Die chemie der schweren carben-analogen R2M,M = Si,Ge, Sn: IX. Eigenschaften und thermolyse von neuen 7-silabicyclo[2.2.1]heptadienen

Factors governing the ease and mechanism of 7-silabicyclo[2.2.1]heptadienes thermolysis in order to generate free silylenes and the corresponding benzene derivatives are investigated. For this purpose, 29 new compounds of the types VII–X have been prepared. No indications for a polar mechanism or an intermediate biradical could be found. The degradation is exactly of first order in all cases investigated sofar, and is enhanced by phenyl groups at the bridgehead C atoms, if a conformation coplanar with the basic ring is allowed by the neighbouring substituents, but is not enhanced by phenyl groups at the Si. The X-ray structure of two typical derivatives is discussed with this respect. A special mechanism is operating in the easy thermolysis of carbomethoxy-substituted compounds leading to cyclic sila enolether intermediates.     

ICP-AES detection of silicon carbide impurities volatilized in a graphite furnace with the use of carbon tetrachloride vapour

The analytical capability of high-temperature halogenation with carbon tetrachloride vapour in a graphite furnace was investigated for silicon carbide powder with known chemical composition and particle size. Intensity vs heating time curves were determined for analytical lines of Al, B, Ba, Ca, Cr, Cu, Fe, Mg, Mn, Ti, V and Si constituents, volatilized with and without the presence of CCl₄ vapour in the furnace atmosphere. Igniting 10 mg SiC at 2100 °C for 60 s in chlorinating atmosphere, the evaporated fraction of most of the constituents was higher than 90% (for Al about 50%). The line intensity vs sample mass (4–26 mg) relationships were linear for all impurities studied, while the intensity of silicon line showed a relatively small change with the sample mass. BEC (background equivalent concentration) values for this solid sampling technique (10 mg loaded sample) were 2–20 fold lower than those calculated for the conventional solution sample introduction method.     

Screening for metal ligands by liquid chromatography--ligand-exchange--electrospray mass spectrometry

Electrospray ionization mass spectrometry is applied for the selective detection of metal ligands after a post-column continuous-flow ligand-exchange reaction. The detection is based on the specific release of a reporter ligand from a metal-reporter ligand complex by a high affinity ligand. Constant infusion and direct-injection experiments are performed to optimize the method. The on-line coupling of a liquid chromatographic separation prior to the continuous flow ligand-exchange reaction enables the screening for high affinity ligands in complex samples. The feasibility of the method is demonstrated by using several ligands with a different affinity for either Cu(II) or Zn(II) ions. The selectivity of the ligand-exchange detection method can be tuned by the choice of the reporter ligand. This is demonstrated by using either 2,2'-bipyridyl or 5-methyl-1,10-phenanthroline as reporter ligands.     

Optimisation and validation of an automated solid phase extraction technique coupled on-line to enzyme-based biosensor detection for the determination of phenolic compounds in surface water samples

Summary A fully integrated screening system for phenolic compounds was developed incorporating on-line solid phase extraction, fractionation and biosensor detection. Two different types of biosensors, solid graphite and carbon paste electrodes incorporating the enzyme tyrosinase, were compared and used in the screening system. Interfacing of the solid phase extraction and fractionation with the biosensor detection was given special attention since the biosensors were not compatible with the organic modifier used for desorption of phenols from the solid phase extraction step. The system was validated with conventional analytical techniques. Surface water samples from the Ebro river were spiked with 1,10, and 25g L^–1 of catechol, phenol,p-cresol, respectively. Three out of seven samples were spiked and the correct samples were identified, containing phenols equivalent to the spiked concentrations.     

Quantitative Transfer of In-Gel Digest Products to Liquid Chromatography-Electrospray Mass Spectrometry Using On-Line Coupled Extraction

A system is described for the on-line extraction of a digested protein in a gel spot. The extract obtained was on-line transferred to a precolumn, used to desalinate and preconcentrate the sample. The precolumn was switched in-line with an LC-ESI-MS system to separate the digest products prior to detection. By using this approach sample losses were minimized and the sample was quantitatively transferred. The benefits of the system were shown for the in-gel tryptic digest of several model proteins. Using this system, the sensitivity was 13-fold increased compared to the off-line extraction of in-gel digest products leading to a higher sequence coverage and thus a better identification potential. Also, the within day repeatability was a factor 2.5 improvement using the on-line procedure compared to the off-line extraction procedure.     

High-performance liquid chromatography with on-line coupled UV, mass spectrometric and biochemical detection for identification of acetylcholinesterase inhibitors from natural products

A high-performance liquid chromatography (HPLC) method with on-line coupled ultraviolet (UV), mass spectrometry (MS) and biochemical detection for acetylcholinesterase (AChE) inhibitory activity has been developed. By combining the separation power of HPLC, the high selectivity of biochemical detection, and the ability to provide molecular mass and structural information of MS, AChE inhibitors can be rapidly identified. The biochemical detection was based on a colorimetric method using Ellman's reagent. The detection limit of galanthamine, an AChE inhibitor, in the HPLC-biochemical detection is 0.3 nmol. The three detector lines used, i.e., UV, MS and Vis for the biochemical detection were recorded simultaneously and the delay times of the peaks obtained were found to be consistent. This on-line post-column detection technique can be used for the identification of AChE inhibitors in plant extracts and other complex mixtures such as combinatorial libraries.     

Coverage‐ and Temperature‐Dependent Metalation and Dehydrogenation of Tetraphenylporphyrin on Cu(111)

Using temperature‐programmed desorption, supported by X‐ray photoelectron spectroscopy and scanning tunneling microscopy, a comprehensive overview of the main reactions of 5,10,15,20‐tetraphenyl‐21H,23H‐porphyrin (2HTPP) on Cu(111) as a function of coverage and temperature is obtained. Three reactions were identified: metalation with Cu substrate atoms, stepwise partial dehydrogenation, and finally complete dehydrogenation. At low coverage the reactions are independent of coverage, but at higher coverage metalation becomes faster and partial dehydrogenation slower. This behavior is explained by a weaker interaction between the iminic nitrogen atoms and the Cu(111) surface in the high‐coverage checkerboard structure, leading to faster metalation, and the stabilizing effect of T‐type interactions in the CuTPP islands formed at high coverage after metalation, leading to slower dehydrogenation. Based on the amount of hydrogen released and the appearance in STM, a structure of the partially dehydrogenated molecule is suggested.     

On Topological Properties of Min-Max Functions

We examine the topological structure of the upper-level set M ^max given by a min-max function φ. It is motivated by recent progress in Generalized Semi-Infinite Programming (GSIP). Generically, M ^max is proven to be the topological closure of the GSIP feasible set (see Guerra-Vázquez et al. 2009; Günzel et al., Cent Eur J Oper Res 15(3):271–280, 2007). We formulate two assumptions (Compactness Condition CC and Sym-MFCQ) which imply that M ^max is a Lipschitz manifold (with boundary). The Compactness Condition is shown to be stable under C ⁰-perturbations of the defining functions of φ. Sym-MFCQ can be seen as a constraint qualification in terms of Clarke’s subdifferential of the min-max function φ. Moreover, Sym-MFCQ is proven to be generic and stable under C ¹-perturbations of the defining functions which fulfill the Compactness Condition. Finally we apply our results to GSIP and conclude that generically the closure of the GSIP feasible set is a Lipschitz manifold (with boundary).