Non-axisymmetric buckling behaviour of elastic-plastic circular tubes subjected to a nosing operation

Theoretical investigations have been carried out to predict the non-axisymmetric buckling seen in the throat of circular elastic-plastic tubes subjected to a nosing operation along a frictionless conically shaped die. The buckling points and associated modes are determined by Hill's bifurcation theory in conjunction with a non-axisymmetric buckling mode. The results show that increasing the die semi-angle and the tube thickness or decreasing the material work-hardening rate are always beneficial to improve the buckling limit. The associated critical buckling mode number generally decreases as the tube thickness increases and does not depend drastically on the die semiangle nor on the hardening rate. The effect of the average r value is substantial and the buckling limit is improved when the r value reduces. Part of the present results predict well the results observed in existing experimental work.     

Flashover voltage characteristics of contaminated station insulators under temporary ac overvoltages in the ac system connected with a frequency converter station

According to the recent analysis results of temporary ac overvoltage in the ac system connected with a frequency converter station, large-magnitude over-voltages were confirmed to occur under some special system conditions. Most of the station insulators currently used cannot withstand such overvoltages according to an evaluation based on the data obtained earlier. The necessity of tests to be done to evaluate such performance more accurately was recognized. Both power frequency and switching impulse overvoltage flashover tests were made on contaminated insulators by the method well simulating the natural wetting condition. Switching impulse flashover voltage with the waveshape having a long wavefront time of 2 ms can be well correlated with the flashover voltage characteristics of temporary ac overvoltage. Higher flashover voltage characteristics were obtained by a clean fog test method compared with those obtained by equivalent fog test method.     

Surgical treatment of metastatic lung tumors

To evaluate an association between Helicobacter pylori (H. pylori) infection and chronic atrophic gastritis (CAG), an established precursor of gastric cancer, we performed a cross-sectional study using IgG antibody against H. pylori and pepsinogens of blood donors in four prefectures in Japan. Although a geographic correlation between the age-adjusted prevalence rates for H. pylori infection and those for CAG was not seen, the age-adjusted odds ratios (OR) of H. pylori infection for CAG were high in each area (around five for men and from four to 12.6 for women). The association between them weakened with advancing age; the ORs in the youngest age group (16-29 yrs) and in the oldest age group (50-64 yrs) were 12.5 and 2.8 for men, and 11.5 and 5.2 for women, respectively. These findings suggest that H. pylori infection is strongly associated with CAG, while there are some other factors interacting in the development of CAG. A prospective cohort study in which CAG and H. pylori infection are taken into account will be necessary to assess the risks of gastric cancer.     

A Unified Approach to Submicron DC MOS Transistor Modeling for Low-Voltage ICs

A unified single-equation approach for the MOS transistordrain current modeling for energy-efficient submicron MOS circuitsis presented. Instead of three sets of separate equations forthe triode, saturation, and weak inversion regions, only a continuousexpression which is valid to describe the behavior of drain currentand the derivatives in all operation regions can be realizedby using a combination of hyperbola, sigmoid, and interpolationmethods. The model expression can predict accurate results forthe current, output conductance, and transconductance with continuousand smooth characteristics. The simulation results agree wellwith experimental data.     

Necrotizing fasciitis of the face

Necrotizing fasciitis (NF) is a rapidly progressive soft tissue infection with high morbidity and mortality rates. Its occurrence in the head and neck region is uncommon, the majority of reported cases being limited to involvement of the neck, usually from infections of dental or pharyngeal origin. Involvement of the face from NF is rare; only 35 such cases have been reported in the literature since 1960. It is not only associated with a high mortality but can also result in severe disfigurement of the face, posing challenging reconstructive problems. Successful management of facial NF requires early diagnosis, prompt institution of broad spectrum antibiotics, aggressive surgical debridement to control the infection, and reconstruction of the resultant soft tissue defects. This report describes four additional cases of facial necrotizing fasciitis. One of the four patients died as a result of sepsis and multi-organ system failure. Two of the three surviving patients had significant facial disfigurement. A comprehensive review of the facial NF cases reported in the literature is also provided. Based on our experience with facial NF and the results of all previous case reports, the clinical manifestations, pathogenesis, and management of this disease are discussed.     

Changes in Aging Behavior and Defect Structure of Yttria-Fully-Stabilized ZrO2 with Sc2O3 Doping

Methods of suppressing decreased conductivity in 8 mol% Y₂O₃-stabilized–92 mol% ZrO₂ (8YSZ) with aging were investigated. Different amounts of Sc₂O₃ were doped into 8YSZ. The electrochemical properties of Sc₂O₃-doped 8YSZ were measured, and the microstructural and local structural changes were characterized. The present results indicate that an appropriate amount of Sc₂O₃ doping, 3 or 4 mol%, effectively suppresses decreased conductivity with aging in 8YSZ.     

A new method for power generation planning and problems of uncertainty

This paper presents a new method for power system planning which considers uncertainties of various system parameters as a part of the criterion function. The criterion function involves both the expected values of total system costs and the cost variances of different power plants. Previously, the authors proposed that these cost variances be evaluated from the existing power system plans in the form of the solutions to the inverse optimization problem, and then applied this procedure to the planning of power systems in Japan. However, because of the correlation between fuel and facility costs, the cost variances could not be determined as specific values. Here, to overcome this difficulty, the authors now introduce hydropower plants into the model as the so-called nonrisky elements and focus on the expenditure shares rather than the plant capacity shares. As a result, more reasonable results are obtained. This improved methodology is applied and the derived cost variances are shown. Further, using the resultant cost variances, the authors make Pareto-optimal power generation plans and demonstrate also the robustness of the method to price fluctuations.     

Some experimental findings in compression-after-impact (CAI) tests of CF/PEEK (APC-2) and conventional CF/epoxy flat plates

Compression-after-impact (CAI) tests have been conducted for quasi-isotropic thick plates with 48 plies by using the NASA method and on plates with 32 plies by using the SACMA method. Specimens are made of CF/PEEK (APC-2) and conventional CF/epoxy for the NASA plates and CF/epoxy for the SACMA plates. In the NASA CAI tests, the sequence of delamination buckling and its propagation is clearly revealed through various experimental techniques. One major technique is moiré topography, and the other is thermo-mechanical stress analysis with a high-accuracy infrared sensor. The arrest of delamination propagation just before catastrophic failure due to high fracture toughness is clearly captured by the moiré camera. This behavior provides good CAI values of CF/PEEK. The initial buckling properties of the delaminated region by the impact are then extensively discussed. Numerical predictions of initial buckling stress have been obtained by modelled geometry of the delaminated region simplified from its precise structure clarified by ultrasonic C-scanning. They agree fairly well with the experimental results. The in-plane stress distribution in the delaminated region before initial buckling is measured by an infrared stress graphic system. This compared favorably with finite element predictions. Two types of symmetric buckling modes with respect to the central plate surface, twin and single peak ones, are experimentally captured.