RA. While repositories of reusable components have been employed for some time, no one has used such repositories to help analysts acquire domain knowledge in order improve the RA of the system.     

Estimation of Mixing Ratio for Saturated Air over Water

The role that water vapor plays in atmospheric phenomena is extremely important. Saturation of moist air at a given temperature and pressure occurs if its mixing ratio is such that the moist air can coexist in a stable condition with an associated condensed phase at the same temperature and pressure. The saturation mixing ratio is useful to calculate the relative humidity which is a ratio, expressed in percent, of the amount of water vapor in the air (actual mixing ratio) compared to the amount of water vapor the air can hold (saturation mixing ratio). In this work, an attempt has been made to develop a simple‐to‐use Arrhenius‐type function to estimate the mixing ratio for saturated air over water as a function of pressure and temperature. Estimations have been found to be in excellent agreement with the data reported in the literature, with the average absolute deviation being around 0.4 %.     

Mathematical modeling and genetic algorithm optimization of clove oil extraction with supercritical carbon dioxide

In the present study, a mathematical modeling for extraction of oil from clove buds using supercritical carbon dioxide was performed. Mass transfer is based on local equilibrium between solvent and solid. The model was solved numerically, and model estimation was validated using experimental data. For optimization, the clove oil equilibrium constant between solid and supercritical phase was determined by a theoretical method using fugacity concept, consequently the genetic algorithm for obtaining optimal operational conditions was used. The optimal conditions which obtained the highest amount of clove oil were pressure of 10 MPa and temperature of 304.2 K.