提高深井硬地层钻井速度技术难点及对策

乌龙1井地层为南方海相沉积,地层古老、岩石硬度大、研磨性强、可钻性差、地层倾角大(最大为80°)井斜难以控制、蹩跳钻严重,制约了该地区深井钻井速度。文章介绍了解决提高钻井速度这一瓶颈问题,从深井优快钻井及其配套技术、硬地层钻进的钻头优选、优化钻井参数、引用新技术、新工艺、新工具等方面进行了探索,钻井速度有了大幅度地提高,对类似井具有一定的借鉴作用。     

利用MSTP技术组建市级公安专网

本文介绍广电采用MSTP技术组建市级公安专网的具体方案，分析组网过程中遇到的常见问题。     

基于C6711处理器cdma2000 1X系统前向信道信号的处理

在cdma20001x前向信道中,要对一段信号进行传送,一般选用QPSK调制,因为QPSK调制比QAM更适合噪音环境。采用TI6000系列的TMS320C6711芯片处理前向信道信号,可以对复杂性和实时性较高的信号做采集、量化、编码、调制等实时处理,主要功能通过软件编程实现,从而使系统具有结构灵活、可靠性高、可扩展等优点。     

1/f noise in large-area Hg<Subscript>1−x</Subscript>Cd<Subscript>x</Subscript>Te photodiodes

The 1/f noise in photovoltaic (PV) molecular-beam epitaxy (MBE)-grown Hg_1−xCd_xTe double-layer planar heterostructure (DLPH) large-area detectors is a critical noise component with the potential to limit sensitivity of the cross-track infrared sounder (CrIS) instrument. Therefore, an understanding of the origins and mechanisms of noise currents in these PV detectors is of great importance. Excess low-frequency noise has been measured on a number of 1000-μm-diameter active-area detectors of varying “quality” (i.e., having a wide range of I-V characteristics at 78 K). The 1/f noise was measured as a function of cut-off wavelength under illuminated conditions. For short-wave infrared (SWIR) detectors at 98 K, minimal 1/f noise was measured when the total current was dominated by diffusion with white noise spectral density in the mid-10⁻¹⁵A/Hz^1/2 range. For SWIR detectors dominated by other than diffusion current, the ratio, α, of the noise current in unit bandwidth i_n(f = 1 Hz, V_d = −60 mV, and Δf = 1 Hz) to dark current I_d(V_d = −60 mV) was α_SW-d = i_n/I_d ∼ 1 × 10⁻³. The SWIR detectors measured at 0 mV under illuminated conditions had median α_SW-P = i_n/I_ph ∼ 7 × 10⁻⁶. For mid-wave infrared (MWIR) detectors, α_MW-d = i_n/I_d ∼ 2 × 10⁻⁴, due to tunneling current contributions to the 1/f noise. Measurements on forty-nine 1000-μm-diameter MWIR detectors under illuminated conditions at 98 K and −60 mV bias resulted in α_MW-P = i_n/I_ph = 4.16 ± 1.69 × 10⁻⁶. A significant point to note is that the photo-induced noise spectra are nearly identical at 0 mV and 100 mV reverse bias, with a noise-current-to-photocurrent ratio, α_MW-P, in the mid 10⁻⁶ range. For long-wave infrared (LWIR) detectors measured at 78 K, the ratio, α_LW-d = i_n/I_d ∼ 6 × 10⁻⁶, for the best performers. The majority of the LWIR detectors exhibited α_LW-d on the order of 2 × 10⁻⁵. The photo-induced 1/f noise had α_LW-P = i_n/I_ph ∼ 5 × 10⁻⁶. The value of the noise-current-to-dark-current ratio, α appears to increase with increasing bandgap. It is not clear if this is due to different current mechanisms impacting 1/f noise performance. Measurements on detectors of different bandgaps are needed at temperatures where diffusion current is the dominant current. Excess low-frequency noise measurements made as a function of detector reverse bias indicate 1/f noise may result primarily from the dominant current mechanism at each particular bias. The 1/f noise was not a direct function of the applied bias.     

Cu-Mg/Al_2O_3催化乙醇和乙二胺合成N-乙基乙二胺

在固定床反应器内,乙醇和乙二胺经分子间催化胺化反应合成了N-乙基乙二胺(NEED),考察了一系列铜系催化剂的活性,并筛选出催化性能较好的Cu-Mg/A l2O3催化剂;通过X射线衍射和透射扫描电子显微镜方法表征了助剂Mg对Cu/A l2O3催化剂的改性作用;考察了助催化剂Mg含量、反应温度、反应压力、进料量和乙二胺含量等对Cu-Mg/A l2O3催化剂性能的影响。实验结果表明,Cu-Mg/A l2O3催化剂具有很好的活性和选择性;在200℃、3.0MPa、质量分数20%的乙二胺乙醇溶液、进料量1.0mL/m in的条件下,乙二胺的转化率为71.56%,产物NEED的选择性和收率分别为92.62%和69.86%;经过20 d的连续使用表明,Cu-Mg/A l2O3催化剂具有良好的稳定性。     

新场气田致密低渗透气藏重复压裂工艺技术

新场气田蓬莱镇组气藏由于储层致密、渗流条件差，单井自然产能低，所以多数气井必须进行压裂改造才能投产，但由于受储层致密和其它多种因素的影响，压裂增产有效期较短，针对这种情况，进行了气井重复压裂工艺技术的理论计算和现场应用研究，初步形成了一套包括储层评估、重复压裂潜力井优选、重复压裂造缝机理研究、优化重复压裂施工及配套工艺和压后评估的气井重复压裂技术。现场试验表明，对具有潜力的压裂失效气井采取重复压裂措施，能取得较好的增产效果。气井重复压裂技术的形成和推广，将有效提高川西地区各气藏的开发水平，同时也为类似致密碎屑岩气藏的开发提供有益的指导和借鉴。     

Synchronous Full-Scan for Asynchronous Handshake Circuits

Handshake circuits form a special class of asynchronous circuits that has enabled the industrial exploitation of the asynchronous potential such as low power, low electromagnetic emission, and increased cryptographic security. In this paper we present a test solution for handshake circuits that brings synchronous test-quality to asynchronous circuits. We add a synchronous mode of operation to handshake circuits that allows full controllability and observability during test. This technique is demonstrated on some industrial examples and gives over 99% stuck-at fault coverage, using test-pattern generators developed for synchronous circuits. The paper describes how such a full-scan mode can be achieved, including an approach to minimize the number of dummy latches in case latches are used in the data path of the handshake circuit.     

抗乙肝病毒表面抗原PreS1(20-47)的单链抗体在转基因烟草根分泌物中的初步表达

为探索利用植物根分泌表达重组蛋白的可行性，构建了含有抗乙肝病毒表面抗原PreS1(20—47)单链抗体(ScFv)基因的表达载体。该ScFv基因转化烟草后在烟草根部细胞的细胞质和内质网中获得表达。实验结果表明，5’端融合ER导向信号肽的重组ScFv可通过根分泌表达。     

蓬莱19-3 FPSO和渤中25-1 FPSO设计的一些特点研究

通过多年在蓬莱19-3油田FPSO和渤中25-1油田FPSO设备维护和管理的经历,从船体、上部模块、单点系泊等方面,对这两艘FPSO上的一些系统和设备在设计方面各自的特点进行对比和分析     

BaxSr（1—x）TiO3多层膜椭偏光谱研究

用溶胶－凝胶技术在Bi(100）衬底上制备了单层和渐变型多层的BaxSr(1-X)TiO3薄膜，其膜层组分分别为：Ba0.7Sr0.3TiO3,Ba0.8Sr0.2TiO,Ba0.9Sr0.1TiO3,BaTiO3，对生长制备出的多层BaxSr(1-X)TiO3薄膜进行了变角度椭偏光谱测量，通过椭偏光谱解谱分析研究，首次得到了BaxSr(1-X)TiO3多层膜结构不同膜层的膜厚和光学常数，其结果显示：椭偏光谱分析得到的不同膜层的膜厚与卢瑟福背向散射测量得到的结果基本相符；渐变型多层膜中BaTiO3薄膜的折射率比单层BaTiO3薄膜折射率大许多，与体BaTiO3的折射率相接近，这说明渐变型多层膜中BaTiO3薄膜的光学性质与体材料的光学性质接近。