可动凝胶深部调驱候选井筛选方法研究

根据可动凝胶深部调驱机理,结合注水井和对应油井的静、动态特征,筛选出了用于确定最佳调驱井的指标体系,并采用变权的模糊综合评判方法进行多因素定量评价。结果表明,用渗透率非均质性、吸水剖面非均质性、吸水强度、井口压降曲线、含水-采出程度对应关系、油水井连通程度、油层未动用程度及沉积相特征等指标来筛选调驱注入井可提高选井的可靠性,保证可动凝胶深部调驱的效果。     

复合多功能通风管道的性能及在空调系统中的应用

详细介绍了复合多功能通风管道的各种性能,并与薄钢板通风管道作了比较,指出了其在空调系系统中的推广应用具有广阔的发展前景。     

二元复合驱阶段见效特征

针对孤东油田油藏条件，通过室内试验研究，确定了以胜利石油磺酸盐为活性剂主剂和聚合物的二元复合驱油体系，通过两者之间的协同效应，增加水驱波及体积和洗油效率。该体系在孤东油田七区西馆上54—61层进行试验，取得了较好的阶段性降水增油效果。本文分析了复合驱见效特征和影响见效因素，为下步跟踪分析调整具有指导意义。     

浅谈现浇框架柱施工中部分质量问题的防治措施

通过对现浇框架施工中柱位移错台、柱子主筋偏移、楼板超厚及保护层不足等质量问题进行综合分析，阐述了此问题出现的根本原因，并提出了防范措施。     

制粉系统的经济运行

分析了广州发电厂员村热电厂制粉系统电耗偏高的原因，通过对制粉系统的一系列改进，使得制粉电耗由原来的27～30kwh／t降低至22～24kwh／t。降低了制粉电耗，提高了制粉系统运行的经济性。     

起落架落震试验飞机机轮三向冲击位移的动态测量

为了研究飞机起落架受冲击载荷时的功量吸收状况，须在起落架落震试验中，对飞机着陆瞬间起落架机轮在空间三个方向上冲击位移的动态变化量进行测量。为此，本文设计了四自由度空间定位装置，并使其与计算机连接，实现了落震试验过程中，起落架在高速冲击状态下机轮三向位移的有效测量与记录。     

改善PZT微位移器线性的一种方法

根据锆钛酸铅压电陶瓷的逆压电效应。设计了以８０３１单片机为核心的压电陶瓷堆微位移器提高了ＰＺＴ的线性，从而满足了在天文自适应系统中所要求的精确微位的应用。     

Design and Characterization of the CLIMPAQ,Chamber for Laboratory Investigations of Materials,Pollution and Air Quality*

A test chamber has been developed in order to provide a small and simple emission testing facility capable of testing construction products in a climate where the important climatic parameters such as temperature, ventilation rate and air velocity can be varied independently around typical indoor values. The test chamber CLIMPAQ is made of panes of window glass. Other main surface materials are stainless steel and eloxated aluminium. The chamber has a volume of 50.9 litres and is designed to meet the requirements for quantifying air pollution. In this investigation human subjects acted as air pollution judges, and chemical characterization of the air pollution was carried out. Carpet, linoleum, wall paint and seal- ant were tested simultaneously in the CLIMPAQ and in four other chambers ranging from a full-scale chamber of 28 m³ to a field and laboratory emission cell of 3.5· 10^?5m³. Product ranking is the same in all chambers for the sensory measurements. Emission rates based on sensory measurements differ for all products less than 100 % except for tests in a 3-litre chamber where emission rates were higher. Chemical measurements differ up to approximately 10 times for the same product in different chambers. Deviations appear to be the result of different environmental parameters in the various chambers. Low air concentrations or high specific ventilation rates seem to increase emissions, while differences in air velocities and sink properties may also be the cause of differences in emission rates.     

Personal Exposure in Displacement Ventilated Rooms

Personal exposure in a displacement ventilated room is examined. The stratified flow and the considerable concentration gradients necessitate an improvement of the widely used fully mixing compartmental approach. The exposure of a seated and a standing person in proportion to the stratification height is examined by means of full-scale measurements. A breathing thermal manikin is used to simulate a person. It is found that the flow in the boundary layer around a person is able to a great extent to entrain and transport air from below the breathing zone. In the case of non-passive, heated contaminant sources, this entrainment improves the indoor air quality. Measurements of exposure due to a passive contaminant source show a significant dependence on the flow field as well as on the contaminant source location. Poor system performance is found in the case of a passive contaminant released in the lower part of the room close to the occupant. A personal exposure model for displacement ventilated rooms is proposed. The model takes the influence of gradients and the human thermal boundary layer into account. Two new quantities describing the interaction between a person and the ventilation are defined.     

测量刚体位移的非接触式光电系统

首次提出用标定法测量刚体的线位移和角位移的方法，该方法具有结构简单，性能可靠，非接触性，集成化高，工业上易实现和价格便宜等优点。本文同时还采用了一个小功率激光器为光源，ＣＣＤ为光电转换器件。最后通过相关分析法和数据拟合技术等图象处理技术，提高了整套系统的分辨率。