Seismic Ground Motion Expected for the Eastern District of Naples

The seismic ground motion of a test area in the eastern district of Naples is computed with a hybrid technique based on the mode summation and the finite difference methods. This technique allows us the realistic modelling of source and propagation effects, including local soil conditions. In the modelling, we consider the 1980 Irpinia earthquake, a good example of strong shaking for the area of Naples, which is located about 90 km from the epicenter.The detailed geological setting is reconstructed from a large number of drillings. The sub-soil is mainly formed by alluvial (ash, stratified sand and peat) and pyroclastic materials overlying a pyroclastic rock (yellow neapolitan tuff), representing the neapolitan bedrock. The detailed information available on mechanical properties of the sub-soil and its geometry warrants the application of the sophisticated hybrid technique.As expected, the sedimentary cover causes an increase of the signal's amplitudes and duration. If thin peat layers are present, the amplification effects are reduced, and the peak ground accelerations are similar to those observed for the bedrock model. This can be explained by the backscattering of wave energy at such layers, that tend to seismically decouple the upper from the lower part of the structure.For SH-waves, the influence of the variations of the S-wave velocities on the spectral amplification is studied, by considering locally measured velocities and values determined from near-by down-hole measurements. The comparison between the computed spectral amplifications confirms the key role of an accurate determination of the seismic velocities of the different layers.The comparison performed between a realistic 2-D seismic response and a standard 1-D response, based on the vertical propagation of waves in a plane layered structure, shows considerable difference, from which it is evident that serious caution must be taken in the modelling of expected ground motion at a specific site.     

Optimal weighting in the finite difference solution of the convection-dispersion equation

Oscillation and numerical dispersion limit the reliability of numerical solutions of the convection-dispersion equation when finite difference methods are used. To eliminate oscillation and reduce the numerical dispersion, an optimal upstream weighting with finite differences is proposed. The optimal values of upstream weighting coefficients numerically obtained are a function of the mesh Peclet number used. The accuracy of the proposed numerical method is tested against two classical problems for which analytical solutions exist. The comparison of the numerical results obtained with different numerical schemes and those obtained by the analytical solutions demonstrates the possibility of a real gain in precision using the proposed optimal weighting method. This gain in precision is verified by interpreting a tracer experiment performed in a laboratory column.     

VARIATION OF TOTAL OZONE IN LOWER LATITUDE AREA OF CHINA

By using the observational O3 data of Kunming and Hong Kong during the period of 1997 – 2001, the paper studies the distribution and variation of total ozone in low latitude region of China. The study shows that the characteristics of variation in Kunm…     

巴楚-伽师Ms6.8地震地磁异常特点分析

通过分析、比较1996--2003年喀什地震台站记录到的新疆伽师及附近地区发生的多次6级地震的地磁前兆异常特征，发现在这几组地震活动过程中喀什地震台的地磁表现出不同的异常特征，说明与地震破裂特征有更深层次的相关性，且地磁响应比异常和总强度差值异常在一定程度上反映了台站周围小范围的震源区介质电性结构的变化。巴楚-伽师6．8级地震前地磁异常特征并不十分突出，有别于1996—1998年伽师强震群震前地磁异常量较丰富的特点。     

兰州CAWS600-R自动站与人工观测资料对比分析

利用2002年11月到2003年2月兰州CAWS600-R型自动站与人工观测的温度、本站气压、水汽压、相对湿度、5～320cm地温等资料，分析了对比观测资料的差值。结果表明：对气温、本站气压、水汽压、相对湿度及320cm地温等要素观测误差较小，5～160cm地温的观测误差较大。自动观测仪器的系统性偏差、测量元件的精度及对气象要素变化响应的灵敏度、观测时间的差异和人为因素的影响是造成对比观测误差的原因。     

能量色散X射线荧光光谱法测定卤水中痕量溴铷砷

用模拟卤水建立了能量色散X射线荧光光谱法测定卤水中溴、铷、砷痕量元素含量的方法.实验表明,方法可以直接取样测定,适用于大批量样品的测试分析.方法的精密度RSD(n＝15)小于1%,加标回收率为86.8%～101.6%.卤水中溴、铷、砷的测定结果与比色法、原子吸收和原子荧光法结果相符.     

高倍稀释熔融制样X射线荧光光谱测定钨砂和铬铁矿中主含量

用X射线荧光光谱测定钨砂中WO3和铬铁矿中Cr2O3,通过高倍稀释熔融玻璃片制样法,采用高纯WO3或Cr2O3作单一标准样测量X射线荧光强度计数,然后同未知样品测量所得X射线荧光强度计数相比,即可计算出WO3和Cr2O3的测量值.方法用于钨砂矿和铬铁矿中WO3和Cr2O3的测定,结果与标准值相符.     

均匀色空间中绿色翡翠的色差

采用MPV-Ⅲ型显微光度计测定了32个翡翠样品的可见光吸收光谱，计算了部分样品的三刺激值。在此基础上引入色度学中均匀色空间及色差的概念，通过计算样品NBS值定量分析了不同翡翠样品间的绿色差异。结果表明，色差的定量计算可以反映样品间的真实颜色差别，并且不同于同色异谱指数，可作为绿色翡翠颜色鉴别中一种较为有效的定量方法。     

时域瞬变场电磁场有限差分法

模拟电磁场在地下介质中的传播规律是理解地下介质响应的重要手段，直接应用有限差分法在时间域对二维、三维瞬变场进行数值分析是一种有效方法。应用反映电磁场基本规律的麦克斯韦方程组，导出时域场量的齐次扩散方程，对所研究的空间区域作差分离散，源作为初始条件加入，采用合适的边界条件，利用差分方程进行计算，从而得到场量的数值结果，展现瞬变场在地下随时间扩散的全过程，对电磁场的瞬态响应有更加直观的了解。