Growth patterns and implications of complex dendrites in calcite travertines from Lýsuhóll, Snæfellsnes, Iceland

Calcite dendrite crystals are important but poorly understood components of calcite travertine that forms around many hot springs. The Lýsuhóll hot-spring deposits, located in western Iceland, are formed primarily of siliceous sinters that were precipitated around numerous springs that are now inactive. Calcite travertine formed around the vent and on the discharge apron of one of the springs at the northern edge of the area. The travertine is formed largely of two types (I and II) of complex calcite dendrite crystals, up to 1 cm high, that grew through the gradual addition of trilete sub-crystals. The morphology of the dendrite crystals was controlled by flow direction and the competition for growth space with neighbouring crystals. Densely crowded dendrites with limited branching characterize the rimstone dams whereas widely spaced dendrites with open branching are found in the pools. Many dendrite bushes in the pools nucleated around plant stems. Growth of the dendrite crystals was seasonal and incremental. Calcite precipitation was driven by rapid CO₂ degassing of CO₂-rich spring waters during the spring and summer. During winter, when snow covered the ground and temperatures were low, opal-A precipitated on the exposed surfaces of the dendrites. Segmentation of dendrite branches by discontinuities coated with opal-A and overgrowth development around sub-crystals resulted from this seasonal growth cycle. The calcite dendrite crystals in the Lýsuhóll travertine differ in morphology from those at other hot springs, such as those at Lake Bogoria, Kenya, and Waikite in New Zealand. Comparison with the calcite dendrite crystals found at those sites shows that dendrite morphology is site-specific and probably controlled by carbonate saturation levels that, in turn, are controlled by the rate of CO₂ degassing and location in the spring outflow system.     

The isotopic composition of oxygen and carbon in the subfossil mollusc shells of the Baltic Sea as an indicator of palaeosalinity

The carbon (δ¹³ C) and oxygen (δ¹⁸O) isotopic composistion in mollusc shells in mainly determined by the isotopic composition of water and dissolved bicarbonate. The δ¹⁸O values of water show a good correlation with the salinity of the Baltic. This correlation served as a basis for reconstructing palaeosalinity and for stratifying the marine sediments according to the δ¹⁸O values of the carbonate skeletons of subfossil shells. The δ¹³C values in shells are mainly determined by the isotopic composition of land-originating bicarbonate, especially in the carbonate skeleton of Lymnaea balthica , which inhabits the immediate coastal zone. According to the δ¹⁸O data, salinity in the investigated area (the coastal area of W and NW Estonia) was highest (about 9–11%) during the Littorina stage. The Limnae a stage had, in general, a salinity similar to the contemporary one, but during some phases possibly exceeding it by 2–3%.     

Data processing and interpretation of sea radiance factor measurements

Problems in the interpretation of passive optical remote sensing data obtained by telespectrometric measurements on board a research vessel (or aircraft) are discussed. Two methods are considered: (1) The correlation method, where correlative relationships between the remotely sensed spectra and concentrations of optically active substances in the water are determined and corresponding regression formulae found; (2) the similarity method, where the remotely sensed spectrum is compared with the multitude of spectra obtained by means of model calculations. The application of these methods and analysis of the results are made using our remote and in situ data. It is found that the correlation method is far from being general (the regression parameters depend on the location, season and weather conditions), but it has the advantage of being applicable without the need to describe the aquatic environment by a theoretical model. The similarity method is much more general but involves difficulties in including the optical properties of the aquatic environment in the theoretical model, especially the backscattering properties of several types of suspended matter in the water bodies.
Some aspects of detecting oil-slick pollution on the sea surface by means of passive optical remote sensing methods are discussed and corresponding examples are shown.     

CHANGES IN DEPOSITION ON A COLLUVIAL FAN DURING THE UPPER HOLOCENE IN THE TINDASTÓLL MOUNTAIN, SKAGAFJÖRÐUR DISTRICT, NORTH ICELAND: PRELIMINARY RESULTS

This study investigates variability in depositional processes and landforms on the Innstaland colluvial fan, northern Iceland, over the late Holocene. This is completed using geomorphological mapping, historical records and relative‐age dating tools (vegetation survey, rock hardness and tephrochronology). Debris flows are the main contributors to fan development. Six main phases of deposition are distinguished, varying in deposit magnitude along a general trend of decreasing magnitude over time. With the help of dated tephra layers, the aggradation rates of the fan are calculated for the upper Holocene and in particular over the historical period (post‐ AD 1104). An episodic sediment transfer system is reconstructed, with several phases of low activity between more rapid aggradational episodes. The interpretation of the colluvial deposits suggests that the main phase of aggradation on the fan ended during the historical period after which incision started (between AD 1300 and 1766). Incision tracks act as the main pathways for debris distribution at the present time. These variations are related to the changing response of the catchment system over time.