High temperature transport kinetics in heteroepitaxial LaFeO3 thin films

Heteroepitaxial LaFeO₃(1 1 0) thin films with a thickness of 150 nm were grown on LaAlO₃(0 0 1) by reactive sputtering in an inverted cylindrical magnetron geometry. Equilibrium conductivity was measured as a function of partial pressure of oxygen at T=1000 °C, and logσ plotted vs. logP(O₂) showed a minimum in conductivity for P(O₂)=10⁻¹¹ atm and a linear response between 10⁻¹⁰ and 1 atm. This linear response makes thin films of LaFeO₃ a promising material for oxygen sensor applications. We have also measured the time response of the film conductivity upon an abrupt change in the partial pressure of ambient oxygen from 10⁻² to 10⁻³ atm, which was determined at 60 s for T=700 °C and <3.5 s at T=1000 °C.     

Infants of diabetic mothers (IDM). II -- Fibronectin and perinatal morbidity

OBJECTIVE: The objective of this study was to determine fibronectin levels in umbilical cord blood of infants of diabetic mothers (IDM) and evaluate a possible correlation with perinatal pathology. PATIENTS AND METHODS: A prospective study of 58 IDM (33 males and 25 females) and 58 control newborns (NB) (33 males and 25 females) was carried out. RESULTS: There were no differences in fibronectin levels between the two groups nor between the sexes. Perinatal morbidity was higher in the IDM group, but there was no correlation between fibronectin levels and the presence of perinatal pathology. CONCLUSIONS: Fibronectin levels are not useful in the perinatal evaluation of infants of diabetic mothers.     

Heat transfer and pressure drop in a new type of corrugated channels

An experimental investigation of heat transfer and pressure drop from a new type of corrugated channels is presented. The investigation has been carried out for Reynolds numbers in the range of $\text{800 <}\text{Re}\text{< 5000}$ for one corrugated and one smooth channel. It is found that the heat transfer from the corrugated channel is up to 3.5 times higher than for the smooth one. The pressure drop is however large (5 – 6 times the value of a smooth channel) and it is suggested that the corrugation height and length should be altered in order to balance the increases in heat transfer and pressure drop.     

Tobramycin-EDTA conjugate: a noninnocent affinity-cleaving reagent

The design, synthesis, and ribozyme inhibitory activity of a novel EDTA-aminoglycoside conjugate are reported. This affinity cleaving reagent is a noninnocent RNA binder: its RNA affinity, judged by its ability to inhibit the hammerhead ribozyme HH16, is different than the parent natural product and is markedly dependent on the oxidation state of the chelated metal ion.     

Catalytic conversion of MTBE to biodegradable chemicals in contaminated water

The behavior of different acid zeolites in the hydrolysis at room temperature of methyl tert-butyl ether (MTBE) was studied with reference to the possibility of its conversion to more biodegradable products in underground water contaminated by MTBE. The effect of the structure of the zeolite and SiO₂/Al₂O₃ ratio was analyzed. The results indicate that acid H-MFI and H-BEA zeolites are effective in both adsorption and hydrolysis of MTBE and may be applied for both in situ underground water remediation and as protection barrier for wells or leaking tanks. However, other zeolites (mordenite and faujasite) result completely inactive. Furthermore, contrary to what was expected, the increase of the Si/Al ratio promotes the reactivity which is determined by the resistance to diffusion of MTBE in the pores of zeolites and the resistance of back-diffusion of the reaction products.     

High-Temperature Creep Behavior of Mixed Conducting La0.5Sr0.5Fe1−xCoxO3-δ (0.5≤x≤1) Materials

Steady-state compressive creep rate of La_0.5Sr_0.5Fe_0.5Co_0.5O_3−δ (LSFC) and La_0.5Sr_0.5CoO_3−δ (LSC) is reported in the temperature region 900°–1050°C and stress range 5–28 MPa. The stress exponents for the two materials were 1.71±0.18 and 1.24±0.15, respectively. The activation energy for creep was considerably higher for LSC (619±56 kJ/mol) than for LSFC (392±28 kJ/mol). The grain size exponent for LSC was 1.28±0.14. Considerably higher creep rates were observed for both materials in N₂ compared with air. Relaxation by creep of chemical-induced stresses in oxygen-permeable membranes is addressed, especially at low partial pressure of oxygen.     

Sintering behaviour of La1−xSrxFeO3−δ mixed conductors

The sintering properties of La_1−xSr_xFeO_3−δ (x = 0.1, 0.25) mixed conductors have been investigated with particular emphasis on the effect of secondary phases due to cation non-stoichiometry (±5 mol% La excess and deficiency). Secondary phases, located at grain boundaries in cation non-stoichiometric materials, increased the sintering temperature compared to single-phase materials. Extensive swelling in final stage of sintering was observed in all materials, which resulted in micro-porous materials. The swelling was most pronounced in the phase pure and two-phase materials due to La-deficiency, while refractory secondary phases in La-excess materials inhibited both sintering, grain growth and swelling. In La-deficient materials, formation of molten secondary phases resulted in rapid swelling due to viscous flow. The present findings demonstrated the importance of controlling sintering temperature and time, as well as careful control of the cation stoichiometry of La_1−xSr_xFeO_3−δ in order to achieve fully dense and homogenous La_1−xSr_xFeO_3−δ ceramics.     

The stability of refractory oxides in sodium-rich environments

The infiltration of molten electrolyte and sodium is known to deteriorate the refractory in aluminum electrolysis. The mineralogical changes due to reactions with molten fluorides have previously been described throughly, while the effect of sodium has not been considered in detail. This paper presents an experimental study of the chemical stability of some refractory materials in sodium-rich environments. The materials were exposed to sodium vapor at 800°C for 4 hours. The mineralogical transformations and deterioration of the materials due to reactions with sodium were analyzed by x-ray diffraction and optical and electron microscopy.