环境因子的定义及研究现状

从普遍接受的三个基本假设出发，讨论环境因子的定义和失效机理不变的约束条件，重点综述环境因子的研究现状和常用方法，并探讨引入反应论模型解决环境因子预测问题的可能途径。     

涂料的发展和市场新动态（Ⅰ）

介绍了近年来国内外涂料生产和市场的一些情况,特别对国外企业在中国投资设厂的分布和产能做了重点论述,介绍了近年来国内外研发的一些新产品。     

Danckwerts’ law for mean residence time revisited

This paper shows that Danckwerts’ law for mean residence time in a vessel with continuous and steady throughflow holds for a stochastic model based on a Markov chain for the particle spatial position, under a set of three very general conditions on the transfer probabilities. These are natural conditions and represent mass balance conditions on the transfer between spatial regions in the process. It is shown that a stochastic model for particle residence time distribution with these three conditions may describe almost any physical flow configuration, and also covers published mathematical RTD models, independent of their mathematical form or the nature of the associated boundary conditions, models for which Danckwert's law has hitherto been shown to be satisfied on a case-by-case basis. Two examples, namely those birth-death Markov chains and fluidized bed models are discussed.     

东营凹陷古近系烃源岩超压特征及分布规律

统计分析1307口探井实测压力系数和83l口探井使用的钻井液密度数据，发现东营凹陷古近系沙三段、沙四段普遍存在异常超压，超压(压力系数1．1-1．5)主要出现在2100-3500m深度，强超压(压力系数大于1．5)主要出现在2800-3500m深度。东营凹陷沙三段、沙四段主力烃源岩超压平面分布具有北高南低、东高西低的总体特点，超压主要分布在洼陷带、断裂构造带和中央背斜带上。烃源岩压力系数等值线北部陡坡带比较密集，南部缓坡带相对稀疏。生油洼陷中心附近异常高压带的分布与生油洼陷基本一致，洼陷深陷区压力系数很大，向周围斜坡和构造高部位呈辐射状逐渐减小至正常，压力分布带与洼陷、边缘斜坡和构造较高部位的欠压实与压实带发育、分布规律的一致性很好。图3表l参9     

德兴铜矿变配电网络地理信息系统设计与实践

介绍了矿山变配电地理信息系统的设计与实施。     

Runout analysis in fatigue investigation

Those individual tests in a series of experiments that are not completed or must be suspended are known as “censored points,” or “runouts”. Inclusion of runouts in data analysis can be problematic, and such ad hoc approaches as ignoring the runout observation or treating it as a failure can significantly affect estimation. The methodology offered here alleviates the handling of runouts and censored data by using the maximum likelihood estimation (MLE) method to incorporate the censored data properly. The methodology is illustrated with an example problem using actual data and the affects of ad hoc approaches are illustrated.     

Electrostatic destabilization of water-in-crude oil emulsions: Application to a real case and evaluation of the Aibel VIEC technology

In the current study, the Aibel Vessel Internal Electrostatic Coalescer (VIEC) technology was tested for a real case scenario encountered in the production train of a UK oil field. Depressurized samples were collected both upstream and downstream of the first stage separator. The separation performance was discussed with respect to water cut and droplet size distribution of the emulsions, and the effect of chemical treatment. Issues with respect to representative sampling and testing have been discussed. The application of an external AC electrical field has been shown to significantly enhance the separation of the aqueous phase from tight emulsions, both when it was used alone and in combination with a commercial demulsifier. By using the VIEC technology, the time for separation could be reduced from 8 min to 2 min and the overall BS&W in the emulsions was improved from 45% or 60% to a residual water content of 5-20%. Destabilization of a 45% water-in-oil emulsion by electrical and chemical treatment (20/40 ppm) produced oil in the 2-7% BS&W range whereas the corresponding tests without applying an electrostatic field led to a BS&W greater than 25%. The achieved results strongly suggest that the VIEC technology can resolve the stable emulsion bands encountered in the Schiehallion train and add flexibility or increased production rate to the process. The results also suggest the importance of further studies on the destabilization performances achieved by electrostatic means.     

Accelerated wear testing with a microfabricated surface to evaluate the lubrication ability of biomolecules on polyethylene

Wear of ultrahigh‐molecular‐weight polyethylene (UHMWPE) and wear‐particle‐induced osteolysis and bone resorption are the major factors causing the failure of total joint replacements. It is feasible to improve the lubrication and reduce the wear of artificial joints. We need further understanding of the lubrication mechanism of the synovial fluid. The objective of this study is to evaluate the lubricating ability of three major components in the synovial fluid: albumin, globulin, and phospholipids. An accelerated wear testing procedure in which UHMWPE is rubbed against a microfabricated surface with controlled asperities has been developed to evaluate the lubrication behavior. An analysis of the wear particle dimensions and wear amount of the tests has provided insights for comparing their lubrication performance. It is concluded that the presence of biomolecules at the articulating interface may reduce friction. A higher concentration of a biological lubricant leads to a decrease in the wear particle width. In addition, in combination with the wear results and mechanical analysis, the roles of individual biomolecules contributing to friction and wear at the articulating interface are discussed. These results can help us to identify the role of the biomolecules in the boundary lubrication of artificial joints, and further development of lubricating additives for artificial joints may be feasible. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2008     

图片彩色参数数字滤波设计

颜色和形状信息是识别物体的重要信息．本文提出用数字滤波器将图象空间分割为H包含M和M/H空间的一种方法．该方法进一步将分析彩色图象为众所周知的测量分割部分几何特征的算法，包括通过节点的阶数确定分割部分的分布及动态特征，包括速度和移动方向的分布等．