溶胶–凝胶法制备ATO-SiO_2抗静电复合薄膜的特性研究

采用两步溶胶–凝胶法制备出 ATO(掺锑氧化锡)-SiO_2复合抗静电薄膜。通过 DTA-TG、XRD、SEM 对 薄膜的结构和形貌进行了表征,结果表明:抗静电复合薄膜表面均匀致密。薄膜中 SiO_2为无定形结构,ATO 的衍射峰 与 SnO_2一致。研究了 SnO_2的含量对薄膜导电性能、结合强度和透过率的影响,发现随 SnO_2含量增加 ?(SnO_2/ SiO_2)从 5 至 12.5,薄膜的表面电阻降低(从 1010ù/□降低到 108ù/□),薄膜的结合强度下降,薄膜的透过率降低(从 89.0%降至 84.2%),结合三方面性能,得出最佳 SnO_2的配比为:?(SnO_2/ SiO_2)=10。     

一种基于DBF的双基地雷达系统的性能分析与实验研究

讨论了一种基于数字波束形成的脉冲追赶式双基地雷达系统的构成和基本工作原理．对该双基地雷达的性能进行了理论分析，并通过实验结果进行了验证。     

Preparation and properties of poly(ethylene oxide) star polymers

Poly(ethylene oxide) (PEO) star polymers were prepared by anionic polymerization of methacryloyl chloride and glyceryl trimethacrylate with sec‐butyllithium in cyclohexane. The ensuing polymers were grafted with poly(ethylene glycol) of molecular weight 400. The final product was washed with methylene chloride and analyzed with infrared spectroscopy, differential scanning calorimetry, and thermogravimetry. Star polymers of PEO were also prepared by anionic polymerization of glycidol with sec‐butyllithium in cyclohexane. The initiator was chosen so as to yield a polymer of 10,000 molecular weight. The resulting polymers were analyzed by nuclear magnetic resonance, infrared spectroscopy, and thermogravimetry. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 87: 322–327, 2003     

基于片上DC-DC的CMOS光接收机前置放大器

利用CSMC 0.6μm CMOS工艺,设计了基于片上DC-DC转换器的光接收机前置放大器。电路采用可调跨阻放大器与片上DC-DC结构,有效地克服了单端跨阻放大器易受电源波动的干扰,并解决了高灵敏度与低失真相互矛盾的问题。模拟结果表明,输入动态范围为83 dB(峰-峰值=0.2μA~3 mA),等效输入电流噪声为1.2 pA/Hz(155 MHz),可稳定工作在155 Mb/s速率上;在5 V电源电压下,功耗为95 mW。     

供电器可供放大器最大级数的计算

有线电视电缆网采用供电器进行集中供电，要计算一个额定容量的供电器可供放大器的最大级数，算式是很复杂的，而用VisaulFOXPRO6．0编写一个小程序，利用电脑对上述问题进行处理，就变得简单易用。     

TMS320F240串口通信特征及其应用

主要论述了TMS320F240串行外设接口模块的特点，并通过与MCS5l单片机通信，实现液晶显示。     

Aggregate States and Energetic Disorder in Highly Ordered Nanostructures of para‐Sexiphenyl Grown by Hot Wall Epitaxy

We report on photoluminescence (PL) and thermally stimulated luminescence (TSL) in highly ordered nanostructures of para‐sexiphenyl (PSP) grown by hot wall epitaxy (HWE). A low‐energy broad band is observed in the PL spectra that can be attributed to the emission from molecular aggregates. While the intrinsic exciton emission in steady‐state PL dominates at low temperatures, the emission from aggregates increases with elevating temperature and its magnitude depends sensitively on film preparation conditions. Time‐resolved PL measurements showed that the aggregate emission decays with a life‐time of ≈ 4 ns, which is approximately an order of magnitude larger than the lifetime of singlet excitons. TSL data suggests the presence of an energetically disordered distribution of localized states for charge carriers in PSP films, which results from an intrinsic disorder in this material. A low‐temperature TSL peak with the maximum at around 30 K evidences for a weak energy disorder in PSP films, and has been interpreted in terms of a hopping model of TSL in disordered organic materials.     

TRVs and fault clearing stresses in extra-high-voltage radial networks

To cope with the high rate of increase of power demand in the main industrialized districts in Japan, 550-kV transmission systems covering the districts have been reinforced, with most of the main power plants connected directly to these systems. Through 550-/300-kV substations, the majority of power to the districts is supplied by 300-kV systems. To limit the excess short-circuit capacity in the 300-kV systems, they tend to be reconstructed as so-called radial networks. In radial networks with high short-circuit capacity and relatively small number of transmission lines connected to the substation busbars, the rate of rise of TRV can be far higher than standard value. This paper analyzes the transient recovery voltages (TRV) in such extra-high-voltage radial networks in Japan, together with the relevant stresses to circuit-breakers during fault clearings. Future system conditions have also been introduced. As the typical rate of rise of the TRV values, more than twice that of today's standard ones are probable.     

丙烯酸酯与甲基丙烯酸酯的共聚及性能研究

采用悬浮聚合法，以丙烯酸－２－乙基－己酯与甲基丙烯酸十二酯为单体，合成了共聚型高吸油性树脂。研究了共聚单体的配比、交联剂用量、引发剂用量诸因素对高吸油性树脂的性能影响。制得的树脂可以吸其自身质量的１１．８倍的煤油、１４．７倍的苯、６．５倍的泵油。     

高放废液中^147Pm的测定

建立了高放废液中~(147)Pm的测定方法。用HDEHP萃取稀土,再用HDEHP萃淋树脂柱分离AM和稀土。然后用高效液相色谱法将~(147)Pm从Eu、Ce等其它稀土中分离出来,用液体闪烁法测量~(147)Pm的放射性活度。