Study on the anodic film formation process of AZ91D magnesium alloy

The formation of anodic film of AZ91D magnesium alloy has been investigated by means of electrochemical impedance spectroscopy (EIS), cyclic voltammetry, anodic polarization curve, current-time transients and SEM technique. The results show that, under our experimental conditions, the formation of AZ91D anodic film follows the mechanism of 3D nucleation with diffusion controlled growth. With the increase of applied anodizing potential, the nucleation type of anodic film changes from progressive to instantaneous. The results also show that the initially formed anodized film is threadlike and porous, and high potential is essential for the formation of good anodic film with excellent properties.     

D,L-对羟基苯甘氨酸的合成研究

对利用氨基磺酸、苯酚、乙醛酸合成D,L 对羟基苯甘氨酸的方法进行研究,利用薄层色谱分析优化了反应条件。合成D,L 对羟基苯甘氨酸的最佳工艺条件为:投料摩尔比苯酚∶氨基磺酸∶乙醛酸=1∶1.2∶1,以水为溶剂,浓硫酸为催化剂。一般0.1mol的乙醛酸加入20ml的水,1～2ml的浓硫酸。温度控制在40～60℃,反应5～6h。单程收率可达66.7%,母液回收套用后收率达83.8%,产品的结构用1H NMR,13C NMR进行鉴定。     

氧化合成对羟基苯甲醛的研究

研究了在硫酸介质中用Mn3+氧化对甲苯酚合成对羟基苯甲醛适宜的工艺条件:反应温度50℃,反应时间60 m in,硫酸浓度7.0 mol/L,搅拌速度为600 r/m in。粗产品经多步过滤分离法提纯,其总产率可达64.63%。     

Polymorphism of tricalcium silicate, the major compound of Portland cement clinker: 2. Modelling alite for Rietveld analysis, an industrial challenge

A comprehensive quantification of the various phases of clinkers by X-ray diffraction with a Rietveld-like analysis is an important industrial challenge. Various available structural models are used for the most frequent M1 and M3 polymorphs of alite usually found in industrial clinkers, referred to as M1- or M3-based clinkers. In this paper, the effect of C₃S structural model is investigated. Four models are tested and compared using either synthetic M1 and M3 alites or M1- and M3-based clinkers. The comparison validates the available models for M1 and M3 alites and an average model, given here, derived from our recently proposed M1 structure as a catch-all model when the nature of the clinker is unknown. The latter model is meant to be used for industrial on-line quantification.     

异丁醛合成2,4,6-三异丙基-1,3,5-三噁烷的研究

本文以异丁醛为原料在杂多酸催化剂的作用下，环化合成了无毒升华剂2，4，6－三异丙基－1，3，5－三恶烷，考查了各种反应条件的影响，确定以磷钨酸为催化剂时的最佳反应条件：反应温度25℃，催化剂用量1．5％，反应时间2．5h，产物的收率达84％以上。     

纳米CaCO3的表面改性研究

本文研究了纳米CaCO3表面改性的影响因素，确定了最优改性剂和改性条件，并运用沉降实验、透射电镜（TEM）等表征手段对粉体的改性效果进行了分析。结果表明：以月桂酸钠为改性剂，用量为10％，pH值为7，改性时间为1h时，改性后的纳米CaCO3的亲油化度达到85．1％，能较好地分散于环己烷和二甲苯中。     

不同方法制备丙酮一步法合成甲基异丁基酮催化剂Cu-MgO-Al2O3的比较

采用浸渍法及共沉淀法分别制备丙酮一步法合成甲基异丁基酮催化剂Cu-MgO-Al2O3，通过考察催化剂的催化性能，研究不同方法制备催化剂对其活性的影响。结果表明，催化剂中碱性组分与金属组分含量匹配合适才能得到最佳的反应结果，共沉淀法催化剂比浸渍法催化剂具有更大的比表面积和孔体积，进料速率高，活性好。     

纳米四氧化三铁磁性微粒的表面有机改性

通过液相共沉淀法制备了纳米四氧化三铁溶胶，利用油酸对纳米粒子体进行表面改性和萃取实验，获得油酸包覆的四氧化三铁微粒。采用FT—IR和高分辨透射电镜对改性后的纳米粉体进行结构和形貌的表征。研究结果表明油酸与四氧化三铁纳米粒子间存在化学键结合。油酸对纳米四氧化三铁微粒进行改性，并且对纳米粒子进行包覆，使外表面形成保护层阻止粒子团聚，改性后的四氧化三铁微粒与有机物具有良好的相溶性，采用表面改性显著改善了纳米四氧化三铁微粒的性能指标。     

Oxygen transport in ferrite-based ceramic membranes: Effects of alumina sintering aid

Moderate additions of Al₂O₃ to strontium ferrite-based mixed conductors, such as SrFe_0.7Al_0.3O_3−δ and La_0.2Sr_0.8Fe_0.8Ga_0.2O_3−δ with the composition close to the solid solution formation limits, make it possible to improve ceramics sinterability, to increase oxygen permeability and to decrease thermal expansion. These effects are associated with the segregation of alumina-rich phases, primarily SrAl₂O₄, and the formation of A-site cation-deficient perovskite. The improved properties of the SrFe_0.7Al_0.3O₃-based material were used to fabricate high-quality tubular membranes for methane conversion reactors. Similar enhancement in sinterability is also observed for another promising parent material of mixed-conducting membranes, La_0.5Sr_0.5FeO_3−δ. However, extensive dissolution of Al³⁺ cations in the iron sublattice, creation of A-site vacancies and changing the La:Sr concentration ratio all lead to decreasing ionic transport in La_0.5Sr_0.5FeO_3−δ. As a result, additions of either Al₂O₃ or SrAl₂O₄ have a deteriorating influence on the oxygen permeation fluxes through La_0.5Sr_0.5FeO₃-based ceramics.     

7-氨基-6-氰基-5-(3-硝基苯基)吡喃并嘧啶-2,4-二酮的合成

报道了常温、超声辐射、水中、无催化剂条件下，以3-硝基苯甲醛、丙二腈和巴比妥酸为原料合成标题化合物的方法。考察了超声技术、反应时间及反应温度对反应的影响。最佳反应条件为：室温、超声辐射2h，收率为86．2％。