贵金属助剂对费-托合成用钴基催化剂的促进作用

贵金属助剂促进的费-托合成用钴基催化剂具有高活性和长链烃(C₅⁺)选择性优越等特点,被广泛应用于由合成气制清洁燃料的合成反应中。 本文重点讨论了贵金属助剂对活性钴物种的结构（还原度、分散度、双金属颗粒或合金的构成）, 钴基催化剂稳定性以及其对费-托合成的反应速率和产物选择性的影响规律。     

Flexural resonance vibrations of piezoelectric ceramic tubes in Besocke-style scanners

Flexural resonance vibrations of piezoelectric ceramic tubes in Besocke-style scanners with nanometer resolution are studied by using an electro-mechanical coupling Timoshenko beam model.Meanwhile,the effects of friction,the first moment,and moment of inertia induced by mass loads are considered.The predicted resonance frequencies of the ceramic tubes are sensitive to not only the mechanical parameters of the scanners,but also the friction acting on the attached shaking ball and corresponding bending moment on the tubes.The theoretical results are in excellent agreement with the related experimental measurements.This model and corresponding results are applicable for optimizing the structures and performances of the scanners.     

水溶性磺酸钠苯基卟啉及其金属配合物共价与非共价修饰多壁碳纳米管的研究

合成了meso-四(4-磺酸钠苯基)卟啉及其Zn, Cu, Mn配合物, 通过共价与非共价的方法将其分别修饰到多壁碳纳米管上. 采用红外光谱对产物结构进行表征|通过透射电镜(TEM)考察了卟啉-多壁碳纳米管复合物的形貌特征|通过紫外光谱、荧光光谱对比分析了两类复合物, 发现在卟啉与多壁碳纳米管之间存在较强的电子效应, 同时发现非共价修饰的卟啉-碳纳米管复合物的荧光淬灭率更高|热重分析(TGA)表明非共价的卟啉-碳纳米管复合物中卟啉的含量比较高. 对修饰后的复合物进行了溶解性测试, 结果表明共价修饰的复合物在水中有较好的溶解性和分散性.     

基于带电粒子活化法开展的SGⅡ-U皮秒激光质子加速实验研究

基于带电粒子活化测谱方法在SGⅡ-U装置上开展了皮秒激光靶背鞘场机制质子加速实验研究,对靶参数进行了优化.利用带电粒子活化测谱方法测量了相同激光条件、不同Cu薄膜靶厚度情况下靶背鞘场加速质子的最高截止能量、角分布、总产额以及激光能量到质子的转化效率等关键参数.实验发现,SGⅡ-U皮秒激光靶背鞘场加速机制的最佳Cu薄膜靶厚度为10 μm,对应质子最高能量接近40 MeV,质子（>4 MeV）总产额约4×10¹²个,激光能量到质子的转化效率约2%.薄膜靶更厚或者更薄都会降低加速质子的最高截止能量;当靶厚减薄至1 μm时,皮秒激光的预脉冲开始对靶背鞘场产生显著影响,质子最高截止能量急剧下降,高能质子束斑呈现空心结构;而当靶厚增加至35 μm时,虽然质子束的能量有所降低,但是质子束斑的均匀性更好.     

基于ANSYS Workbench热板电加热与油加热模拟及对比分析

为改善平板硫化机热板表面温度场分布的均匀性, 对规格为75mm×2400mm×2400mm的平板硫化机热板进行了有限元模拟. 利用ANSYS Workbench软件分别模拟热板电加热与导热油加热情况, 并进行对比分析. 结果表明, 针对同一块热板在加热到190℃工作温度左右时, 电加热热板表面温差为12.012℃, 导热油加热热板表面温差为9.2℃. 模拟分析结果表明, 采用导热油加热热板表面温度均匀性更高、升温速率更快; 且入口流速在4m?s-1时, 温度场均匀性得到明显改善.     

Acoustic-electromagnetic slow waves in a periodical defective piezoelectric slab

Coupled slow waves, slow acoustic waves, and electromagnetic waves are simultaneously achieved based on a piezoelectric material, in which a line defect is created within a honeycomb lattice array of cylindrical holes etched in a LiNbO_3 slab. Finite element simulations in frequency domain and time domain demonstrate that a highly localized slow mode is obtained in the defect. Owing to the piezoelectricity of LiNbO_3, acoustic and electromagnetic waves are coupled with each other and transmit along the line defect. Therefore, in addition to a slow acoustic wave, an electromagnetic wave with a group velocity even lower than conventional acoustic waves is achieved.     

基于巴西劈裂法的饱水煤样能量耗散特征研究

为研究饱水煤样拉伸破坏过程中的能量耗散规律,利用RMT-150B岩石力学实验系统对赵固二矿二1煤层煤样在自然和饱水状态下进行巴西圆盘劈裂实验,探讨了自然与饱水状态下煤样的应力、强度及能量变化。结果表明:巴西劈裂实验时,加载过程应力-时间关系与实验控制方式有关。采用载荷控制方式时,峰值前拉应力与时间呈良好线性关系,达到峰值时应力瞬间跌落为零,表现出明显脆性破坏特征;采用变形控制方式时峰值前拉应力与时间呈非线性关系,峰值后出现分次破坏特征;采用两种控制方式在巴西圆盘劈裂实验破坏前没有本质区别;两种状态下不同层位煤样抗拉强度和峰值能率存在差异,自然状态下层位煤样抗拉强度较高(1.80MPa),中层位煤样抗拉强度较低(1.23MPa),上层位煤样抗拉强度介于两者之间(1.52MPa),饱水后上中下层位煤样的抗拉强度和峰值能率均有不同程度降低,抗拉强度平均软化系数分别为0.65,0.61和0.61,平均峰值能率降幅为36.0%,56.1%和40.6%;两种状态下煤样抗拉强度与峰值能率大致呈线性关系,表明抗拉强度越高的煤样,能量耗散越少,煤样抗拉强度越低,能量耗散越多。     

复间冷机组高温时段汽轮机排汽真空优化管理

本文基于复合制冷循环间接空冷(复间冷)系统的结构组成和传热过程,定性分析了环境气温对干、湿冷机组排汽真空影响机理的异同,确定了复间冷机组汽轮机排汽真空的影响因素,建立复间冷机组高温时段变工况特性下排汽真空计算模型,并以最佳真空为目标,给出运行工况复间冷机组高温时段最佳真空的计算方法。以600 MW虚拟复间冷机组参数为基准,通过分析计算,揭示了复间冷机组高温时段最佳真空变化规律以及压缩机的相应运行特性,所得结果可为高温时段复间冷系统设计和运行优化提供可靠理论依据。     

Dose estimation and shielding calculation for X-ray hazard at high intensity laser facilities

An ionizing radiation hazard produced from the interaction between high intensity lasers and solid targets has been observed. Laser-plasma interactions create "hot" electrons, which generate bremsstrahlung X-rays when they interact with ions in the target. However, up to now only limited studies have been conducted on this laser-induced radiological protection issue. In this paper, the physical process and characteristics of the interaction between high intensity lasers and solid targets are analyzed. The parameters of the radiation sources are discussed, including the energy conversion efficiency from laser to hot electrons, hot electron energy spectrum and electron temperature, and the bremsstrahlung X-ray energy spectrum produced by hot electrons. Based on this information, the X-ray dose generated with high-Z targets for laser intensities between 10¹⁴ and 10²⁰ W/cm² is estimated. The shielding effects of common shielding items such as the glass view port, aluminum chamber wall and concrete wall are also studied using the FLUKA Monte Carlo code. This study provides a reference for the dose estimation and the shielding design of high intensity laser facilities.     

基于自适应EKF的弱GNSS信号跟踪算法

弱GNSS信号跟踪技术是卫星导航接收机关键技术之一,跟踪技术的好坏将直接影响卫星导航接收机在弱信号条件下的跟踪性能;在动态环境和先验信息不充分的情况下,由于扩展卡尔曼滤波(EKF)的固定设计使其不能满足要求,针对此不足引入一种自适应扩展卡尔曼滤波(AEKF)的信号跟踪算法;该自适应滤波算法能够实时监测残差或滤波器新息的动态变化,来修正观测噪声方差和状态噪声方差,以此调整滤波器增益,观测值和控制预测值在滤波结果中的权重;理论分析和结果表明,该算法能够充分利用观测信号的统计特性,克服了传统EKF算法不足,获得更好的跟踪性能。