高Q Ba(Zn_(1/3)Ta_(2/3))O_3介质谐振器材料及其在毫米波系统中的应用

叙述了Ｂａ（Ｚｎ１／３Ｔａ２／３）Ｏ３介质谐振器材料的制备、结构、微波性能及典型应用。Ｂａ（Ｚｎ１／３Ｔａ２／３）Ｏ３介质材料介电常数εｒ为２９．５，频率温度系数τ≈０（－５５～＋８５℃），１０ＧＨｚ下最大无载Ｑ值１４７００，在２８ＧＨｚ测得Ｑ值约为４８００。这种材料具有高Ｑ值，特别适用于Ｘ以上波段作为振荡器电路中频率稳定元件。用这种介质谐振器已研制出８ｍｍ介质稳频微带耿氏振荡器，频率稳定度小于１０×１０－６／℃，最大输出功率达１８０ｍＷ。     

Existence of discrete-time LQG-controllers

Existence results for the LQG-controller are investigated. An infimal Riccati equation based controller may potentially give closed loop eigenvalues on the unit circle. Assuming left and right invertibility it is shown that there exists an optimal controller if and only if the Riccati equation based controller stabilizes the closed loop system after removal of all its unobservable and uncontrollable modes. Furthermore this reduced controller is the optimal controller, and its transfer function is unique. This existence condition is a considerable simplification of the more general geometric condition recently derived by Trentelman and Stoorvogel.     

知识库系统中的一种并发控制方法

本文给出了一个基于ＤＡＴＡＬＯＧ环境的知识库并发控制算法，算法的基础是两段锁（ＴＷＯＰＨＡＳＥＬＯＣＫＩＮＧ），它使用了相关和覆盖的概念，减少了被锁对象的数目，从而提高了系统的效率．最后给出了算法的正确性证明．     

X荧光光谱法测定不锈钢的研究

本文论述了Ｘ荧光光谱测定高铬钢和不锈钢的分析方法，用理论α系数校正基体效应和用谱线干扰系数Ｌ校正谱线重叠影响。方法准确度和精度令人满意，操作十分简便、快速。     

（Y－ZrO_2）－SiCw－Al_2O_3陶瓷复合材料的摩擦磨损

本文对Ａｌ２Ｏ３基陶瓷复合材料Ａｌ２Ｏ３－ＺｒＯ２－ＳｉＣｗ进行了干摩擦磨损试验，并运用了ＳＥＭ，ＴＥＭ和ＸＲＤ等手段对其显微结构、力学性能及它们与ＧＣｒ１５钢对摩时的摩擦磨损行为进行了系统分析，在此基础上深入探讨了ＳｉＣ晶须（ＳｉＣｗ）增韧补强作用对复合材料的摩擦磨损性能的影响。     

Oxidation of methane in a wide range of pressures and effect of inert gases

The analysis of methane oxidation in a wide range of pressures (0.05–10 atm) demonstrates that the efficiency of CH₃ radicals recombination is of great importance for high selectivity of C₂ hydrocarbons formation. The relative efficiency of different “colliders” assisting the stabilization of exited C₂H*₆ molecules increases in the series: solid surface> Ar> He. The increase of the overall reaction rate upon increasing pressure of the inert gases in the case of catalysts having a higher surface area and more developed pore structure is likely due to the contribution of the surface-induced chain reaction in the volume of pores.     

Synthesis of polyurethane elastomers hypercross-linked by partially hydrated polyhydroxylated C60

Utilization of polyhydroxylated C₆₀ (fullerenols) in a condensation reaction with diisocyanated oligo(tetramethylene oxide) led to the successful fabrication of elastomeric poly (urethane-ether) networks. These polymer networks exhibit interesting thermal behavior at low temperatures, improved tensile strength and elongation at ambient temperatures, and enhanced thermal mechanical stability at high temperatures, as compared with those of the parent linear polyurethane analogues; or with the conventional oligo (tetramethylene oxide)-derived polyurethane elastomers cross-linked by trihydroxylated reagents (1,I,1-trismethylol propane) or tetrahydroxylated reagents (pentaerythritol). The presence of a limited quantity of water molecules in the condensation reaction of fullerenols with diisocyanated prepolymers modified the physical properties of the resulting elastomeric products with a notable increase in tensile strength, modulus, and Ts over those of elasotmers prepared under anhydrous conditions. These water molecules contributed effectively to the increase of the number of cross-linking centers during the reaction.     

Al2O3—TiB2陶瓷刀具材料的高温氧化及其对刀具耐磨性能的影响

研究了Ａｌ２Ｏ３－ＴｉＢ２陶瓷刀具材料在１０００℃下的氧化行为，用ＸＲＤ、ＳＥＭ分析了氧化后的相组成及显微结构。结果表明：Ａｌ２Ｏ３－ＴｉＢ２陶瓷材料在１０００℃空气中氧化增重符合抛物线规律；随ＴｉＢ２含量的增加，该材料的抗氧化能力下降。     

大面积硅锂漂移探测器制备及其性能

制备了大面积硅锂漂移探测器,其性能为:探测器的灵敏面积123.6 cm~2;灵敏层深度2 mm;在室温和300 V反向偏压的工作条件下漏电流小于20 μA;对~(241)Am 5.486 MeV α粒子的能量分辨(FWHM)为77.67 keV。     

Influence of the surface conditions on permeation in the deuterium–MANET system

The condition of the surfaces is of crucial importance for the deuterium permeation through materials. In this work a study of the surface constants for the adsorption (σk₁) and release (σk₂) of deuterium under different surface conditions on the martensitic steel DIN 1.4914 (MANET) has been carried out. The growth of an oxide surface layer (Cr₂O₃) of about 25–30 nm in a MANET sample, heat treated in an oxidizing environment, compared to the bare MANET that have a ‘natural' oxide of about 5 nm has provoked a reduction of both the permeation rate and the recombination coefficient (about 3 orders of magnitude). In addition, the permeation governing process has changed from diffusion-limited to surface-limited. The measurements of the permeation rate of deuterium were performed by a gas-phase permeation technique over the temperature range 574–746 K and for deuterium driving pressures in the range from 3 to 10⁵ Pa.