Effect of 100 KeV Ar+ ion beam irradiation on ZnO thin films – Influence of morphology vis-a-vis electrode/electrolyte interface and its impact on photoelectrochemical water splitting

The present study attempts quantitative determination of changes in the morphological surface features viz. fractal dimension, lower and upper cut off length scale through Power Spectral Density analysis prior to and after irradiation of 100 KeV Ar⁺ ion beam at incidence angles of 0°, 40° and 60° on ZnO thin films. All the unirradiated and irradiated samples are subjected to photoelectrochemical characterization and a correlation between photoelectrochemical performance and morphological parameters is established. Sample irradiated at 40° angle at the fluence of 5 × 10¹⁶ ions/cm² is found to possess maximum fractal dimension of 2.72, lower and upper cut off length scale of 3.16 nm and 63.00 nm respectively. This sample exhibits maximum photocurrent density of 3.19 mA/cm² and applied bias photon-to-current efficiency of 1.12% at 1.23 V/RHE. Hydrogen gas collected for duration of 1 h for the same sample was ~4.83 mLcm^?2.     

Error monitoring issues for common channel signaling

Motivated by field data which showed a large number of link changeovers and incidences of link oscillations between in-service and out-of-service states in common channel signalling (CCS) networks, a number of analyses of the link error monitoring procedures in the SS7 protocol were performed by the authors. This paper summarizes the results obtained thus far and include the following: (a) results of an exact analysis of the performance of the error monitoring procedures under both random and bursty errors; (b) a demonstration that there exists a range of error rates within which the error monitoring procedures of SS7 may induce frequent changeovers and changebacks; (c) an analysis of the performance of the SS7 level-2 transmission protocol to determine the tolerable error rates within which the delay requirements can be met; (d) a demonstration that the tolerable error rate depends strongly on various link and traffic characteristics, thereby implying that a single set of error monitor parameters will not work well in all situations; and (e) some recommendations on a customizable/adaptable scheme of error monitoring with a discussion on their implementability. These issues may be particularly relevant in the presence of anticipated increases in SS7 traffic due to widespread deployment of advanced intelligent network (AIN) and personal communications service (PCS) as well as for developing procedures for high-speed SS7 links currently under consideration by standards bodies     

Planning collision-free trajectories in time-varying environments: a two-level hierarchy

We propose a two-level hierarchy for planning collision-free trajectories in time varying environments. Global geometric algorithms for trajectory planning are used in conjunction with a local avoidance strategy. Simulations have been developed for a mobile robot in the plane among stationary and moving obstacles. Essentially, the robot has a global geometric planner that provides a coarse global trajectory (the path and velocity along it), which may be locally modified by the low-level local avoidance module if local sensors detect any obstacles in the vicinity of the robot. This hierarchy makes effective use of the complementary aspects of the global trajectory planning approaches and the local obstacle avoidance approaches.     

Quantifying DNS namespace influence

Name resolution using the Domain Name System (DNS) is integral to today’s Internet. The resolution of a domain name is often dependent on namespace outside the control of the domain’s owner. In this article we review the DNS protocol and several DNS server implementations. Based on our examination, we propose a formal model for analyzing the name dependencies inherent in DNS. Using our name dependency model we derive metrics to quantify the extent to which domain names affect other domain names. It is found that under certain conditions, more than half of the queries for a domain name are influenced by namespaces not expressly configured by administrators. This result serves to quantify the degree of vulnerability of DNS due to dependencies that administrators are unaware of. When we apply metrics from our model to production DNS data, we show that the set of domains whose resolution affects a given domain name is much smaller than previously thought. However, behaviors such as using cached addresses for querying authoritative servers and chaining domain name aliases increase the number and diversity of influential domains, thereby making the DNS infrastructure more vulnerable.     

A novel microfluidic switch for pH control using Chitosan based hydrogels

We report a novel pH-sensitive hydrogel based micro-valve for metered flow that has applications in a laboratory made “Intelligent valving system”. The hydrogel solution was prepared through Chitosan and poly vinyl alcohol in acetic acid and crystallized using gluteraldehyde as the crosslinking agent in the form of thin wafers and it was found to be very sensitive to pH changes. The pore structure of hydrogel was investigated through Field Emission Scanning Electron Microscopy and thin wafers of the gel were physically placed inside PDMS microchannels. Flow metering in these channels was observed by controlled expansion of the hydrogel plug till complete valving was realized. This valving device was further precisely characterized with micro Particle Image Velocimetry using a solution containing fluorescent polymeric micro beads. The principle advantage of this hydrogel device is the smaller range of pH (varying between pH 3 and 7) over which the valving response is observed.     

Hydration Study of the System Ca3Al2O6–CaSO4· 2H2O–Ca(OH)2–H2O with and without Citric Acid

Hydration occurring in the system Ca₃Al₂O₆–CaSO₄· 2H₂O–Ca(OH)₂–H₂O has been studied at different temperatures and it was found that the reactions are diffusion controlled. The kinetic data obeyed Jander's equation and the rate of reaction increased with increasing temperature. X-ray diffraction studies and calorimetric measurements show that when gypsum is consumed, ettringite is converted into monosulfate. The rate of this conversion also increased with the increasing temperature and decreased in the presence of citric acid. Spectroscopic studies showed that there was some interaction between citric acid and the cement and that the product of hydration is of colloidal nature. Zeta potential measurements show that retardation of Ca₃Al₂O₆ hydration in the presence of gypsum and Ca(OH)₂ is not due to SO²⁻₄ adsorption. Electrical conductivity and thermoelectric potential measurements of solid Ca₃Al₂O₆ show that Ca₃Al₂O₆ is an n -type semiconductor and contains defects. The retardation of Ca₃Al₂O₆ may be due to poisoning of reaction sites by gypsum and Ca(OH)_2.     

Graft copolymerization of 2‐acrylamido‐2‐methyl‐1‐propanesulfonic acid onto carboxymethylcellulose (sodium salt) by H2O2/Fe+2 redox pair

The effect of the reaction conditions on the grafting parameters during grafting of 2‐acrylamido‐2‐methyl‐1‐propanesulfonic acid onto sodium carboxymethylcellulose using H₂O₂/Fe⁺² redox pair are studied at 30°C. The grafting ratio, add on, and conversion initially increase with the H₂O₂ concentration in the range of (10.0–15.0) × 10^?2 mol dm^?3. Thereafter, these parameters decrease with the H₂O₂ concentration. The grafting ratio, add on, and conversion increase when increasing the ferrous ion concentration from (0.5 to 4.0) × 10^?2 mol dm^?3 and decrease with a further increase in the concentration. It is observed that the grafting ratio and add on increase with the monomer concentration, whereas the conversion decrease. The hydrogen ions seem to be facilitating the grafting reaction up to a certain concentration and after this concentration seem to be retarding the process. The grafting ratio, add on, and conversion decrease with the sodium carboxymethylcellulose concentration. When increasing the time period from 60 to 90 min, the grafting parameters increase but decrease thereafter. Similarly, when increasing the temperature from 25 to 30°C, the grafting parameters increase and decrease thereafter. © 2006 Wiley Periodicals, Inc. J Appl Polym Sci 100: 4819–4825, 2006     

The Rank-Width of Edge-Coloured Graphs

A C-coloured graph is a graph, that is possibly directed, where the edges are coloured with colours from the set C. Clique-width is a complexity measure for C-coloured graphs, for finite sets C. Rank-width is an equivalent complexity measure for undirected graphs and has good algorithmic and structural properties. It is in particular related to the vertex-minor relation. We discuss some possible extensions of the notion of rank-width to C-coloured graphs. There is not a unique natural notion of rank-width for C-coloured graphs. We define two notions of rank-width for them, both based on a coding of C-coloured graphs by ${\mathbb{F}}^{*}$ -graphs— $\mathbb {F}$ -coloured graphs where each edge has exactly one colour from $\mathbb{F}\setminus \{0\},\ \mathbb{F}$ a field—and named respectively $\mathbb{F}$ -rank-width and $\mathbb {F}$ -bi-rank-width. The two notions are equivalent to clique-width. We then present a notion of vertex-minor for $\mathbb{F}^{*}$ -graphs and prove that $\mathbb{F}^{*}$ -graphs of bounded $\mathbb{F}$ -rank-width are characterised by a list of $\mathbb{F}^{*}$ -graphs to exclude as vertex-minors (this list is finite if $\mathbb{F}$ is finite). An algorithm that decides in time O(n ³) whether an $\mathbb{F}^{*}$ -graph with n vertices has $\mathbb{F}$ -rank-width (resp. $\mathbb{F}$ -bi-rank-width) at most k, for fixed k and fixed finite field $\mathbb{F}$ , is also given. Graph operations to check MSOL-definable properties on $\mathbb{F}^{*}$ -graphs of bounded $\mathbb{F}$ -rank-width (resp. $\mathbb{F}$ -bi-rank-width) are presented. A specialisation of all these notions to graphs without edge colours is presented, which shows that our results generalise the ones in undirected graphs.