Effect of cellulose acetate/cellulose triacetate ratio on reverse osmosis blend membrane performance

Surface functionalization and modification including the grafting process are effective approaches to improve and enhance the reverse osmosis (RO) membrane performance. This work is aimed to synthesize grafted/crosslinked cellulose acetate (CA)/cellulose triacetate (CTA) blend RO membranes using N-isopropylacrylamide (N-IPAAm) as a monomer and N,N-methylene bisacrylamide (MBAAm) as a crosslinker. The morphology of these membranes was analyzed by scanning electron microscopy and their surface roughness was characterized by atomic force microscopy. The performance of these membranes was evaluated through measuring two major parameters of salt rejection and water flux using RO unit at variable operating pressures. It was noted that the surface average roughness obviously decreased from 148 nm for the pure CA/CTA blend membrane with 2.5% CTA to 110 nm and 87 nm for the grafted N-IPAAm and grafted/crosslinked N-IPAAM/MBAAm/CA/CTA-RO membranes, respectively. Moreover, the contact angle decreased from 51.98° to 47.6° and 43.8° after the grafting and crosslinking process. The salt rejection of the grafted CA/CTA-RO membrane by 0.1% N-IPAAm produced the highest value of 98.12% and the water flux was 3.29 L/m²h at 10 bar.     

Pheromone Disruption of Argentine Ant Trail Integrity

Disruption of Argentine ant trail following and reduced ability to forage (measured by bait location success) was achieved after presentation of an oversupply of trail pheromone, (Z)-9-hexadecenal. Experiments tested single pheromone point sources and dispersion of a formulation in small field plots. Ant walking behavior was recorded and digitized by using video tracking, before and after presentation of trail pheromone. Ants showed changes in three parameters within seconds of treatment: (1) Ants on trails normally showed a unimodal frequency distribution of walking track angles, but this pattern disappeared after presentation of the trail pheromone; (2) ants showed initial high trail integrity on a range of untreated substrates from painted walls to wooden or concrete floors, but this was significantly reduced following presentation of a point source of pheromone; (3) the number of ants in the pheromone-treated area increased over time, as recruitment apparently exceeded departures. To test trail disruption in small outdoor plots, the trail pheromone was formulated with carnuba wax-coated quartz laboratory sand (1 g quartz sand/0.2 g wax/1 mg pheromone). The pheromone formulation, with a half-life of 30 h, was applied by rotary spreader at four rates (0, 2.5, 7.5, and 25 mg pheromone/m²) to 1- and 4-m² plots in Volcanoes National Park, Hawaii. Ant counts at bait cards in treated plots were significantly reduced compared to controls on the day of treatment, and there was a significant reduction in ant foraging for 2 days. These results show that trail pheromone disruption of Argentine ants is possible, but a much more durable formulation is needed before nest-level impacts can be expected. Electronic supplementary material  The online version of this article (doi:) contains supplementary material, which is available to authorized users.     

Postintegration methods for numerical integration of non-linear dynamic equations of motion

The paper presents a family of methods with postintegration, for numerical integration of non-linear dynamic equations of motion of discrete systems. Both explicit and implicit algorithms of these methods are conditionally stable, but can give solutions of accuracy of a few orders higher than the known methods with preintegration, corresponding to them. A general analysis of stability and accuracy of single-step methods is carried out. The postintegration methods have been tested on a single-degree-of-freedom non-linear system.     

Comparison of two different approaches for making design sensitivity analysis an integrated part of finite element analysis

This paper presents a comparison of two approaches for incorporating design sensitivity calculations into finite element analysis. The formulations depend on the implicit differentiation method and require few additional calculations to obtain the design sensitivity derivatives. The first approach by-passes the direct calculation of the stiffness matrix derivatives by calculating the sensitivity derivatives at the stress recovery stage of the analysis. The second approach depends on the direct calculation of the derivatives of the stiffness matrix, which are stored for re-use in multiple load case analyses, and subsequent matrix multiplications to evaluate the design sensitivities. The two approaches are developed and implemented to calculate the design sensitivities for continuum and structural isoparametric elements. In addition, a criterion is developed to aid in deciding which approach is better for a given number of load cases. To demonstrate the validity of the developed criterion and to evaluate the relative merits of each approach, some sensitivity calculation test problems are solved with different numbers of load cases.     

Some interesting properties of metals confined in time and nanometer space of different shapes

The properties of a material depend on the type of motion its electrons can execute, which depends on the space available for them (i.e., on the degree of their spatial confinement). Thus, the properties of each material are characterized by a specific length scale, usually on the nanometer dimension. If the physical size of the material is reduced below this length scale, its properties change and become sensitive to its size and shape. In this Account we describe some of the observed new chemical, optical, and thermal properties of metallic nanocrystals when their size is confined to the nanometer length scale and their dynamical processes are observed on the femto- to picosecond time scale.     

Inhibitory Effect of Monoterpenes on Response of Pityogenes bidentatus to Aggregation Pheromone Released by Piezoelectric Sprayer for Precision Release of Semiochemicals

A piezoelectric sprayer for dispensing semiochemicals was developed and used for a field test of bark beetle semiochemicals. The sprayer consists of a geared pump that pushes a syringe slowly to dispense semiochemicals in solvents through a microtube to a glass micropipet fixed to a piezoelectric high-frequency vibrator. The frequency is adjusted via a function generator to about 120 kHz until the harmonic properties of the glass micropipet, drawn by an electrophysiological pipet puller, cause vibrations that atomize the solvent from the micropipet tip. The sprayer, syringe, pump, function generator, and power supply were hung on one arm of a rotating trap pair (traps 6 m apart) that was slowly rotated at 2 revolutions per hour (rph) to even out the position effects on trap catches. The aggregation pheromone components of Pityogenes bidentatus, grandisol and cis-verbenol, were released by standard tube dispensers in one trap and compared to the release of similar amounts by the sprayer in the other trap. No significant differences in catch were observed. No effect of the solvent hexane on aggregation could be observed. The trap pair also caught approximately equal numbers of bark beetles when the baits were identical. The release of (+)and (–)--pinene, (+)-3-carene, and terpinolene, monoterpenes of host Scotch pine, Pinus sylvestris, at increasing rates from 0.01 to 10 log-equivalents in decadic steps (each at 0.1–100 g/min) resulted in decreasing responses to aggregation pheromone (only 9% at highest rate). Inhibition by the individual monoterpenes tested at the 100 g/min rate was significant for (+)and (–)--pinene and terpinolene (12, 13, and 15% of control, respectively). The inhibition by the host Scotch pine monoterpenes may allow P. bidentatus to avoid resistant trees that release large amounts of toxic monoterpenes in their resin and instead colonize dying and diseased limbs or slash, the usual host substrate. The piezoelectric sprayer should prove generally useful to dispense precise amounts of semiochemicals in field and laboratory experiments.     

Speech enhancement with an adaptive Wiener filter

This paper proposes an adaptive Wiener filtering method for speech enhancement. This method depends on the adaptation of the filter transfer function from sample to sample based on the speech signal statistics; the local mean and the local variance. It is implemented in the time domain rather than in the frequency domain to accommodate for the time-varying nature of the speech signals. The proposed method is compared to the traditional frequency-domain Wiener filtering, spectral subtraction and wavelet denoising methods using different speech quality metrics. The simulation results reveal the superiority of the proposed Wiener filtering method in the case of Additive White Gaussian Noise (AWGN) as well as colored noise.     

Radiation-induced oxidative degradation of isotactic polypropylene

Gas evolution, oxygen consumption, and change of mechanical properties were studied for the γ-ray irradiation of isotactic polypropylene from ⁶⁰Co under various conditions, such as vacuum, air, and oxygen at room temperature. For irradiation under vacuum, G(H₂) = 2.9 and G (CH₄) = 0.09; the G values for other gases were very small. In the presence of oxygen, G(H₂) was the same, and the G values for other hydrocarbons were two times those under vacuum. The G values of oxidative products and oxygen consumption were G(CO₂) = 2.5, G(CO) = 1.1, and G(O₂) = 50 at oxygen pressure of 500 torr and were dependent on oxygen pressure. With irradiation under vacuum at 2–3 Mrad, mechanical properties scarcely changes immediately after irradiation but degrade gradually with storage time in air at room temperature.     

Characterization of Pheromone Blend for Grapevine Moth, Lobesia botrana by Using Flight Track Recording

The behavioral responses of Lobesia botrana males to calling females, pheromone gland extracts, and synthetic sex pheromones were recorded in a wind tunnel. Gland extracts and synthetic pheromones were released from a pheromone evaporator. The numbers of males reaching the source and their flight tracks in response to calling females and pheromone gland extracts were compared to those of synthetic blends. Upwind flights to natural sex pheromone were straighter and faster than to a three-component blend of (E)-7,(Z)-9-dodecadienyl acetate (E7,Z9–12:Ac), (E)-7,(Z)-9-dodecadien-1-ol (E7,Z9–12:OH), and (Z)-9-docecenyl acetate (Z9–12:Ac) (100:20:5). The optimum ratio of E7,Z9–12:OH and Z9–12:Ac to E7,Z9–12:Ac was found to be 5% and 1%, respectively. An additional seven compounds identified in the sex pheromone gland were investigated for their biological activity. Two unsaturated acetates, i.e., (E)-9-dodecenyl acetate (E9–12:Ac) and 11-dodecenyl acetate (11–12:Ac), increased the number of males reaching the source as well as straightness, linear velocity, and decreased the track angle of upwind flight. Optimum response was obtained by releasing 10 pg/min E7,Z9–12:Ac in a mixture with 0.5 pg/min E7,Z9–12:OH, 0.1 pg/min Z9–12:Ac, 0.1 pg/min E9– 12:Ac and 1 pg/min 11-12–Ac. The saturated acetates previously identified in the female glands were biologically inactive.     

An efficient IoT based smart farming system using machine learning algorithms

Multimedia Tools and Applications - This paper suggests an IoT based smart farming system along with an efficient prediction method called WPART based on machine learning techniques to predict crop...