300M钢腐蚀疲劳裂纹萌生的超载特性

本文对３００Ｍ钢在空气与３．５％ＮａＣｌ溶液中疲劳裂纹萌生的周期超载和单次超载特性进行了试验研究与理论分析。试验结果表明，３．５％ＮａＣｌ溶液中，单次超载所致腐蚀疲劳裂纹迟滞萌生的迟滞强度远小于周期超载的对应值。３．５％ＮａＣｌ溶液与空气中，超载迟滞强度均随超载比增大或等效应力幅水平的提高而增大，在腐蚀疲劳裂纹萌生寿命估算中，只考虑单次超载的迟滞规律，会得出大大保守的寿命估计，只有将单次超载和周期     

The internal-nitriding behavior of 310 stainless steel with and without Al and Ti additions

The internal-nitriding behavior in ammonia-hydrogen atmospheres of type-310 stainless steel and 310 to which either 2 wt.% Ti or 3 wt.% Al were added was studied over the range of 550–950°C. An Fe-24Cr binary alloy was included to assess the role of a BCC crystal structure vs the FCC crystal structure of 310 stainless steel. The BCC alloy exhibited the most rapid kinetics as expected. X-ray diffraction showed only the presence of CrN in all the alloys up to 735°C. At 850°C and above, both CrN and Cr₂N were detected. The nonformation of TiN and AlN at lower temperatures is attributed to nucleation problems. Precipitates were extremely fine (unresolvable even at 20,000×) at 563°C and became much coarser with increasing temperature. The precipitate density, size, and shape varied across the internal-nitriding zone at the higher temperatures. External scaling was noted at 850°C and above, however, it was not a continuous film. The activation energy of internal nitriding from 563–735°C ranged from 3.8 kcal/mol for 310+2Ti to 18.2 kcal/mol for 310+3Al; from 850–950°C, the activation energy ranged from 44 (310+2Ti) to 56.6 kcal/mol (310+3Al). Microhardness profiles show that an intermediate zone exists between the nitride case and the base metal. The origin of this zone is discussed.     

Estimation in Random Coefficient Autoregressive Models

Abstract. We propose the quasi‐maximum likelihood method to estimate the parameters of an RCA(1) process, i.e. a random coefficient autoregressive time series of order 1. The strong consistency and the asymptotic normality of the estimators are derived under optimal conditions.     

Consistent estimation of the memory parameter for nonlinear time series

Abstract. For linear processes, semiparametric estimation of the memory parameter, based on the log‐periodogram and local Whittle estimators, has been exhaustively examined and their properties well established. However, except for some specific cases, little is known about the estimation of the memory parameter for nonlinear processes. The purpose of this paper is to provide the general conditions under which the local Whittle estimator of the memory parameter of a stationary process is consistent and to examine its rate of convergence. We show that these conditions are satisfied for linear processes and a wide class of nonlinear models, among others, signal plus noise processes, nonlinear transforms of a Gaussian process ξ_t and exponential generalized autoregressive, conditionally heteroscedastic (EGARCH) models. Special cases where the estimator satisfies the central limit theorem are discussed. The finite‐sample performance of the estimator is investigated in a small Monte Carlo study.     

干旱指数在四川省的适用性分析

干旱灾害频发严重制约着四川省的农业发展,为合理分析四川省干旱情况,干旱指数的选择尤为重要。本文基于四川省39个气象站点1960年-2013年的气象资料,分别计算1961年、1994年、2006年和2009年-2010年各站点相对湿润指数M、气象干旱综合指数CI、标准化降水指数SPI和标准化降水蒸散指数SPEI,利用Arcgis反距离插值法进行空间插值,并与中国气象灾害大典记录的四川省典型年干旱情况进行对比分析,进而评价四种干旱指数在四川省的适用性。结果表明:对于1961年夏旱,M指数和CI指数均表现出无旱或轻旱,SPI指数结果较实际情况偏小,SPEI指数监测出了干旱的重灾区,效果在四个干旱指标中最好;1994年夏伏旱,M指数监测结果偏小;CI指数出现了空报,对川东地区和川西高原的监测结果偏小,SPEI指数在达县、巴中一带结果偏小,而SPI指数在成都、绵阳一带的结果偏小。2006年伏旱,M指数监测结果偏小;CI指数比M指数效果稍好,但结果仍然偏小;SPI指数和SPEI指数监测出的干旱特征与实际一致;2009年-2010年的冬春连旱,SPEI指数效果最好,M指数次之,SPI指数效果最差。SPEI指数最能反映四川省典型干旱年干旱的空间分布特征。     

橡胶硫化促进剂NS的合成研究

本研究采用促进剂M、叔丁胺为原料,以过氧化氢为氧化剂,用水做溶剂在酸性条件下合成橡胶硫化促进剂NS。并通过实验得到优化工艺条件:n(叔丁胺)/n(促进剂M)为2.0、n(过氧化氢)/n(促进剂M)为1.5、反应温度为60℃和反应时间为90min,在此工艺条件下合成橡胶硫化促进剂NS的收率可达90.0%。     

Characterization of microporous-mesoporous MCM-41 silicates prepared in the presence of octyltrimethylammonium bromide

MCM-41 silicates prepared in the presence of octyltrimethylammonium bromide either by a conventional method or by post-synthesis hydrothermal treatment were characterized by nitrogen adsorption in a wide range of relative pressure from 10^-6 to 1. Hydrothermally restructured samples were found to have lower BET surface areas, lower external surface areas and thicker silica walls than the non-treated sample. More importantly, in addition to their characteristic mesopores (ca. 3 nm), they were shown to have considerable amounts of micropores. The relative amount of micropores and mesopores was shown to be dependent on the treatment conditions. Thus, it is demonstrated that the postsynthesis hydrothermal restructuring is a convenient synthesis route to MCM-41 silicates with bimodal pore size distribution involving controllable amounts of microporosity. This revised version was published online in July 2006 with corrections to the Cover Date.     

羊布鲁菌O链M抗原提纯及其单克隆抗体的研制

目的研制羊布鲁菌O链M纯化抗原及其单克隆抗体。方法采用冷酚法提纯羊布鲁菌16M的O链抗原,并经琼脂糖凝胶免疫扩散和SDS-PAGE鉴定,用灭活的该抗原免疫BALB/c小鼠,制备单克隆抗体,并进行鉴定。结果建立3株分泌单克隆抗体的细胞株2D10、3C6和1E10,ELISA效价分别为1.380、1.109和1.048,与大肠杆菌0:157、小肠结肠炎耶尔森菌0:9、鼠伤寒沙门菌和猪胸膜肺炎放线杆菌均无交叉反应。3C6和1E10与牛布鲁菌544A发生交叉反应,2D10的亲和常数达5.30×10~7M~(-1)。结论已制备出纯化的羊布鲁菌O链M抗原及其单抗。     

基于XC2287M的工程机械ECU设计

ECU是工程机械电控系统的核心部件,目前国内中高端ECU市场基本被国外厂商所垄断。设计了一款基于XC2287M微控制器的工程机械智能ECU,采用CODESYS软PLC作为编程平台,支持IEC 61131-3定义的5种标准PLC语言进行编程。所设计的ECU拥有丰富的I/O资源和完善的安全保护机制,能够广泛应用于各种工程机械控制系统,打破国外厂商对ECU市场的垄断。     

Parameter Estimation for Periodically Stationary Time Series

Abstract. The innovations algorithm can be used to obtain parameter estimates for periodically stationary time series models. In this paper, we compute the asymptotic distribution for these estimates in the case, where the innovations have a finite fourth moment. These asymptotic results are useful to determine which model parameters are significant. In the process, we also develop asymptotics for the Yule–Walker estimates.