Impact of hydroquinone on thermal and electrical properties of plasticized [poly(vinyl alcohol)]0.7(LiBr)0.3(H2SO4) solid acid membrane

A novel multi‐component system containing poly(vinyl alcohol), lithium bromide, sulfuric acid, ethylene carbonate and hydroquinone was prepared using a solution‐casting technique. The presence of hydroquinone as a reducing agent in the inorganic–organic membrane structure thus produced was thought to lead to enhanced thermal stability of the membrane. The activation energy for the thermal decomposition of the product samples increased with increasing hydroquinone doping. The ionic conductivities of the films were determined from AC impedance measurements in the temperature range 300–373 K. The maximum conductivity was found to be 1.75 × 10^?3 S cm^?1 for a film doped with 4 wt% hydroquinone. The results give some insight into the potential utility of the membrane as a proton‐conducting solid polymer electrolyte. Copyright © 2011 Society of Chemical Industry     

Long-Term Dynamic Modeling Approach to Quantifying Attached Algal Growth and Associated Impacts on Dissolved Oxygen in the Lower Truckee River, Nevada

Nutrient loads enter the lower Truckee River of western Nevada, affecting the growth of attached algae (periphyton) which causes depressed nighttime dissolved oxygen (DO) levels. The lower Truckee River is home to the endangered cui-ui and threatened Lahontan cut-throat trout, with DO standards being established to in part protect these species. Hydrodynamics, nutrient concentrations, periphyton biomass, and DO data spanning August 2000–December 2001 were used to calibrate and verify a modified version of the Water Quality Analysis Simulation Program Version 5 (WASP5). Under typical loading conditions the periphyton community is nitrogen limited, however nitrogen loading from an upstream wastewater treatment facility increased greatly during the analysis period due to approved site construction activities (discharge permit excursion) causing the periphyton community to temporarily become phosphorus limited. The developed modeling approach, with limited calibration, was able to accurately track dynamic system responses. Removing the impact of the noted discharge permit excursion resulted in a minimum computed DO value of 4.13?mg/L, occurring at the downstream end of the modeling domain on August 8, 2001. Additionally removing the impact of all nutrient loads from area agriculture resulted in a predicted minimum DO value of 4.54?mg/L, while also shifting its location significantly upstream and its timing to April 26, 2001. Meeting all prescribed DO standards required establishing a minimum in-stream flow value of 1.81?m3/s (64.0?ft3/s) downstream of Derby Dam.     

Evaluation of high‐resolution and mobile display systems for digital radiology in dark and bright environments using human and computational observers

Abstract— As digital display systems replace film traditionally used for reading radiographic images, resource‐intensive acceptance testing must be performed to ensure that quality meets and maintains desired specifications. If machine observers can replace human readers, whose performances are highly variable, the results will be more consistent and less costly. To be effective, however, the automated observers must track human performance. An approach for a model observer, validated with human readers, for the evaluation of the visibility of low‐contrast small targets in high‐resolution and mobile displays under different ambient illumination, will be described. The displays were tested using CDMAM‐like digital phantoms containing disks of varying diameters and contrasts on a flat background. For this task, we find the best indicator of display performance to be the display's ability to represent small luminance contrast, not resolution or pixel size. The results confirm that high‐resolution systems perform better under low illumination while illuminance has a minor impact on the mobile‐display performance. Finally, the results show that the machine observer tracks the performance of human readers. Machine observers with proper validation can replace humans in the acceptance testing procedures, saving the testers both time and money.     

Simultaneous Spectrophotometric Determination of 2-Thiouracil and 2-Mercaptobenzimidazole in Animal Tissue Using Multivariate Calibration Methods: Concerns and Rapid Methods for Detection

ABSTRACT: Two multivariate calibration methods, partial least squares (PLS) and principal component regression (PCR), were applied to the spectrophotometric simultaneous determination of 2-mercaptobenzimidazole (MB) and 2-thiouracil (TU). A genetic algorithm (GA) using partial least squares was successfully utilized as a variable selection method. The concentration model was based on the absorption spectra in the range of 200 to 350 nm for 25 different mixtures of MB and TU. The calibration curve was linear across the concentration range of 1 to 10 μg mL⁻¹ and 1.5 to 15 μg mL⁻¹ for MB and TU, respectively. The values of the root mean squares error of prediction (RMSEP) were 0.3984, 0.1066, and 0.0713 for MB and 0.2010, 0.1667, and 0.1115 for TU, which were obtained using PCR, PLS, and GA-PLS, respectively. Finally, the practical applicability of the GA-PLS method was effectively evaluated by the concurrent detection of both analytes in animal tissues. It should also be mentioned that the proposed method is a simple and rapid way that requires no preliminary separation steps and can be used easily for the analysis of these compounds, especially in quality control laboratories.     

Noise in nanotechnology

The length scales dominating physical phenomena in nanotechnology are at the boundary of the macroscopic and microscopic world. Nanoobject formation is governed by a competition between deterministic and random forces. Therefore, classical physical noise phenomena play an important role in determining structural formations and noise measurements can be used as important tools of nanotechnology.     

Characterization of poly(lactic acid) multifilament yarns. I. The structure and thermal behavior

The structure and thermal behavior of poly(lactic acid) (PLA) multifilament yarns were studied by complementary techniques of differential scanning calorimetry (DSC), Fourier transform infrared (FTIR) spectroscopy, and wide angle X‐ray diffraction (WAXD). As for PLA filaments, notable differences in the WAXD patterns, DSC curves, and FTIR spectra were observed. The combination of the WAXD and FTIR results showed that PLA samples with different crystallinity contain α‐form crystal structure. The FTIR spectra of the filaments were analyzed to study their crystallinity and crystal structure. The total crystallinity of the PLA filaments was obtained from the percent area loss of the skeletal amorphous band at 955 cm^?1. Crystalline fraction from FTIR and DSC were comparable with each other. The C?O stretching region, which is sensitive to crystallization and dipole–dipole interactions, was evaluated to provide information about chain conformers and crystallinity of the samples. Depending on the processing conditions, double melting peaks were observed in the DSC curves of the samples. This exhibited the structural reorganization of the crystal phase during heating affected by heating and cooling rate. In the DSC curves of the nearly amorphous multifilament yarn, the exothermic peak observed right above the glass transition temperature (T_g) indicated two relaxed and deformed amorphous regions. However, the multifilament yarn with higher crystallinity showed just endothermic melting peak after its glass transition. © 2010 Wiley Periodicals, Inc. J Appl Polym Sci, 2010     

Current and voltage based bit errors and their combined mitigation for the Kirchhoff-law–Johnson-noise secure key exchange

We classify and analyze bit errors in the current measurement mode of the Kirchhoff-law–Johnson-noise (KLJN) key distribution. The error probability decays exponentially with increasing bit exchange period and fixed bandwidth, which is similar to the error probability decay in the voltage measurement mode. We also analyze the combination of voltage and current modes for error removal. In this combination method, the error probability is still an exponential function that decays with the duration of the bit exchange period, but it has superior fidelity to the former schemes.     

Dendrigraft with citric acid on acrylonitrile/acrylic acid copolymer electrospun fibres

Acrylonitrile/acrylic acid copolymers were synthesized with different mole fractions (1, 2, 5 and 10 mol%) of acrylic acid (AA) in the feed by aqueous suspension polymerization, and bead‐free fibres (295–375 nm in diameter) were made from the copolymers in dimethylformamide solutions by electrospinning. In a heterogeneous system containing electrospun fibre mats, dendritic molecules were grown by reaction between carboxylic acid of AA and –OH groups of citric acid activated by dicyclohexylcarbodiimide. The products were analysed using ¹H NMR, ¹³C NMR and Fourier transform infrared spectroscopies, density determination, scanning electron microscopy, optical microscopy, differential scanning calorimetry and pH response properties. With decreasing AA content, the isotacticity of the copolymers decreases with a more random distribution of the co‐monomers which leads to higher percentage conversions of dendrigraft due to reduced steric hindrance. On the formation of dendrigraft, the percentage conversion of the reactions decreases with an increase of generation number and AA content. A reduction of density for the first generation and then an increase with increasing generation are observed. During oxidation stabilization of fibres with a decrease of AA content and an increase in generation number, the amount of liberated heat increases. Fibres containing more carboxylic groups show significantly greater amounts of swelling/de‐swelling in basic and acidic media, respectively. To be used as nanocarbon fibre precursors, or as active particles for loading with guest molecules, or as pH actuators, the first generation of dendrigrafted fibres are expected to have the greatest potential among the various samples examined. © 2013 Society of Chemical Industry