A redundant multivalued logic for a 10-Gb/s CMOS demultiplexer IC

A redundant multivalued logic is proposed for high-speed communication ICs. In this logic, serial binary data are received and converted into parallel redundant multivalued data. Then they are restored into parallel binary data. Because of the multivalued data conversion, this logic makes it possible to achieve higher operating speeds than that of a conventional binary logic. Using this logic, a 1:4 demultiplexer (DEMUX, serial-parallel converter) IC was fabricated using a 0.18-/spl mu/m CMOS process. The IC achieved an operating speed of 10 Gb/s with a supply voltage of only 1.3 V and with power consumption of 38 mW. This logic may achieve CMOS communication ICs with an operating speed several times greater than 10 Gb/s.     

Mechanical properties of SiNxCx ceramic films prepared by plasma CVD

The mechanical properties of Si₃N₄-SiC, SiN_x and SiC_y films prepared at a low temperature of 400 °C by plasma chemical vapour deposition are reported. Microhardness, internal stress of the film and adhesive strength between the film and glass or stainless steel substrate were evaluated as principal mechanical properties. Microhardness was measured to be about 10 to 20 G Pa dependent on the film composition in each system. Internal stress of the films on borosilicate glass substrates extensively varied from tensile to compressive with the film composition change from Si₃N₄ to SiC. Adhesive strength, as ascertained by the scratch test, was about 580 to 800 MPa for crown glass substrates, and about 210 to 310 M Pa for 316 stainless steel substrates. It is pointed out that tensile stress in these films brought about more abrupt decreases of the adhesive strength than did compressive stress.     

Comfort limits for asymmetric thermal radiation

Groups of 32 and 16 subjects of both sexes were exposed in an environmental chamber to radiant asymmetry caused by a cool wall, a warm wall, and a cool ceiling. Each subject was tested individually while seated and clothed at 0.6 clo. During each 3.5-hour experiment the subject was exposed to six radiant temperature asymmetries. He was asked whether and where he experienced any local cool or warm sensation, and whether it was felt to be uncomfortable. During the entire experiment he was kept thermally neutral by changing the air temperature according to his wishes.For cool walls, warm walls, and cool ceilings curves have been established showing the percentage of dissatisfied subjects as a function of the radiant asymmetry. Radiant asymmetry at a warm wall caused less discomfort than a cool wall. A cool ceiling caused less discomfort than a warm ceiling. Accepting that 5% of the subjects may feel uncomfortable. a radiant temperature asymmetry of 10°C is allowable at a cool wall, 23°C at a warm wall, and 14°C under a cool ceiling. A previous study showed that 4°C is allowable under a warm ceiling. Radiant asymmetry had no significant impact on the operative temperatures preferred by the subjects. No significant differences were observed between the responses of men and women exposed to radiant asymmetry.     

Practical method for generation expansion planning based on dynamic programming

This paper presents an efficient method which provides the optimal generation mix and the optimal generation construction process. The approximation method in which the dynamic programming technique and gradient method are combined is applied to determine the optimal generation mix with hydropower generation technologies. The successive approximations dynamic programming (SADP) technique, which is very suitable for high-dimensional multistage decision process problems, is used for obtaining the optimal generation construction process. The effectiveness and feasibility of the developed technique are demonstrated on a practical power system model which has five types of generation technologies including a hydropower generation technology.     

A case of macrocystic cervical neurinoma diagnosed by MRI with Gd-DTPA

The authors report a rare case of a large cystic cervical neurinoma. A 45-year-old female was admitted to our clinic because of motor weakness of the right upper extremity, numbness of the right fingers and right posterior cervical pain. Metrizamide CT myelography demonstrated the outline of a low density mass. MRI showed a mass revealing low signal intensity on T1-weighted image, high signal intensity on T2-weighted image and marginal enhancement on contrast image with Gd-DTPA. The mass which was diagnosed as cystic tumor, was located in the intradural extramedullary space between C4 to C5 segments. After C4 through C5 laminectomy, the tumor was found to originate from the C5 anterior motor root. The tumor consisted mostly of a cystic part with a very thin solid compartment beneath the capsule. Postoperative course of the patient was uneventful. Although spinal neurinoma is one of the most common spinal tumors, an almost completely degenerated large cystic spinal neurinoma is extremely rare. MRI with Gd-DTPA was useful for the diagnosis of the cystic neurinoma by clearly enhancing the margin of the tumor.     

Effects of macrophage colony-stimulating factor (M-CSF) on lipopolysaccharide (LPS)-induced mediator production from monocytes in vitro

M-CSF is a macrophage-lineage-specific growth factor that causes proliferation and differentiation of progenitor cells in the bone marrow. To investigate the effects of M-CSF on more matured cells, human monocytes were cultured in the presence or absence of M-CSF for 6 days. Addition of M-CSF at more than 10(2) U/ml resulted in higher viability and caused morphological differentiation to large macrophage-like cells. LPS-induced mediator production was also compared between M-CSF-treated and control cell. Monocytes were incubated with or without M-CSF for 3 days, and were stimulated with 1 microgram/ml of LPS for 2 days. IL-1 beta was not detected in the both culture supernatants, and PGE2 production was not influenced by M-CSF. However, amounts of G-CSF, GM-CSF, IL-6, and TNF-alpha produced in response to 1 microgram/ml of LPS were 1.5 to 2 times greater from monocytes treated with 10(4) U/ml of M-CSF than from control cells. The priming effect of M-CSF on LPS-induced cytokine production was found to require 3-day preincubation, and reached a maximum at the concentration of 10(4) U/ml. M-CSF-treated cells responded to a 10 times lower concentration of LPS than control cells in terms of cytokine production. M-CSF was also shown by flowcytometric analysis to influence the expression of CD14, a receptor for LPS, which might render monocytes more sensitive to LPS.     

Operation of HTS Toggle-Flip-Flop Circuit With Improved Layout Design

Toggle-flip-flop (T-FF) is one of the most important high-T_c superconducting single-flux quantum (HTS SFQ) circuit components and has been designed and fabricated by using YBa₂Cu₃ O_7-delta ramp-edge junction technology. The circuit layout of the T-FF was improved to suppress the junction critical current (I_c) spread in the circuit. Test circuits, which include a T-FF with a single output for evaluating the logic operation and measuring the operating frequency, were fabricated and their operation characteristics were investigated. The T-FF circuit with a single output was successfully operated and finite direct current (dc) supply current margins were obtained at temperatures from 27 to 34 K. Moreover, the maximum operating frequency of the T-FF was estimated to be 360 GHz at 4.2 K and 114 GHz at 41 K. In addition, reduction of dc supply current margins due to thermal noise was also investigated. According to the numerical simulation in which parasitic inductances were taken into account, the narrowest margin in the T-FF circuit wider than plusmn10% was maintained with a bit-error rate (BER) of 10^-6 up to 40 K     

New approach to aortic dissection: development of an insertable aortic prosthesis

We have developed a new aortic prosthesis with which we can replace or reinforce the aorta using a simple percutaneous technique. We have named the new prosthesis the shape-memory aortic prosthesis (SAP); it consists of a spiral-shaped nitinol stent and polyurethane tube. It can be compressed inside a 14F catheter at a low temperature and regain its original shape at above 30 degrees C. As a preliminary study, SAP sutureless grafting into the descending aorta was performed on 10 mongrel dogs. We found that when the proper diameter of SAP was applied, it functioned satisfactorily for 3 months or more. A percutaneous placement technique pertinent to the SAP also was developed and tried on 4 animals. Our procedure was applied to Stanford type B dissection models to close the entry point successfully. This newly developed SAP has potential to be applied to emergency cases of human aortic dissections.